CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Question 1

I have a Pentair ICHLOR 30 Salt Chlorine Generator that I want to replace. Will this unit work? My pool is about 13,000 gallons. View answer

Asked 3 ´years ago

Question 2

I have a limited length of 2" pipe to install the generator. What is the length of pipe needed to be cut out for install? Does the unit come with a cut template? View answer

Asked 4 ´years ago

Question 3

What is the minimum required flow (in GPM) for the RJ60+ Flow Switch to close and enable the Salt Cell to generate Chlorine? View answer

Asked 3 ´years ago

Question 4

Will the system say when it’s time to change the cell? View answer

Asked 5 ´years ago

Question 5

Will this work on 24 round above ground pool that is 5 ft deep ? View answer

Asked 5 ´years ago

Question 6

Is the 10,000 hour life just for the cell? Is that the recommended replacement? View answer

Asked 4 ´years ago

Question 7

Does it need to be connected to 120v or 240v? View answer

Asked 4 ´years ago

Question 8

Does the chlorinator need to have water circulating through it continuously? My pool has a timer to run about 8 hours a day. Does the unit need to be oversized for this? View answer

Asked 3 ´years ago

Question 9

I meant to click the box for 1 1/2 in reducers when I purchased the Core 55 last week. I've looked on the site, but I don't see them separately. Is there a way I can get these now? thanks, Patrick Smith View answer

Asked 4 ´years ago

Question 10

Does the CORE55 control need to be protected from sunlight? View answer

Asked 4 ´years ago

Question 11

I have an RJ-30 Plus system. What is the effect of Cell Version setting on the Menu? Each numerical value also has a '+' and '-'. What does this do to the operation of the system? This is not mentioned anywhere in the manual. View answer

Asked 3 ´years ago

Question 12

can the Core 55 system be installed vertically View answer

Asked 3 ´years ago

Question 13

What size PVC pipe does this fit? My plumbing is 1.5" View answer

Asked 3 ´years ago

Question 14

The pump has written on it : This pump must be installed with a two, multi, or variable speed pump motor controller. The manual says nothing about this. Do I need something else to install this or is it already on the pump? Thanks View answer

Asked 3 ´years ago

Question 15

The lifespan is referring to the cell, correct? How much is the replacement cell for this system? Why is the lifespan range so wide- I am hearing 3 to 7 years- what effects the life span? Thank you. View answer

Asked 3 ´years ago

Question 16

I see it is drop-in replacement for IntelliFlo and WhisperFlo, what about SuperFlo? I have a single-speed SuperFlo 340038. View answer

Asked 4 ´years ago

Question 17

I am looking for a unit to convert my pool to a saltwater pool. I noticed this system says that it is a "replacement" for current systems. What would I need to do to install this as a new system? View answer

Asked 3 ´years ago

Question 18

Does this kit come with a flow switch and is this flow switch from the Hayward compatible with this one View answer

Asked 3 ´years ago

Question 19

The unit is blowing the 15 amp fuse what could cause it? View answer

Asked 4 ´years ago

Question 20

Is it really better to oversize? Looking at the Universal40 for a 20K size pool. Will the 25K be just as efficient? Does the electronic box have a timer or do I need to tie it into my pool timer? Runs 12 hours per day. Using 220v pump. Thank you. View answer

Asked 3 ´years ago

Question 21

Panel is blank View answer

Asked 4 ´years ago

Question 22

Is this system Hayward compatible? View answer

Asked 3 ´years ago

Question 23

What is the current draw of the entire system if running on 110VAC? View answer

Asked 4 ´years ago

Question 24

How much is it to ship to 11715? Blue point NY View answer

Asked 3 ´years ago

Question 25

How soon can we get this product? View answer

Asked 3 ´years ago

Question 26

I need replacement o- rings for this chlorinator. Do you sell then. and if so, how much are they? View answer

Asked 4 ´years ago

Question 27

When do you know it's time to replace an old system? I have a CircuPool Si Series , 8 yrs old this past March, (salt). Can it be replaced with this one? View answer

Asked 3 ´years ago

Question 28

Can I easily replace my jandy 1400 aquapure system with this circupool 40k unit? View answer

Asked 2 ´years ago

Question 29

What is the salt level on this system View answer

Asked 3 ´years ago

Question 30

Will this work with a 25000 gallon above ground pool? View answer

Asked 3 ´years ago

Question 31

Does this unit come with a plug for 120 vac or is it hard wired? View answer

Asked 3 ´years ago

Question 32

What is the overall length on the 40,000 chlorine generator. Is the generator and controller hard wired View answer

Asked 3 ´years ago

Question 33

I have a 5 plus year old SI45 now. I have replaced the cell and now it is blowing the fuse on the main panel. I’m not sure what the cost is to replace the main board or if I should purchase this new unit. Thoughts? View answer

Asked 3 ´years ago

Question 34

Can this be hard wired in place of my hayward salt generator with a 240v connection? View answer

Asked 3 ´years ago

Question 35

What are the dimensions of the control box. I need to decide where I can mount the box. Thanks View answer

Asked 3 ´years ago

Question 36

I am going to be installing an 18,000 gallon above ground pool. Is the Circupool Universal40 the correct size for me and will it come with everything I need for a new install? View answer

Asked 3 ´years ago

Question 37

How many pounds it has? View answer

Asked 3 ´years ago

Question 38

Does it matter if I hook up to 110 volts instead of 220? View answer

Asked 3 ´years ago

Question 39

Where do you install the cartridge-looking device... On the intake line or the outflow (back to the pool) line? View answer

Asked 3 ´years ago

Question 40

1)Hi, are your generators universal voltage? Are there for 220 Volts? 2) How many years can work for a pool of 80,000 liters(21,000 gallons), Thanks View answer

Asked 3 ´years ago

Question 41

My chlorinator is saying there is no water flow, but the water is flowing just fine with no obstructions. The flow indicator switch moves freely. What can I do?? View answer

Asked 3 ´years ago

Question 42

How often do you have to replace the salt cells? I see no mention of longevity View answer

Asked 4 ´years ago

Question 43

Does the control module have to be covered or is it waterproof? View answer

Asked 4 ´years ago

Question 44

What is the warranty? I don’t see any info here. View answer

Asked 4 ´years ago

Question 45

We have a RJ 45 and a pool with just under 14,000 gal. Once Chem levels are achieved how much salt should need to be added to maintain them. It is an indoor pool. View answer

Asked 3 ´years ago

Question 46

Can this replace a Jandy Aquapure 1400 with automation (Jandy AquaLink)? View answer

Asked 5 ´years ago

Question 47

max amperage draw at 220v View answer

Asked 4 ´years ago

Question 48

Does this generator cell plug up with calcite quicker/more readily than the CORE? We have very hard water and very high temperatures, View answer

Asked 4 ´years ago

Question 49

I just installed an RJ60+ in place of my Aquapure 1400. I was just wondering- on the unit, there is a “remote” indicator. What is this for? Are there ways to adjust the unit remotely, perhaps interfacing it with the Jandy system? Thanks. View answer

Asked 4 ´years ago

Question 50

Is there a place where i can get actual dimensions? Like a shop drawing. Ive already managed to rule out the CORE55 from rough dimensions given to another. I suspect this model will be a much more close call on fitting. View answer

Asked 4 ´years ago

CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools