Answer
Sep 09, 2024 - 08:49 AM
The two conditions are likely unrelated, but first you should remove your flow switch and verify that there is no debris caught up in the switch and that there is no obvious physical damage to the switch. If you are able to apply power to the CM without the pump operating, then power it on and hold the flow switch closed. If the pump must be running to power up the CM, then replace the flow switch with it twist-tied or rubber-banded into a closed position. In both cases, if the light stays on, call us weekdays at (888) 206-9938 between 9-4:30 Central about replacing the flow switch. If the light goes off, then the waterflow is inadequate and you will want to check and clean the skimmers and filter and also check the circulation system for any leaks.
Regarding your indicated salinity of 5300, start by getting two or more water tests from different sources for a consensus measure of your salinity and check via your System Status menu that you are set to the correct cell type. Call us if necessary.
Regarding your indicated salinity of 5300, start by getting two or more water tests from different sources for a consensus measure of your salinity and check via your System Status menu that you are set to the correct cell type. Call us if necessary.
Add New Comment