CircuPool® Classic Combo (Salt Chlorinator + Pump) Q&A

Question 1

Core35 warranty 8 year limited. What is covered? View answer

Asked 5 ´years ago

Question 2

Can Core35 be mounted horizontally instead of vertically? Do you have dimensions for the Core35? View answer

Asked 4 ´years ago

Question 3

Concerning your RJ-20 System, I am close to the beach and a very corrosive environment, what is the rating on your control box and how does it stand up in salty conditions? View answer

Asked 5 ´years ago

Question 4

"Roughly" how long is the power wire? If it's short, is it easy to wire in a new one? "Roughly" how many amps would one think the 35k unit draws? I'm deciding on hardwiring it to my pump timer or a separate GFI outlet that runs off the timer. View answer

Asked 4 ´years ago

Question 5

Does this kit come with a flow switch and is this flow switch from the Hayward compatible with this one View answer

Asked 4 ´years ago

Question 6

rj-30 generates 1.5 lbs / day... Question: What do you mean by "day"? How many hours in "day"? View answer

Asked 4 ´years ago

Question 7

Hello, I have a 6,000 gal in-ground pool in the Florida Keys. What is the best system and size for my pool. thank you. Jose View answer

Asked 4 ´years ago

Question 8

What is the length of the EDG40 chlorine generator cell, please? Just end-of-threads-to-end-of-threads... View answer

Asked 5 ´years ago

Question 9

My old salt system lasted 19 years with the original cell, the system periodically reverse its polarity to self clean the cell. Does the CORE 35 do this? And if it doesn't why not? View answer

Asked 4 ´years ago

Question 10

what type chlorinator with good warranty do you recommend for a freeform 10,000 gallon pool? You offer so many series. Thank you. View answer

Asked 4 ´years ago

Question 11

how long does the edge 15 need to be run to meet the advertised chlorine rate per day? View answer

Asked 5 ´years ago

Question 12

What are the dimensions of the electronics box? Does it have a door that has to be swung open? I am concerned about clearances. I now have a Hayward box. View answer

Asked 7 ´years ago

Question 13

What are the dimensions of the UL 40 and it's flow control unit. (LxW). I'm investigating an acceptable place to install in my existing cholorine system piping. I cannot find this info anywhere on your site. View answer

Asked 4 ´years ago

Question 14

What is the grams per hour output of the RJ45? View answer

Asked 6 ´years ago

Question 15

How can I tell what my salinity level is on the Core35 unit? View answer

Asked 5 ´years ago

Question 16

I am replacing a rj30. Is the control mounting bracket the same? View answer

Asked 5 ´years ago

Question 17

I see the flow switch is integrated into the replaceable cell. Can it be repaired without replacing the entire cell? It seems flow switches are the weakest link with Pentair. While I like this system, I'm a little apprehensive. View answer

Asked 5 ´years ago

Question 18

Can we get an adapter kit for a pentair ic 40 View answer

Asked 4 ´years ago

Question 19

What are the dimensions of the RJ-45 cell and flow switch? I need to confirm if I have enough piping. Thank you View answer

Asked 4 ´years ago

Question 20

I have a RJ-45 Plus Salt Generator. I don't know what the winter mode button actually does and what it's usefulness is. The owners manual really doesn't describe it's function or why it should or should not be used. View answer

Asked 5 ´years ago

Question 21

We just cleaned our cell and now we are having issues with it communicating to the system. There is a code saying Cell Connection. We have inspected the all of the cables and everything look to be in good shape. We have powered it down several times and disconnected it several times as well yet we can not get the cell to communicate with the system, W”hat could be the cause of this code? View answer

Asked 5 ´years ago

Question 22

Does the control module have to be covered or is it waterproof? View answer

Asked 5 ´years ago

Question 23

What are the dimensions of the Core55 unit? I need to make sure I have enough room to install with existing setup. View answer

Asked 5 ´years ago

Question 24

Can this be used as an initial conversion kit? Meaning I don't have a salt system can I install this product? Thanks View answer

Asked 5 ´years ago

Question 25

Can this replace a Jandy Aquapure 1400 with automation (Jandy AquaLink)? View answer

Asked 7 ´years ago

Question 26

My pool is 40,000 gallons. Will this work properly? How much salt will need to be added? View answers

Asked 5 ´years ago

Question 27

CircuPool product under serious consideration. Long time pool owner. 16x34 with diving end rectangular pool so I est. about 25,000 gals. DIY installation and controller can be in or out (exposed to all sun & elements). Can you suggest a good model for me? Thanks View answer

Asked 5 ´years ago

Question 28

The description says this can be installed horizontally or vertically but then the website shows a ventricle installation kit. Does this mean the unit as purchased cannot be installed vertically out of the box? View answer

Asked 5 ´years ago

Question 29

What is the minimum required flow (in GPM) for the RJ60+ Flow Switch to close and enable the Salt Cell to generate Chlorine? View answer

Asked 4 ´years ago

Question 30

Is the cell a direct replacement for the Pentair IC20? And, is the flowmeter integral it the cell? View answer

Asked 5 ´years ago

Question 31

Hello. I have an RJ-60+ which is rated at 300W, so presumably it only draws 1.36A at 220V. However, the manual also mentions the cell current ranging between 2.5 and 7.8 amps. I can also see the cell current displayed when I cycle through the menu options. For example, at 50%, it shows 5.7 amps. I'm assuming this cell current is different from the load on the circuit breaker. Can you confirm please? View answer

Asked 5 ´years ago

Question 32

Can you mount this vertical? View answer

Asked 4 ´years ago

Question 33

are the input and output connections 1 1/2 or 2'' View answer

Asked 5 ´years ago

Question 34

How do I shock my salt water pool that has a RJ60+ system. View answer

Asked 4 ´years ago

Question 35

What size PVC pipe does this fit? My plumbing is 1.5" View answer

Asked 5 ´years ago

Question 36

Will this be a direct replacement for the Si45? View answer

Asked 5 ´years ago

Question 37

Will the Sj-20 work with an above ground round 20’ x 48” Intex pool? If it does, do you have an adapter kit? The fittings are 1.5 in. View answer

Asked 4 ´years ago

Question 38

What is the optimum Salt content for this unit. I think its referred to as Parts per million (PPM) Thank You View answer

Asked 5 ´years ago

Question 39

Hi, Can I use this with my existing pool pump? Do you have it in stock? View answer

Asked 5 ´years ago

Question 40

The lifespan is referring to the cell, correct? How much is the replacement cell for this system? Why is the lifespan range so wide- I am hearing 3 to 7 years- what effects the life span? Thank you. View answer

Asked 4 ´years ago

Question 41

IS THIS A 110V UNIT ? View answer

Asked 6 ´years ago

Question 42

How easy are is the SJ 35 to clean and how often does it need clening. View answer

Asked 5 ´years ago

Question 43

Does the unit stop making chlorine when the water temperature drops? My cold water light is on and it doesn't seem to be making any chlorine. If it stop, what is the temperature range for it to work? View answer

Asked 4 ´years ago

Question 44

Will the plumbing for the SJ20 classic fit with the new SJ series? View answer

Asked 4 ´years ago

Question 45

I have a 5 plus year old SI45 now. I have replaced the cell and now it is blowing the fuse on the main panel. I’m not sure what the cost is to replace the main board or if I should purchase this new unit. Thoughts? View answer

Asked 4 ´years ago

Question 46

Where do you install the cartridge-looking device... On the intake line or the outflow (back to the pool) line? View answer

Asked 4 ´years ago

Question 47

My chlorinator is saying there is no water flow, but the water is flowing just fine with no obstructions. The flow indicator switch moves freely. What can I do?? View answer

Asked 4 ´years ago

Question 48

I currently have a zodiac lm2-24 salt chlorinator. Does the Circupool sj-40 mount on the same plumbing? (i.e., have the same dimensions for its fittings? )or will I have to re-engineer the existing pvc? View answer

Asked 6 ´years ago

Question 49

HI..MY SALT LEVEL PPM IS 5000. WILL YUR SYTEM STILL GENERATE CLHORILE AT THIS LEVEL? View answer

Asked 6 ´years ago

Question 50

Will this control panel work with a Hayward Salt Cell? View answer

Asked 4 ´years ago

CircuPool® Classic Combo (Salt Chlorinator + Pump) Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools