CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Question 1

I have a variable speed pump. The question is, when I am at the low speed I suspect the flow will not be enough for the flow switch to read so it will not produce salt. Is this correct? Will this harm the system?If I purchase this my plan is to set the pump speeds to get the chlorine level I need. Pool is 15000 gallons View answer

Asked 3 ´years ago

Question 2

What is the recommended GPM flow for the RJ45 system, Core35, and Core55 systems? View answer

Asked 5 ´years ago

Question 3

When switching from chlorine to salt, do you have to start with fresh pool water or just add salt? View answer

Asked 10 ´months ago

Question 4

How to wire this pump with CircuPool RJ-30 PLUS Salt Chlorine Generator to be able to use the pump timer ? View answer

Asked 3 ´years ago

Question 5

I have a timer on my pump. Does the generator need to be on a timer also or is it ok to just let the flow switch shut down the unit when the pump is off? View answer

Asked 3 ´years ago

Question 6

Panel is blank View answer

Asked 4 ´years ago

Question 7

Where is CircuPool equipment made? View answer

Asked 6 ´years ago

Question 8

Can I use this unit with a variable speed (vs) pump? If so what rpm and duration settings should I use? View answers

Asked 4 ´years ago

Question 9

Our GRC/J1400-3 chlorine generator has failed. Looking for a direct replacement so the pipes don't need to be changed. Is this model applicable? Thanks View answer

Asked 5 ´years ago

Question 10

Does the unit stop making chlorine when the water temperature drops? My cold water light is on and it doesn't seem to be making any chlorine. If it stop, what is the temperature range for it to work? View answer

Asked 3 ´years ago

Question 11

when there is no electricity, will the device return to work after the power is restored? View answer

Asked 3 ´years ago

Question 12

Does this work for above ground pool View answer

Asked 3 ´years ago

Question 13

Can this replace my intellichlor ic60 or does it require replumbing? How soon can I get it? View answer

Asked 4 ´years ago

Question 14

What’s the average lifespan of the cell in the RJ30? View answer

Asked 3 ´years ago

Question 15

Can you use a timer to turn the rj30 on and off? View answer

Asked 4 ´years ago

Question 16

My pool Is 27,000 gals ... is it best to purchase core 55 salt chlorinator or would that be to big ..also will the metal components on the pool equipment suffer from the salt View answer

Asked 4 ´years ago

Question 17

Is there a separate priming speed/time setting on the pump or do you have to sacrifice SPEED 1 to use for pump priming? The manual is not very clear on this. View answers

Asked 5 ´years ago

Question 18

I see the flow switch is integrated into the replaceable cell. Can it be repaired without replacing the entire cell? It seems flow switches are the weakest link with Pentair. While I like this system, I'm a little apprehensive. View answer

Asked 4 ´years ago

Question 19

I have a below grade equipment room. I was going to install 2- SJ55 on a 50,000 gallon pool. I want the system to coast for longer cell life. What do I need to install the two units below ground? Would it be possible to get a drawing of what you would recommend? View answer

Asked 6 ´years ago

Question 20

The description says this can be installed horizontally or vertically but then the website shows a ventricle installation kit. Does this mean the unit as purchased cannot be installed vertically out of the box? View answer

Asked 4 ´years ago

Question 21

Can this be used as an initial conversion kit? Meaning I don't have a salt system can I install this product? Thanks View answer

Asked 4 ´years ago

Question 22

HI..MY SALT LEVEL PPM IS 5000. WILL YUR SYTEM STILL GENERATE CLHORILE AT THIS LEVEL? View answer

Asked 5 ´years ago

Question 23

Can Core35 be mounted horizontally instead of vertically? Do you have dimensions for the Core35? View answer

Asked 3 ´years ago

Question 24

what should the salt level of the pool be? View answer

Asked 3 ´years ago

Question 25

I'm installing a 16x32 inground pool, approx 30,000 gallons. Instead of a chlorine pool, I'd like to make it salt water and looking at this unit. Will this suffice my pool size. No pump, filter are installed yet so now is the time for me to make this decision. View answer

Asked 4 ´years ago

Question 26

I have a 13,000 gallon fiberglass pool. I was looking at your Core35, is this overkill? I would rather have it and not need it, than need it and not have it. View answer

Asked 4 ´years ago

Question 27

Hello, What is the minimum flow rate (GPM) for operation for the CircuPool Core series? I currently have a Jandy VSP pump that I run at 1200 rpms that generates 22 gpm. Would the Chlorinator work at this low flow rate? Thanks in advance for your assistance. Have a GREAT Day. Regards, Eric Brown View answer

Asked 3 ´years ago

Question 28

How does direct sunlight for most of the day affect the control unit? View answer

Asked 3 ´years ago

Question 29

How often does the electrolytic cell need to be replaced? View answer

Asked 3 ´years ago

Question 30

Only number two polarity comes on View answer

Asked 5 ´years ago

Question 31

Need to get a manual. I own this device already View answer

Asked 5 ´years ago

Question 32

When will SJ-20 system be available? View answer

Asked 4 ´years ago

Question 33

I purchased a Universal 55 to replace a Pentair Salt System and I was wondering if there is an adapter kit or if I will just have to modify the plumbing myself. Thank you for your time and I can't wait to see the new system in action! View answer

Asked 3 ´years ago

Question 34

My pool is 35k gals does it hurt anything if I go with the bigger 55k unit? Thanks View answer

Asked 3 ´years ago

Question 35

Does the chlorinator need to have water circulating through it continuously? My pool has a timer to run about 8 hours a day. Does the unit need to be oversized for this? View answer

Asked 3 ´years ago

Question 36

My chlorinator is saying there is no water flow, but the water is flowing just fine with no obstructions. The flow indicator switch moves freely. What can I do?? View answer

Asked 3 ´years ago

Question 37

Overall length of salt cell. Also, is it 2 inch tuping in and out, or does it have recucing bushings to change larger size to 2 inch? What's the approximate weight of the salt cell? View answer

Asked 3 ´years ago

Question 38

Bought until 5 months ago and not generating. Power doesn’t seem to be getting to cell but control box lights working and has power. Any ideas? View answer

Asked 3 ´years ago

Question 39

I have a Pentair ICHLOR 30 Salt Chlorine Generator that I want to replace. Will this unit work? My pool is about 13,000 gallons. View answer

Asked 3 ´years ago

Question 40

I am trying to decide between this rj30 and your core 35 could you give me some help I have 15000gl pool changing from tables to salt View answer

Asked 3 ´years ago

Question 41

I see it is drop-in replacement for IntelliFlo and WhisperFlo, what about SuperFlo? I have a single-speed SuperFlo 340038. View answer

Asked 4 ´years ago

Question 42

how long does the edge 15 need to be run to meet the advertised chlorine rate per day? View answer

Asked 4 ´years ago

Question 43

I have a RJ-45 Plus Salt Generator. I don't know what the winter mode button actually does and what it's usefulness is. The owners manual really doesn't describe it's function or why it should or should not be used. View answer

Asked 5 ´years ago

Question 44

Looking at the circupool smartflo variable speed pump (1.5 Hp). What is the frame sizing of the motor, 48 or 56 frame? View answer

Asked 5 ´years ago

Question 45

I have a variable speed pump and I'm curious, what is the minimum water flow in GPM for the CORE series? View answer

Asked 3 ´years ago

Question 46

What determins when your RJ+45 Series" goes into it's "REST Cycle"? View answer

Asked 6 ´years ago

Question 47

I would like to confirm that the Core55 can be connected to an Pentair EasyTouch and IntelliTouch Pool and Spa System as I believe it can. Will the unit work? View answer

Asked 3 ´years ago

Question 48

Hello. I have an RJ-60+ which is rated at 300W, so presumably it only draws 1.36A at 220V. However, the manual also mentions the cell current ranging between 2.5 and 7.8 amps. I can also see the cell current displayed when I cycle through the menu options. For example, at 50%, it shows 5.7 amps. I'm assuming this cell current is different from the load on the circuit breaker. Can you confirm please? View answer

Asked 4 ´years ago

Question 49

How do you winterize the unit? View answer

Asked 4 ´years ago

Question 50

What is the length of the EDG40 chlorine generator cell, please? Just end-of-threads-to-end-of-threads... View answer

Asked 4 ´years ago

CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools