Answer
Aug 20, 2025 - 02:54 PM
You can order s Flow Switch here if you are out of warranty or call us if you are uncertain or know that you are covered. We can be reached at (888) 206-9938 Mon-Thu: 9-4:30 or Fri: 9-3PM Central.
However, if you have a No Flow warning, you can't assume that the switch is bad simply because you know the pump is moving water. I would check the little cable (looks like an old phone wire) that goes to the flow switch and make sure there are no kinks or breaks in the line. If that all looks good, you will need to test the flow switch. If you have the ability to turn off your pump and leave the chlorine generator on, then turn off the pump, remove the flow switch from the line and hold the toggle closed with your fingers. If your equipment comes on and off together, you will need to remove the flow switch from the line and tie it closed with a string or rubber band and then re-install it in order to test it. Sometimes a switch will stick in the No Flow position with debris preventing it from triggering. If If the flow switch is working, the no flow light should blink for around 60 seconds and then go out. If it does not, you will need a new flow switch. Remember that the flow switch has to be installed so that the water will push that toggle closed!
However, if you have a No Flow warning, you can't assume that the switch is bad simply because you know the pump is moving water. I would check the little cable (looks like an old phone wire) that goes to the flow switch and make sure there are no kinks or breaks in the line. If that all looks good, you will need to test the flow switch. If you have the ability to turn off your pump and leave the chlorine generator on, then turn off the pump, remove the flow switch from the line and hold the toggle closed with your fingers. If your equipment comes on and off together, you will need to remove the flow switch from the line and tie it closed with a string or rubber band and then re-install it in order to test it. Sometimes a switch will stick in the No Flow position with debris preventing it from triggering. If If the flow switch is working, the no flow light should blink for around 60 seconds and then go out. If it does not, you will need a new flow switch. Remember that the flow switch has to be installed so that the water will push that toggle closed!
Add New Comment