RJ PLUS Series Q&A

Question 1

Why does my display say "LOW TEMP" and not generating....says water temp is 46 degrees and my Jandy says its 78 deg View answer

Asked 9 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 2

Why is salt level reading not accurate? View answer

Asked 2 ´years ago | Support

Question 3

How do you replace the fuse? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 4

Is the flow switch required on a salt chlorinator system? View answer

Asked 2 ´years ago

Question 5

Is there a malfunction? View answer

Asked 1 ´year ago

Question 6

My generate light is flashing on my CircuPool RJ45+, what does that mean? View answer

Asked 2 ´years ago

Question 7

How should I store my salt chlorinator in the winter months? View answer

Asked 4 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 8

How do you claim a warranty on my CircuPool equipment? View answer

Asked 2 ´years ago

Question 9

Hello. I have an RJ-60+ which is rated at 300W, so presumably it only draws 1.36A at 220V. However, the manual also mentions the cell current ranging between 2.5 and 7.8 amps. I can also see the cell current displayed when I cycle through the menu options. For example, at 50%, it shows 5.7 amps. I'm assuming this cell current is different from the load on the circuit breaker. Can you confirm please? View answer

Asked 3 ´years ago

Question 10

Power button is not working View answer

Asked 15 ´days ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 11

noise View answer

Asked 9 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 12

My RJ-45 is showing negative amps View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 13

I love my salt chlorine generator but I use a lot of acid for the pH. Is this caused by it generating chlorine? View answer

Asked 1 ´year ago

Question 14

Does the RJ30+ need to be recalibrated..if so how? View answer

Asked 8 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 15

My unit's fan is buzzing for 20 seconds on startup. Should be on warranty for part. View answer

Asked 8 ´months ago

Question 16

"Cell Connection" frozen on the screen. What can I do? View answer

Asked 9 ´months ago

Question 17

Is it product partial to leave the unit powered 24-7 ? I recently purchased a variable speed pump which leaves the unit on displaying various lights…I realize the flow switch controls the Cell but I dont want to unnecessarily damage the unit by leaving it powered 24-7 View answer

Asked 3 ´years ago

Question 18

Do you make an extension cable for the rj 45 cell? View answer

Asked 2 ´years ago

Question 19

I have never seen a positive current reading from the menu. What's wrong? View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 20

High salt View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 21

How can I tell when my electrolytic cell is bad? View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 22

The power button does not respond. Can I fix it? View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 23

how to replace a rj-60 keypad? View answer

Asked 4 ´months ago

Question 24

I am experiencing a lack of chlorine being generated but cell parameters seem correct. Solution? View answer

Asked 7 ´months ago

Question 25

cell connection error displaying View answer

Asked 6 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 26

Where can I find the CircuPool serial number on my equipment?? View answer

Asked 1 ´year ago

Question 27

I just installed an RJ60+ in place of my Aquapure 1400. I was just wondering- on the unit, there is a “remote” indicator. What is this for? Are there ways to adjust the unit remotely, perhaps interfacing it with the Jandy system? Thanks. View answer

Asked 4 ´years ago

Question 28

My RJ45 control module shows cell volts 12.2 cell Amps 0.00A, power is set at MAX. Salinity shows Average:0000 View answer

Asked 6 ´months ago

Question 29

if set below 70% my generator stops generating. i shut off and turn on it starts generating then stops again View answer

Asked 6 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 30

Is there a cap to clean the cell View answer

Asked 12 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 31

Question about the Voltage View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 32

Will the generator be compatible with my infinity i40 salt cell View answer

Asked 2 ´years ago

Question 33

How do I clean the CircuPool RJ45+ salt cell? View answer

Asked 2 ´years ago | Support

Question 34

What do I do when the cell maintenance light is on my CircuPool RJ45+ salt chlorine generator? View answer

Asked 2 ´years ago

Question 35

Is there a way to set run time limit? View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 36

flow switch not working View answer

Asked 2 ´years ago

Question 37

I have a high water temp message on the display. What needs done to fix this? View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 38

We have a 60000 gal pool at our yacht club View answer

Asked 10 ´months ago

Question 39

Software View answer

Asked 6 ´months ago

Question 40

what is the length of it? How long of a span of tubing is needed to be cut out for install? View answer

Asked 4 ´years ago

Question 41

Why is my display reading High Temperature and not displaying salt reading View answer

Asked 9 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series

Question 42

My NO FLOW light started flashing, shut unit down & checked flow switch, restarted now is solid red View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 43

My salt cell is creating foam in my pool View answer

Asked 6 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 44

Do I use the setting +30 or -30 for the RJ plus 30? View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 45

Concerning your RJ-20 System, I am close to the beach and a very corrosive environment, what is the rating on your control box and how does it stand up in salty conditions? View answer

Asked 3 ´years ago

Question 46

My RJ PLUS control module is reading 0 amps; it's not generating chlorine. Possible fix? View answer

Asked 6 ´months ago | Support

Question 47

What is the return policy if the cell is not the fix and I need to buy another complete system? View answer

Asked 7 ´months ago

Question 48

what is the difference compared to the old RJ30 View answer

Asked 3 ´years ago

Question 49

Reported Temperature is high. View answer

Asked 8 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 50

Can i use rj-45 for a 10000 gallon pool. My neighbor sold his house before he got to instill it on his pool. View answer

Asked 2 ´years ago

RJ PLUS Series Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools