CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Question 1

Do I need to install a check valve before the CORE35 to prevent superchlorinated water backflowing into my system when the pool pump is turned off? View answer

Asked 4 ´years ago

Question 2

How important to place Core35 after the heater? The heater is about 8 feet from the filter but all the plumbing is underground and the wiring will be a longer distance than desired. This will cause me lots of work on new plumbing. I can easily place it between the filter (pool return) and the heater (which we rarely use in Florida). It this acceptable? View answer

Asked 4 ´years ago

Question 3

Can we get an adapter kit for a pentair ic 40 View answer

Asked 3 ´years ago

Question 4

What are the overall dimensions of the unit? View answer

Asked 6 ´years ago

Question 5

Standard overall needed space for installation? And can it be installed vertically? View answer

Asked 5 ´years ago

Question 6

1. Is the Core55 UL listed? 2. Does the unit have a flow direction as the console might be facing my filter? 3. At full Chlorine output what is the 120/240 vac amperage (current draw)?? 4. Does the unit have a bonding lug for connection to the pool system grounded conductor? View answer

Asked 5 ´years ago

Question 7

Do the CORE series of salt chlorinators have a max flow rate? My current Chlorinator requires a bypass loop if the flow rate exceeds 80 gpm. View answer

Asked 4 ´years ago

Question 8

if buying in bulk what kind of deal will i get View answer

Asked 4 ´years ago

Question 9

What's the minimum flow required for the Core55? I'm currently at 1700rpm and seeing the no flow light? Any ideas? View answer

Asked 4 ´years ago

Question 10

CircuPool product under serious consideration. Long time pool owner. 16x34 with diving end rectangular pool so I est. about 25,000 gals. DIY installation and controller can be in or out (exposed to all sun & elements). Can you suggest a good model for me? Thanks View answer

Asked 4 ´years ago

Question 11

Can this be installed at a diagonally? View answer

Asked 4 ´years ago

Question 12

Can this replace my intellichlor ic60 or does it require replumbing? How soon can I get it? View answer

Asked 4 ´years ago

Question 13

are the input and output connections 1 1/2 or 2'' View answer

Asked 4 ´years ago

Question 14

Can you mount this vertical? View answer

Asked 4 ´years ago

Question 15

I have a variable speed pump and I'm curious, what is the minimum water flow in GPM for the CORE series? View answer

Asked 3 ´years ago

Question 16

Can the core 55 be mounted in the vertical position? View answer

Asked 3 ´years ago

Question 17

If hardwired to the pump, will the percentage of output stay the same when powered off and back on again? View answer

Asked 6 ´years ago

Question 18

we just recently bought this product and have questions. Is there a customer service department we can speak to? View answer

Asked 5 ´years ago

Question 19

When converting from a chlorine pool to this system, do I run the already chlorinated water through the system and add additional salt as needed? Thanks a lot for the assistance. View answer

Asked 3 ´years ago

Question 20

When do you think this product will be available again? I am converting a 9 person hot tub to saltwater. Would the edge25 be too large for hot tub? View answer

Asked 3 ´years ago

Question 21

What is the total dimension for the flow switch and cell for the Edge 40? 11 3/4 inches View answer

Asked 6 ´years ago

Question 22

Who sells and installs the EDGE 25/40 in Orlando Florida Area? View answer

Asked 6 ´years ago

Question 23

I am replacing a Hayward system. I will eventually replace the control panel also but for now need ot know if I need to purchase anything else to connect to the existing control panel. it has a plug that connects to it now. Do I need to purchase a separate plug to connect to the control panel? View answer

Asked 6 ´years ago

Question 24

I have a limited length of 2" pipe to install the generator. What is the length of pipe needed to be cut out for install? Does the unit come with a cut template? View answer

Asked 4 ´years ago

Question 25

Can this be used for an 8’x8’ below ground hot tub? View answer

Asked 4 ´years ago

Question 26

I have a 10,000 gallon pool and want to convert to salt. So many questions. It's been 3 years since I drained and replaced 1/2 the water in the pool due to a repair. Should I consider a water replacement prior to conversion ? Under what circumstances should I consider water replacement? Money not an option...which model should I buy? What size? When does increase size not benefit performance for salt conversion power, cell cleaning cycle time, and cell life? Installation should not be a consideration as all would fit my system. Thank you, Bill View answer

Asked 3 ´years ago

Question 27

How do I winterize with this system. View answer

Asked 4 ´years ago

Question 28

I have the Edge40. After a big rainstorm, the system told me that salt level was low. I added a few bags, and got it tested. Showings 4500 level. I had it running on high and boost for about 6 hours, yet my chlorine levels were still extremely low. I then cleaned the cell by the book and ran it again for a few hours with no change to chlorine levels. Still shows no chlorine when tested. I looked at the cell with a flashlight while it was running. I did see the electrolysis bubbles being formed. Yet after a few hours the chlorine levels did not rise. Please advise. View answer

Asked 4 ´years ago

Question 29

Why does the boost light flash on my edge pool generator? View answer

Asked 3 ´years ago

Question 30

Do you have package pricing for just the pre filter, cartridge filter, and the 3hp pump? View answer

Asked 1 ´year ago

Question 31

Does the unlimited combo package come with flow switch or T pipe or do they need to be purchased separately? View answer

Asked 9 ´months ago

Question 32

i have a VS pump/electronic control . can generator be connected directly to pump without separate controller View answer

Asked 5 ´months ago

Question 33

What is the overall length on the 40,000 chlorine generator. Is the generator and controller hard wired View answer

Asked 4 ´years ago

Question 34

What is the salt level on this system View answer

Asked 3 ´years ago

Question 35

is this unit 220V or 115V View answer

Asked 3 ´years ago

Question 36

How much is it to ship to 11715? Blue point NY View answer

Asked 3 ´years ago

Question 37

Does this kit come with a flow switch and is this flow switch from the Hayward compatible with this one View answer

Asked 3 ´years ago

Question 38

How soon can we get this product? View answer

Asked 3 ´years ago

Question 39

Where can I purchase the cell only for the 40 model ? View answer

Asked 3 ´years ago

Question 40

Can I easily replace my jandy 1400 aquapure system with this circupool 40k unit? View answer

Asked 3 ´years ago

Question 41

The unit is blowing the 15 amp fuse what could cause it? View answer

Asked 4 ´years ago

Question 42

When do you know it's time to replace an old system? I have a CircuPool Si Series , 8 yrs old this past March, (salt). Can it be replaced with this one? View answer

Asked 3 ´years ago

Question 43

I have a 5 plus year old SI45 now. I have replaced the cell and now it is blowing the fuse on the main panel. I’m not sure what the cost is to replace the main board or if I should purchase this new unit. Thoughts? View answer

Asked 3 ´years ago

Question 44

Where do you install the cartridge-looking device... On the intake line or the outflow (back to the pool) line? View answer

Asked 3 ´years ago

Question 45

can I buy a remote for the UL40? View answer

Asked 3 ´years ago

Question 46

Bought until 5 months ago and not generating. Power doesn’t seem to be getting to cell but control box lights working and has power. Any ideas? View answer

Asked 3 ´years ago

Question 47

Will this control panel work with a Hayward Salt Cell? View answer

Asked 4 ´years ago

Question 48

Overall length of salt cell. Also, is it 2 inch tuping in and out, or does it have recucing bushings to change larger size to 2 inch? What's the approximate weight of the salt cell? View answer

Asked 3 ´years ago

Question 49

Can I install the unit on the discharge of the filter housing? View answer

Asked 3 ´years ago

Question 50

is it plug and play 120 volt input hook-up. is it all in one inside program box is there a transformer inside the panel? or do I need extural View answer

Asked 3 ´years ago

CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools