CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Question 1

Can your pumps and filters work just as well with chlorinated pool? View answer

Asked 21 ´days ago

Question 2

When switching from chlorine to salt, do you have to start with fresh pool water or just add salt? View answer

Asked 21 ´days ago

Question 3

Do you have package pricing for just the pre filter, cartridge filter, and the 3hp pump? View answer

Asked 27 ´days ago

Question 4

Hi, I'm a return customer. Well, I think it's time to replace the old system with a new one. My question is... I see a round "white" fitting with wires attached in your photos. What is that? I don't have anything like that on my current system (RJ20 serial # 030282). Also, will the chlorinator fit the same fittings as my old system? Thank You! View answer

Question updated 1 month ago

Question 5

I have a variable speed pump. The question is, when I am at the low speed I suspect the flow will not be enough for the flow switch to read so it will not produce salt. Is this correct? Will this harm the system?If I purchase this my plan is to set the pump speeds to get the chlorine level I need. Pool is 15000 gallons View answer

Question updated 1 month ago

Question 6

I just purchased RJ60+ System. Is there a maximum flow limit that I shall not exceed for the Salt Cell.? Maximum flow, for example 85 GPM, for their Salt Cell. View answer

Question updated 1 month ago

Question 7

can I buy a remote for the UL40? View answer

Question updated 1 month ago

Question 8

Is it a bad thing to go bigger with the pump and generator? View answer

Asked 1 ´month ago

Question 9

Can this be hard wired in place of my hayward salt generator with a 240v connection? View answer

Question updated 1 year ago

Question 10

Will this work with my existing T-15 cell? View answer

Answer updated 1 year ago

Question 11

Is there a separate priming speed/time setting on the pump or do you have to sacrifice SPEED 1 to use for pump priming? The manual is not very clear on this. View answers

Answer posted 1 year ago

Question 12

This says it can produce up to 1.4 lbs of chlorine per day. Would this be assuming it is running at 100% output for 24 hours? Just trying to figure out my run time and output settings. Last year I was using about a 1/2 pound to 3/4 pound of chlorine per day before I installed this salt cell View answer

Answer updated 1 year ago

Question 13

will this system do a 30,000 gallon pool? im trying to convert from fresh water to salt water with this system. View answer

Asked 2 ´years ago

Question 14

Can I use this unit with a variable speed (vs) pump? If so what rpm and duration settings should I use? View answers

Answer posted 2 years ago

Question 15

How long will the cell last before it needs to be replaced? View answer

Answer posted 2 years ago

Question 16

What would you recomand using your products in place of a Pentair #520555 IntelliChlor IC40 Salt Chlorine Generator Cell. View answer

Answer posted 2 years ago

Question 17

How to wire this pump with CircuPool RJ-30 PLUS Salt Chlorine Generator to be able to use the pump timer ? View answer

Answer posted 2 years ago

Question 18

I would like to confirm that the Core55 can be connected to an Pentair EasyTouch and IntelliTouch Pool and Spa System as I believe it can. Will the unit work? View answer

Answer posted 2 years ago

Question 19

I currently have an RG 30 but it doesn’t seem to be reading the salinity levels correctly. I’m wondering if I need to purchase a separate new cell. If so how much would it be?Many thanks Jeff View answer

Answer posted 2 years ago

Question 20

How do I shock my salt water pool that has a RJ60+ system. View answer

Answer posted 2 years ago

Question 21

why does the housing leak? I replaced gasket and it leaks around the threads View answer

Answer posted 2 years ago

Question 22

Overall length of salt cell. Also, is it 2 inch tuping in and out, or does it have recucing bushings to change larger size to 2 inch? What's the approximate weight of the salt cell? View answer

Answer posted 2 years ago

Question 23

When do you think this product will be available again? I am converting a 9 person hot tub to saltwater. Would the edge25 be too large for hot tub? View answer

Answer posted 2 years ago

Question 24

Can this chlorinator be added before the filter after the pump ?The existing pool system is very constrained where the water returns to the pool after the filter View answer

Answer posted 2 years ago

Question 25

Is there a replacement for the cell when it finally dies, or do you have to buy the entire system? I am not seeing one on the site. View answer

Answer posted 2 years ago

Question 26

Can I easily replace my jandy 1400 aquapure system with this circupool 40k unit? View answer

Answer posted 2 years ago

Question 27

when there is no electricity, will the device return to work after the power is restored? View answer

Answer posted 2 years ago

Question 28

Are replacement cells readiiy available and how much $ If the flow valve breaks, can it be replaced or is a new cell required. View answer

Answer posted 2 years ago

Question 29

We're thinking of replacing out Hayward with this system. Can we reply on the flow switch to turn the chlorinator on and off? The pump is always powered, but has an internal controller as well as variable speed. We can have reduced flow as well as no flow during parts of the day. Will this hurt your system? Thank you in advance. View answer

Answer posted 2 years ago

Question 30

Do you offer a military discount? View answer

Answer posted 2 years ago

Question 31

I just ordered an RJ-45+. Should I install a check valve after the heater? View answer

Answer posted 2 years ago

Question 32

What is the max amp draw of this unit? I am trying to decide if I should add it to my pump circuit or add a new circuit and if the latter than size the circuit. View answer

Answer posted 2 years ago

Question 33

Does the CircuPool Core 35 come with a sacrificial anode? View answer

Answer posted 2 years ago

Question 34

I have a timer on my pump. Does the generator need to be on a timer also or is it ok to just let the flow switch shut down the unit when the pump is off? View answer

Answer posted 2 years ago

Question 35

i HAVE A 25,000 GAL POOL WILL THE CORE35 BE SUFFICIENT? View answer

Answer posted 2 years ago

Question 36

Can we get an adapter kit for a pentair ic 40 View answer

Answer posted 2 years ago

Question 37

Will the universal 40 cell fit the t-15 directly. View answer

Answer posted 2 years ago

Question 38

Will this handle a 72000 litre pool in a northern rn climate View answer

Answer posted 2 years ago

Question 39

Can you have too big of a chlorinator? View answer

Answer posted 2 years ago

Question 40

Bought until 5 months ago and not generating. Power doesn’t seem to be getting to cell but control box lights working and has power. Any ideas? View answer

Answer posted 2 years ago

Question 41

I have a 15 x 32 18200 gallon pool. I have small children and occasionally have pool partya with 20+ people in the pool. I also live near trees that constantly release leaves on to the pool. Thousands in a day. Would this system be able to handle these conditions? View answer

Answer posted 2 years ago

Question 42

Will this work with a 25000 gallon above ground pool? View answer

Answer posted 2 years ago

Question 43

Where can I purchase the cell only for the 40 model ? View answer

Answer posted 2 years ago

Question 44

If you have the SJ20 and upgrade to the RJ30 plus, do all the replacement parts fit where the SJ20 parts were? For example the cell fittings? View answer

Answer posted 2 years ago

Question 45

I am looking for a unit to convert my pool to a saltwater pool. I noticed this system says that it is a "replacement" for current systems. What would I need to do to install this as a new system? View answer

Answer posted 2 years ago

Question 46

Hello, What is the minimum flow rate (GPM) for operation for the CircuPool Core series? I currently have a Jandy VSP pump that I run at 1200 rpms that generates 22 gpm. Would the Chlorinator work at this low flow rate? Thanks in advance for your assistance. Have a GREAT Day. Regards, Eric Brown View answer

Answer posted 2 years ago

Question 47

What are the dimensions of the RJ-45 cell and flow switch? I need to confirm if I have enough piping. Thank you View answer

Answer posted 2 years ago

Question 48

Is there a regular interval at which polarity is reversed? I run my pump 4 hours per day. When not running there will be no power to the control unit. I'm worried based on my past experience with Zodiac LM that with power being cut, the polarity will be reversed every 4 hours after power up which would be a problem (of course I can run it longer if needed). View answer

Answer posted 2 years ago

Question 49

How do I buy a replacement for the SJ 3500 Generator buy it's self?? View answer

Answer posted 2 years ago

Question 50

What is the wording for the limited warranty * ? View answer

Answer posted 2 years ago

CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools