Answer
Jul 11, 2023 - 02:20 PM
If the generate light is flashing and there is either a hot or cold error code on the screen, this indicates that the water temperature that the system is measuring is outside of its operational range (approximately 50-140F). This may occur during the winter or when a heater is in operation. Please remember that the water temperature in the plumbing is not the same was the body of water in the pool.
If however the actual water temperature is not the same as what as being measured be the unit, this may mean that damage has occurred to its temperature sensor. A replacement part may be required in this case (item and instructions linked below).
For additional technical or warranty support you can reach us at 888-206-9938
https://www.circupool.com/CircuPool%C...
https://www.circupool.com/assets/doc/...
If however the actual water temperature is not the same as what as being measured be the unit, this may mean that damage has occurred to its temperature sensor. A replacement part may be required in this case (item and instructions linked below).
For additional technical or warranty support you can reach us at 888-206-9938
https://www.circupool.com/CircuPool%C...
https://www.circupool.com/assets/doc/...
Add New Comment