CircuPool® Classic Combo (Salt Chlorinator + Pump) Q&A

Question 1

Does this kit come with a flow switch and is this flow switch from the Hayward compatible with this one View answer

Asked 4 ´years ago

Question 2

Asked 6 ´years ago

Question 3

I have a 5 plus year old SI45 now. I have replaced the cell and now it is blowing the fuse on the main panel. I’m not sure what the cost is to replace the main board or if I should purchase this new unit. Thoughts? View answer

Asked 4 ´years ago

Question 4

Will the plumbing for the SJ20 classic fit with the new SJ series? View answer

Asked 4 ´years ago

Question 5

How easy are is the SJ 35 to clean and how often does it need clening. View answer

Asked 5 ´years ago

Question 6

Hi, Can I use this with my existing pool pump? Do you have it in stock? View answer

Asked 5 ´years ago

Question 7

What is the optimum Salt content for this unit. I think its referred to as Parts per million (PPM) Thank You View answer

Asked 5 ´years ago

Question 8

Will the Sj-20 work with an above ground round 20’ x 48” Intex pool? If it does, do you have an adapter kit? The fittings are 1.5 in. View answer

Asked 4 ´years ago

Question 9

Can you have too big of a chlorinator? View answer

Asked 4 ´years ago

Question 10

Is this a complete system? How easy is this to install? View answer

Asked 6 ´years ago

Question 11

Can this be used on an above ground pool? View answer

Asked 6 ´years ago

Question 12

Can i use rj-45 for a 10000 gallon pool. My neighbor sold his house before he got to instill it on his pool. View answer

Asked 4 ´years ago

Question 13

I have 1 -1/2" pipe 44gpm Hayward filter and Hayward pool heater. Will this work easily with these things?? View answer

Asked 4 ´years ago

Question 14

Can this chlorinator be added before the filter after the pump ?The existing pool system is very constrained where the water returns to the pool after the filter View answer

Asked 4 ´years ago

Question 15

need more infro on the system View answer

Asked 5 ´years ago

Question 16

How can I get a pdf of the manual View answer

Asked 5 ´years ago

Question 17

What is the power draw on the Edge system? View answer

Asked 4 ´years ago

Question 18

I purchased a SJ-20 (from Amazon, hasn't arrived yet) it was a panic buy, only nine left yada yada, no chlorine available locally. but I realize now that the unit will likely be undersized as my pool is 30000 gallons. they didn't indicate volume or capacity and I did not find you website until after i made the purchase. So am i wasting my time with this unit or do I have any recourse ( upgrade path? bigger cell etc.) any input would be appreciated. View answer

Asked 5 ´years ago

Question 19

Does the RJ45 refer to pool size (45,000 Ga's) or does the 45 represent the element output in grams per hour? View answer

Asked 6 ´years ago

Question 20

Is the SJ20 110 or 240 volt? View answer

Asked 4 ´years ago

Question 21

Installed the RJ-30 just before summer hit here in the Houston area on a ~15K gallon pool. Just want to know if having to run it at around 85-90% power is normal for the hot summer days on this size of pool. View answer

Asked 4 ´years ago

Question 22

I currently have an RG 30 but it doesn’t seem to be reading the salinity levels correctly. I’m wondering if I need to purchase a separate new cell. If so how much would it be?Many thanks Jeff View answer

Asked 4 ´years ago

Question 23

Will this handle a 72000 litre pool in a northern rn climate View answer

Asked 4 ´years ago

Question 24

Do you offer a military discount? View answer

Asked 4 ´years ago

Question 25

What is the length of the power cord? View answer

Asked 6 ´years ago

Question 26

What’s the average lifespan of the cell in the RJ30? View answer

Asked 4 ´years ago

Question 27

We will be replacing our old Zodiac LM23 chlorinator. We have a Hayward variable speed pump. I think the pool is a bit over 15000 gallons. Which system would be best for us? View answer

Asked 4 ´years ago

Question 28

I have a SJ-series system 4 years ago. works great. I just had a variable speed pool pump installed. It goes threw its own internal timers. does the SJ- series have a built in flow switch sensor built in. Worried about the unit coming on via the old pool timer without the new pump running? View answer

Asked 6 ´years ago

Question 29

what is the difference compared to the old RJ30 View answer

Asked 4 ´years ago

Question 30

Does it only work when pump running and does it have a chlorine level reading View answer

Asked 5 ´years ago

Question 31

Is it product partial to leave the unit powered 24-7 ? I recently purchased a variable speed pump which leaves the unit on displaying various lights…I realize the flow switch controls the Cell but I dont want to unnecessarily damage the unit by leaving it powered 24-7 View answer

Asked 5 ´years ago

Question 32

Does rj20 plus have a timer? View answer

Asked 5 ´years ago

Question 33

Just bought the sj35 and don’t see anywhere in the instructions how long the two risers have to be. How long should they be? View answer

Asked 5 ´years ago

Question 34

Is the flow through the cell directional? Does it matter which way I install it? View answer

Asked 5 ´years ago

Question 35

what is the length of it? How long of a span of tubing is needed to be cut out for install? View answer

Asked 6 ´years ago

Question 36

is there a verical hook-up kit available? View answer

Asked 7 ´years ago

Question 37

What would you recomand using your products in place of a Pentair #520555 IntelliChlor IC40 Salt Chlorine Generator Cell. View answer

Asked 4 ´years ago

Question 38

If hardwired to the pump, will the percentage of output stay the same when powered off and back on again? View answer

Asked 6 ´years ago

Question 39

How long will the cell last before it needs to be replaced? View answer

Asked 4 ´years ago

Question 40

What is the max amp draw of this unit? I am trying to decide if I should add it to my pump circuit or add a new circuit and if the latter than size the circuit. View answer

Asked 4 ´years ago

Question 41

Just received it, and so psyched to replace my 18 year old Aquarite, it looks great. Can I keep the old flow switch from that system that still works fine, or do I need to swap in the new one. Just looking for simplicity in the install. Thanks, View answer

Asked 5 ´years ago

Question 42

If I currently have a Hayward Aquarite, do I need the adapter or will the Core35 fit where my cell is now? View answer

Asked 4 ´years ago

Question 43

can I buy a remote for the UL40? View answer

Asked 4 ´years ago

Question 44

Bought until 5 months ago and not generating. Power doesn’t seem to be getting to cell but control box lights working and has power. Any ideas? View answer

Asked 4 ´years ago

Question 45

Hello, I'd like to connect a CORE35 onto 1.5 inch pvc pipe. Do I need the 1.5" reducer ? Just want to double check. Thanks, Dave View answer

Asked 4 ´years ago

Question 46

What is the warranty? I don’t see any info here. View answer

Asked 5 ´years ago

Question 47

I need replacement o- rings for this chlorinator. Do you sell then. and if so, how much are they? View answer

Asked 5 ´years ago

Question 48

Other than warranty, what are the differences between the Universal Series and the RJ Series? View answer

Asked 4 ´years ago

Question 49

Is this the complete system. All I need to convert to a salt system from chloriine? View answer

Asked 4 ´years ago

Question 50

Will the system say when it’s time to change the cell? View answer

Asked 6 ´years ago

CircuPool® Classic Combo (Salt Chlorinator + Pump) Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools