CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Question 1

This says it can produce up to 1.4 lbs of chlorine per day. Would this be assuming it is running at 100% output for 24 hours? Just trying to figure out my run time and output settings. Last year I was using about a 1/2 pound to 3/4 pound of chlorine per day before I installed this salt cell View answer

Asked 4 ´years ago

Question 2

I have a variable speed pump. The question is, when I am at the low speed I suspect the flow will not be enough for the flow switch to read so it will not produce salt. Is this correct? Will this harm the system?If I purchase this my plan is to set the pump speeds to get the chlorine level I need. Pool is 15000 gallons View answer

Asked 3 ´years ago

Question 3

I have a below grade equipment room. I was going to install 2- SJ55 on a 50,000 gallon pool. I want the system to coast for longer cell life. What do I need to install the two units below ground? Would it be possible to get a drawing of what you would recommend? View answer

Asked 6 ´years ago

Question 4

I have a timer on my pump. Does the generator need to be on a timer also or is it ok to just let the flow switch shut down the unit when the pump is off? View answer

Asked 3 ´years ago

Question 5

I have a 10,000 gallon pool and want to convert to salt. So many questions. It's been 3 years since I drained and replaced 1/2 the water in the pool due to a repair. Should I consider a water replacement prior to conversion ? Under what circumstances should I consider water replacement? Money not an option...which model should I buy? What size? When does increase size not benefit performance for salt conversion power, cell cleaning cycle time, and cell life? Installation should not be a consideration as all would fit my system. Thank you, Bill View answer

Asked 3 ´years ago

Question 6

Our pool has 6500 gal. and I think the CORE15 model should have the right size. 1. When do I have to change the cell for the first time? and 2. what means 8 years "limited"? Thank you, Thomas View answer

Asked 4 ´years ago

Question 7

Does the chlorinator need to have water circulating through it continuously? My pool has a timer to run about 8 hours a day. Does the unit need to be oversized for this? View answer

Asked 3 ´years ago

Question 8

How do I shock my salt water pool that has a RJ60+ system. View answer

Asked 3 ´years ago

Question 9

My chlorinator is saying there is no water flow, but the water is flowing just fine with no obstructions. The flow indicator switch moves freely. What can I do?? View answer

Asked 3 ´years ago

Question 10

How to wire this pump with CircuPool RJ-30 PLUS Salt Chlorine Generator to be able to use the pump timer ? View answer

Asked 2 ´years ago

Question 11

What is the current draw of the entire system if running on 110VAC? View answer

Asked 4 ´years ago

Question 12

Where is CircuPool equipment made? View answer

Asked 5 ´years ago

Question 13

Can I use this unit with a variable speed (vs) pump? If so what rpm and duration settings should I use? View answers

Asked 3 ´years ago

Question 14

What is the difference between the RJ vs the SJ series? View answer

Asked 6 ´years ago

Question 15

Do I need to install a check valve before the CORE35 to prevent superchlorinated water backflowing into my system when the pool pump is turned off? View answer

Asked 4 ´years ago

Question 16

How can I tell what my salinity level is on the Core35 unit? View answer

Asked 4 ´years ago

Question 17

How can I get a pdf of the manual View answer

Asked 4 ´years ago

Question 18

what size pipe is used for the inlet and outlet and is it PVC? View answer

Asked 3 ´years ago

Question 19

What is the minimum GPM flow rate required for the Core series? View answer

Asked 4 ´years ago

Question 20

I have a 13,000 gallon fiberglass pool. I was looking at your Core35, is this overkill? I would rather have it and not need it, than need it and not have it. View answer

Asked 4 ´years ago

Question 21

I have a Pentair ICHLOR 30 Salt Chlorine Generator that I want to replace. Will this unit work? My pool is about 13,000 gallons. View answer

Asked 3 ´years ago

Question 22

Is this compatible with iAquaLink 3.0 so I can view my readings remotely? View answer

Asked 3 ´years ago

Question 23

Bought until 5 months ago and not generating. Power doesn’t seem to be getting to cell but control box lights working and has power. Any ideas? View answer

Asked 3 ´years ago

Question 24

Can this be used on an above ground pool? View answer

Asked 5 ´years ago

Question 25

When will SJ-20 system be available? View answer

Asked 4 ´years ago

Question 26

Only number two polarity comes on View answer

Asked 5 ´years ago

Question 27

Is this compatible for a compupool inlet and outlet hook ups? View answer

Asked 6 ´years ago

Question 28

I have a SJ-series system 4 years ago. works great. I just had a variable speed pool pump installed. It goes threw its own internal timers. does the SJ- series have a built in flow switch sensor built in. Worried about the unit coming on via the old pool timer without the new pump running? View answer

Asked 5 ´years ago

Question 29

is this unit 220V or 115V View answer

Asked 3 ´years ago

Question 30

Does this unit come with a plug for 120 vac or is it hard wired? View answer

Asked 3 ´years ago

Question 31

What are the dimensions of the control box. I need to decide where I can mount the box. Thanks View answer

Asked 3 ´years ago

Question 32

Just bought the sj35 and don’t see anywhere in the instructions how long the two risers have to be. How long should they be? View answer

Asked 4 ´years ago

Question 33

How do I buy a replacement for the SJ 3500 Generator buy it's self?? View answer

Asked 3 ´years ago

Question 34

Is there an adapter kit for a Compupool CPSC36 system? View answer

Asked 4 ´years ago

Question 35

Can you use the flow switch from my Hayward system or do I have to change it? Also what would be the shipping time after I order? Universal 40 View answer

Asked 4 ´years ago

Question 36

I bought a house with a 26qft pool. I'm trying to learn to control the salt chlorinator (SJ series) for my pool. The water is murky now, with algae. All parameters are ok (I check regularly), except chlorine and free chlorine levels, which are at 0. How do I know that the cell actually works? Is there a documentation regarding the controller? the left bottom green light has been blinking. Also, how is this controller related to the pump? I have Hayward controller for the pump, and I'm clueless here too. Please help. View answer

Asked 3 ´years ago

Question 37

what is the length of it? How long of a span of tubing is needed to be cut out for install? View answer

Asked 5 ´years ago

Question 38

Will this be a direct replacement for the Si45? View answer

Asked 4 ´years ago

Question 39

Can the RJ series be run on a above ground pool? If so can it be run vertically similar to the same way the Hayward Aqutrol RJ model which ties connected directly to the return jet? Thanks for any info View answer

Asked 6 ´years ago

Question 40

Hi I have a 20,000 gallon pool pentair IC40 Salt Chlorinator right now and want to replace with the RJ30. I wanted to know if the RJ30 would fit the current plumbing exactly or would I have to do some repiping? View answer

Asked 4 ´years ago

Question 41

what is the difference compared to the old RJ30 View answer

Asked 3 ´years ago

Question 42

I am trying to decide between this rj30 and your core 35 could you give me some help I have 15000gl pool changing from tables to salt View answer

Asked 3 ´years ago

Question 43

If you have the SJ20 and upgrade to the RJ30 plus, do all the replacement parts fit where the SJ20 parts were? For example the cell fittings? View answer

Asked 3 ´years ago

Question 44

I have an inground 11,500gal (estimate) pool. I have a 100 sq ft cartridge filter. All visible plumbing is 1-1/2" PVC. The current pump motor is 1 HP single speed. I would like to upgrade to a VS pump to run 8 hrs per day and turn the pool over 2x/day. I'm also considering the RJ-20PLUS SWCG. What size motor should I use - the 1.5, 2.0 or the 3.0HP??? Also, do you agree with the RJ-20 or should I go with the RJ-30? View answer

Asked 3 ´years ago

Question 45

I see it is drop-in replacement for IntelliFlo and WhisperFlo, what about SuperFlo? I have a single-speed SuperFlo 340038. View answer

Asked 4 ´years ago

Question 46

Installed the RJ-30 just before summer hit here in the Houston area on a ~15K gallon pool. Just want to know if having to run it at around 85-90% power is normal for the hot summer days on this size of pool. View answer

Asked 3 ´years ago

Question 47

Can i use rj-45 for a 10000 gallon pool. My neighbor sold his house before he got to instill it on his pool. View answer

Asked 3 ´years ago

Question 48

Is there a place where i can get actual dimensions? Like a shop drawing. Ive already managed to rule out the CORE55 from rough dimensions given to another. I suspect this model will be a much more close call on fitting. View answer

Asked 4 ´years ago

Question 49

16x32 x 5what size system do I need View answer

Asked 3 ´years ago

Question 50

Can you have too big of a chlorinator? View answer

Asked 3 ´years ago

CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools