Stops generating after a few hours of running. Turn it off and on and back to normal. CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources RJ PLUS Series

Question

Stops generating after a few hours of running. Turn it off and on and back to normal. CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources RJ PLUS Series

Works great when I turn it on. After a few hours I check on the system and the power is still on but it is not generating and cycling through the menu shows 0 A cell amps and 0 PPM Salinity Now. Turning the system off and then back on and it wakes back up and starts producing and shows current (amps) going to cell and displays the pool salinity level. Let the system run a few hours and I'll come back and it's back to no producing, no amps to cell, and no salinity level (like it goes into a sleep mode). Is there an auto sleep after X amount of time I'm not seeing?

Status: Open May 23, 2024 - 02:46 PM

Do you have the same question? Follow this Question

1answer

Answer

May 23, 2024 - 02:46 PM

When a CircuPool RJ-PLUS Series Salt Chlorinator operates at anything less than full output, it accomplishes that by prorated operation at 100% and 0% to reproduce that partial output level. During the "rest periods," the unit will report 0 amps to the cell and an instantaneous salinity reading of 0000. If you are concerned about whether the system is producing chlorine, always turn the output up to "Power Max" and check the amps and salinity. If it shows correct operation in that mode, then you should be comfortable that it is performing correctly and then turn the system back to your chosen output level.

0

Comments (0) | New Comment