Packages Q&A

Question 1

How difficult is it to convert a chlorine tablet system to the Circupool SJ~20 system? Is the conversion similar to the one you use to convert from one salt system to the circupool product. Thanks View answer

Asked 4 ´years ago

Question 2

Hello, What is the minimum flow rate (GPM) for operation for the CircuPool Core series? I currently have a Jandy VSP pump that I run at 1200 rpms that generates 22 gpm. Would the Chlorinator work at this low flow rate? Thanks in advance for your assistance. Have a GREAT Day. Regards, Eric Brown View answer

Asked 3 ´years ago

Question 3

I see it is drop-in replacement for IntelliFlo and WhisperFlo, what about SuperFlo? I have a single-speed SuperFlo 340038. View answer

Asked 4 ´years ago

Question 4

we have a pentair intelliflo that just blew up on us could we replace with this? View answer

Asked 3 ´years ago

Question 5

Will this work with a 25000 gallon above ground pool? View answer

Asked 3 ´years ago

Question 6

I'm installing a 16x32 inground pool, approx 30,000 gallons. Instead of a chlorine pool, I'd like to make it salt water and looking at this unit. Will this suffice my pool size. No pump, filter are installed yet so now is the time for me to make this decision. View answer

Asked 4 ´years ago

Question 7

Is this system Hayward compatible? View answer

Asked 3 ´years ago

Question 8

I have an inground pool 13,500 gallon in southwest Florida what size SJ unit will i need ? View answer

Asked 5 ´years ago

Question 9

When switching from chlorine to salt, do you have to start with fresh pool water or just add salt? View answer

Asked 1 ´year ago

Question 10

My old salt system lasted 19 years with the original cell, the system periodically reverse its polarity to self clean the cell. Does the CORE 35 do this? And if it doesn't why not? View answer

Asked 3 ´years ago

Question 11

What is the wording for the limited warranty * ? View answer

Asked 3 ´years ago

Question 12

What would you recomand using your products in place of a Pentair #520555 IntelliChlor IC40 Salt Chlorine Generator Cell. View answer

Asked 3 ´years ago

Question 13

what is the length of it? How long of a span of tubing is needed to be cut out for install? View answer

Asked 5 ´years ago

Question 14

Is it product partial to leave the unit powered 24-7 ? I recently purchased a variable speed pump which leaves the unit on displaying various lights…I realize the flow switch controls the Cell but I dont want to unnecessarily damage the unit by leaving it powered 24-7 View answer

Asked 4 ´years ago

Question 15

I am going to be installing an 18,000 gallon above ground pool. Is the Circupool Universal40 the correct size for me and will it come with everything I need for a new install? View answer

Asked 4 ´years ago

Question 16

What are the dimensions of the UL 40 and it's flow control unit. (LxW). I'm investigating an acceptable place to install in my existing cholorine system piping. I cannot find this info anywhere on your site. View answer

Asked 4 ´years ago

Question 17

What are the dimensions of the steel cabinet? View answer

Asked 4 ´years ago

Question 18

I like the core55. I am currently a no salt pool and would like to switch with this system. However, my pool is 54,000 gallons. Can I install the core55 with any the core35 and meet my needs? View answer

Asked 5 ´years ago

Question 19

What is the max amp draw of this unit? I am trying to decide if I should add it to my pump circuit or add a new circuit and if the latter than size the circuit. View answer

Asked 3 ´years ago

Question 20

I own this system but it sometimes does not produce enough chlorine for my 240 00 gallon pool, guess to runtime being less than 24 hours. can i upgrade to RJ 60 salt cell without changing controller? will controller recognize larger cell and correctly produce chlorine? View answer

Asked 4 ´years ago

Question 21

I have an RJ-30 Plus system. What is the effect of Cell Version setting on the Menu? Each numerical value also has a '+' and '-'. What does this do to the operation of the system? This is not mentioned anywhere in the manual. View answer

Asked 4 ´years ago

Question 22

I have a RJ-45 Plus Salt Generator. I don't know what the winter mode button actually does and what it's usefulness is. The owners manual really doesn't describe it's function or why it should or should not be used. View answer

Asked 5 ´years ago

Question 23

Does it need to be connected to 120v or 240v? View answer

Asked 4 ´years ago

Question 24

What’s the average lifespan of the cell in the RJ30? View answer

Asked 3 ´years ago

Question 25

How often do you have to replace the salt cells? I see no mention of longevity View answer

Asked 4 ´years ago

Question 26

I am getting ready to install this unit but may have to install it vertically. What, if anything, do I need to do to insure the system works properly? Thanks, Marty View answer

Asked 4 ´years ago

Question 27

The Core-55 capacity is listed at 2.3 lbs/day. Is the "day" in this calculation 24 hours of runtime will produce 2.3 lbs or is the number of hours smaller? I realize the 2.3 lbs is an approximation...just curious about the required runtime to get the output. View answer

Asked 4 ´years ago

Question 28

I have a 25000 gal. Gunite pool and live in Maryland. Would you recommend the 40 or 65 model for maximum efficiency. Also can the control panel be mounted outside and is it waterproof View answer

Asked 4 ´years ago

Question 29

Will the system say when it’s time to change the cell? View answer

Asked 5 ´years ago

Question 30

Does this work for above ground pool View answer

Asked 3 ´years ago

Question 31

I am trying to decide between this rj30 and your core 35 could you give me some help I have 15000gl pool changing from tables to salt View answer

Asked 3 ´years ago

Question 32

Will this be a direct replacement for the Si45? View answer

Asked 5 ´years ago

Question 33

DOES THE NO FLOW LIGHT STAY ON WHEN THE PUMP IS OFF? IF SO, HOW LONG? WILL I HAVE TO MANUALLY TURN IT OFF EVERY DAY? View answer

Asked 5 ´years ago

Question 34

Will this system work on an above ground pool? View answer

Asked 4 ´years ago

Question 35

Does the RJ45 refer to pool size (45,000 Ga's) or does the 45 represent the element output in grams per hour? View answer

Asked 5 ´years ago

Question 36

Will the universal 40 cell fit the t-15 directly. View answer

Asked 3 ´years ago

Question 37

What is the recommended GPM flow for the RJ45 system, Core35, and Core55 systems? View answer

Asked 5 ´years ago

Question 38

Does the control module have to be covered or is it waterproof? View answer

Asked 4 ´years ago

Question 39

I have above ground pool 33 foot by 54 inch deep is this the best unit View answer

Asked 4 ´years ago

Question 40

I need replacement o- rings for this chlorinator. Do you sell then. and if so, how much are they? View answer

Asked 4 ´years ago

Question 41

What size do I go with? My pool is 18 by 36 inground with a 4 foot shallow end and 9 feet in deep end which is gradual. Why would I choose one system over another?? What are your recommendations? I do not currently have a salt system View answer

Asked 3 ´years ago

Question 42

Can I use this unit with a variable speed (vs) pump? If so what rpm and duration settings should I use? View answers

Asked 4 ´years ago

Question 43

Hi, Can I use this with my existing pool pump? Do you have it in stock? View answer

Asked 4 ´years ago

Question 44

I purchased a SJ-20 (from Amazon, hasn't arrived yet) it was a panic buy, only nine left yada yada, no chlorine available locally. but I realize now that the unit will likely be undersized as my pool is 30000 gallons. they didn't indicate volume or capacity and I did not find you website until after i made the purchase. So am i wasting my time with this unit or do I have any recourse ( upgrade path? bigger cell etc.) any input would be appreciated. View answer

Asked 4 ´years ago

Question 45

My chlorinator is saying there is no water flow, but the water is flowing just fine with no obstructions. The flow indicator switch moves freely. What can I do?? View answer

Asked 3 ´years ago

Question 46

I currently have a Jandy AquaPure PLC1400 that went bad. Can this replace that without professional? Thanks much. Duane View answer

Asked 4 ´years ago

Question 47

Just received it, and so psyched to replace my 18 year old Aquarite, it looks great. Can I keep the old flow switch from that system that still works fine, or do I need to swap in the new one. Just looking for simplicity in the install. Thanks, View answer

Asked 5 ´years ago

Question 48

What are the dimensions of the RJ-45 cell and flow switch? I need to confirm if I have enough piping. Thank you View answer

Asked 3 ´years ago

Question 49

Can you have too big of a chlorinator? View answer

Asked 3 ´years ago

Question 50

Is this compatible with iAquaLink 3.0 so I can view my readings remotely? View answer

Asked 4 ´years ago

Packages Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools