Packages Q&A

Question 1

I am looking for a unit to convert my pool to a saltwater pool. I noticed this system says that it is a "replacement" for current systems. What would I need to do to install this as a new system? View answer

Answer posted 2 years ago

Question 2

Hello, What is the minimum flow rate (GPM) for operation for the CircuPool Core series? I currently have a Jandy VSP pump that I run at 1200 rpms that generates 22 gpm. Would the Chlorinator work at this low flow rate? Thanks in advance for your assistance. Have a GREAT Day. Regards, Eric Brown View answer

Answer posted 2 years ago

Question 3

What are the dimensions of the RJ-45 cell and flow switch? I need to confirm if I have enough piping. Thank you View answer

Answer posted 2 years ago

Question 4

Tired of the sand. Looking to replace my sand filter with a two-stage process like this. I get the TJ-16 but not sure what the proper filter would be? CJ180? What is the replacement cost of the filter cartridge? View answer

Answer posted 2 years ago

Question 5

water pump qualifies for energy star tax credit View answer

Answer posted 2 years ago

Question 6

Is there a regular interval at which polarity is reversed? I run my pump 4 hours per day. When not running there will be no power to the control unit. I'm worried based on my past experience with Zodiac LM that with power being cut, the polarity will be reversed every 4 hours after power up which would be a problem (of course I can run it longer if needed). View answer

Answer posted 2 years ago

Question 7

How do I buy a replacement for the SJ 3500 Generator buy it's self?? View answer

Answer posted 2 years ago

Question 8

What is the wording for the limited warranty * ? View answer

Answer posted 2 years ago

Question 9

My old salt system lasted 19 years with the original cell, the system periodically reverse its polarity to self clean the cell. Does the CORE 35 do this? And if it doesn't why not? View answer

Answer posted 2 years ago

Question 10

Do you have a comparison chart for different models of salt chlorine generators? What is the difference between the RJ30 and Core35? View answer

Answer posted 2 years ago

Question 11

I have a 10,000 gallon pool and want to convert to salt. So many questions. It's been 3 years since I drained and replaced 1/2 the water in the pool due to a repair. Should I consider a water replacement prior to conversion ? Under what circumstances should I consider water replacement? Money not an option...which model should I buy? What size? When does increase size not benefit performance for salt conversion power, cell cleaning cycle time, and cell life? Installation should not be a consideration as all would fit my system. Thank you, Bill View answer

Answer posted 2 years ago

Question 12

What do I do when it says "salt cell low" View answer

Answer posted 2 years ago

Question 13

what size pipe is used for the inlet and outlet and is it PVC? View answer

Answer posted 2 years ago

Question 14

Why does the boost light flash on my edge pool generator? View answer

Answer posted 2 years ago

Question 15

What size unit would I need for 18,000 pool 16 x 32 8 ft deep end 4 ft shallow View answer

Answer posted 2 years ago

Question 16

I have an inground 11,500gal (estimate) pool. I have a 100 sq ft cartridge filter. All visible plumbing is 1-1/2" PVC. The current pump motor is 1 HP single speed. I would like to upgrade to a VS pump to run 8 hrs per day and turn the pool over 2x/day. I'm also considering the RJ-20PLUS SWCG. What size motor should I use - the 1.5, 2.0 or the 3.0HP??? Also, do you agree with the RJ-20 or should I go with the RJ-30? View answer

Answer posted 2 years ago

Question 17

How many pounds it has? View answer

Answer posted 2 years ago

Question 18

I purchased a Universal 55 to replace a Pentair Salt System and I was wondering if there is an adapter kit or if I will just have to modify the plumbing myself. Thank you for your time and I can't wait to see the new system in action! View answer

Answer posted 2 years ago

Question 19

Hello, I have a 6,000 gal in-ground pool in the Florida Keys. What is the best system and size for my pool. thank you. Jose View answer

Answer posted 2 years ago

Question 20

what should the salt level of the pool be? View answer

Answer posted 2 years ago

Question 21

Does the power turn off to the plates when pump is off and it says no flow View answer

Answer posted 2 years ago

Question 22

I am trying to decide between this rj30 and your core 35 could you give me some help I have 15000gl pool changing from tables to salt View answer

Answer posted 2 years ago

Question 23

How many amps does the circupool universal 25 draw? Running power out to pool and making sure that I run the correct amount. View answer

Answer posted 2 years ago

Question 24

Installed the RJ-30 just before summer hit here in the Houston area on a ~15K gallon pool. Just want to know if having to run it at around 85-90% power is normal for the hot summer days on this size of pool. View answer

Answer posted 2 years ago

Question 25

Does this work for above ground pool View answer

Answer posted 2 years ago

Question 26

How many amps will this pump pull? View answer

Answer posted 2 years ago

Question 27

What’s the average lifespan of the cell in the RJ30? View answer

Answer posted 2 years ago

Question 28

I am considering the purchase on your model RJ30. I am looking at the spects on Amazon, on the page for ordering it states 1.5 lb of salt made per day. but down on the compareable chart it states 3.1 lbs for the RJ30. which is it? View answer

Answer posted 2 years ago

Question 29

Do I need a flow sensor with the SJ system? How do you know the differences between SJ-20 and others? Is it size of pool? Location? View answer

Answer posted 2 years ago

Question 30

What is the RJ+ cell unit's maximum pressure (PSI) rating? View answer

Answer posted 2 years ago

Question 31

what type chlorinator with good warranty do you recommend for a freeform 10,000 gallon pool? You offer so many series. Thank you. View answer

Answer posted 2 years ago

Question 32

My chlorinator is saying there is no water flow, but the water is flowing just fine with no obstructions. The flow indicator switch moves freely. What can I do?? View answer

Answer posted 2 years ago

Question 33

The lifespan is referring to the cell, correct? How much is the replacement cell for this system? Why is the lifespan range so wide- I am hearing 3 to 7 years- what effects the life span? Thank you. View answer

Answer posted 2 years ago

Question 34

If I currently have a Hayward Aquarite, do I need the adapter or will the Core35 fit where my cell is now? View answer

Answer posted 2 years ago

Question 35

can the control panel be mounted remotely? where my pump currently sits, the top of the motor would not be very accessible to be able to program the pump View answer

Answer posted 2 years ago

Question 36

Can the core 55 be mounted in the vertical position? View answer

Answer posted 2 years ago

Question 37

How does direct sunlight for most of the day affect the control unit? View answer

Answer posted 2 years ago

Question 38

will this replace an pentair Iclor 30 View answer

Answer posted 2 years ago

Question 39

Is there any reason I cannot use a Universal55 in a 35K gallon pool? Thx View answer

Answer posted 2 years ago

Question 40

How soon can we get this product? View answer

Answer posted 2 years ago

Question 41

My pool is 35k gals does it hurt anything if I go with the bigger 55k unit? Thanks View answer

Answer posted 2 years ago

Question 42

When converting from a chlorine pool to this system, do I run the already chlorinated water through the system and add additional salt as needed? Thanks a lot for the assistance. View answer

Answer posted 2 years ago

Question 43

Is it OK to install the salt generator cell (SJ-20) and flow sensor on the discharge piping of my pool cartridge cannister? View answer

Answer posted 2 years ago

Question 44

I bought a house with a 26qft pool. I'm trying to learn to control the salt chlorinator (SJ series) for my pool. The water is murky now, with algae. All parameters are ok (I check regularly), except chlorine and free chlorine levels, which are at 0. How do I know that the cell actually works? Is there a documentation regarding the controller? the left bottom green light has been blinking. Also, how is this controller related to the pump? I have Hayward controller for the pump, and I'm clueless here too. Please help. View answer

Answer posted 2 years ago

Question 45

Is the warranty for 8 years even if I install it the owner and it’s large enough for 80 thousand litres pooland brand new unit and will I receive it and is in Canadian money this numbe thanks View answer

Answer posted 2 years ago

Question 46

Would this pump be a swap out for a Pentair 1.5 or would pipe modifications be needed? And can it be used with fresh water chlorine pools? View answer

Answer posted 2 years ago

Question 47

Installed in fall of 2020. Tuned on in spring of 2021. How do I clean it and what is best to use. ??? View answer

Answer posted 2 years ago

Question 48

I have a variable speed pump and I'm curious, what is the minimum water flow in GPM for the CORE series? View answer

Answer posted 2 years ago

Question 49

Hello, I'd like to connect a CORE35 onto 1.5 inch pvc pipe. Do I need the 1.5" reducer ? Just want to double check. Thanks, Dave View answer

Answer posted 2 years ago

Question 50

16x32 x 5what size system do I need View answer

Answer posted 2 years ago

Packages Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools