CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A
Activity timeframe
are the input and output connections 1 1/2 or 2'' View answer
Asked 4 ´years ago
Can you mount this vertical? View answer
Asked 3 ´years ago
can the Core 55 system be installed vertically View answer
Asked 3 ´years ago
Can the core 55 be mounted in the vertical position? View answer
Asked 3 ´years ago
How long will the cell last before it needs to be replaced? View answer
Asked 3 ´years ago
Does the CORE55 control need to be protected from sunlight? View answer
Asked 4 ´years ago
Who sells and installs the EDGE 25/40 in Orlando Florida Area? View answer
Asked 5 ´years ago
I am replacing a Hayward system. I will eventually replace the control panel also but for now need ot know if I need to purchase anything else to connect to the existing control panel. it has a plug that connects to it now. Do I need to purchase a separate plug to connect to the control panel? View answer
Asked 5 ´years ago
Can this be used for an 8’x8’ below ground hot tub? View answer
Asked 4 ´years ago
What is the power draw on the Edge system? View answer
Asked 3 ´years ago
I have a 10,000 gallon pool and want to convert to salt. So many questions. It's been 3 years since I drained and replaced 1/2 the water in the pool due to a repair. Should I consider a water replacement prior to conversion ? Under what circumstances should I consider water replacement? Money not an option...which model should I buy? What size? When does increase size not benefit performance for salt conversion power, cell cleaning cycle time, and cell life? Installation should not be a consideration as all would fit my system. Thank you, Bill View answer
Asked 3 ´years ago
How do I winterize with this system. View answer
Asked 4 ´years ago
I have the Edge40. After a big rainstorm, the system told me that salt level was low. I added a few bags, and got it tested. Showings 4500 level. I had it running on high and boost for about 6 hours, yet my chlorine levels were still extremely low. I then cleaned the cell by the book and ran it again for a few hours with no change to chlorine levels. Still shows no chlorine when tested. I looked at the cell with a flashlight while it was running. I did see the electrolysis bubbles being formed. Yet after a few hours the chlorine levels did not rise. Please advise. View answer
Asked 4 ´years ago
Why does the boost light flash on my edge pool generator? View answer
Asked 3 ´years ago
Is it a bad thing to go bigger with the pump and generator? View answer
Asked 10 ´months ago
Can your pumps and filters work just as well with chlorinated pool? View answer
Asked 9 ´months ago
What size set up for a 3000 gallon plunge pool? View answer
Asked 5 ´months ago
Can I install the unit on the discharge of the filter housing? View answer
Asked 3 ´years ago
Is there a regular interval at which polarity is reversed? I run my pump 4 hours per day. When not running there will be no power to the control unit. I'm worried based on my past experience with Zodiac LM that with power being cut, the polarity will be reversed every 4 hours after power up which would be a problem (of course I can run it longer if needed). View answer
Asked 3 ´years ago
