CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Question 1

Can I use this unit with a variable speed (vs) pump? If so what rpm and duration settings should I use? View answers

Asked 4 ´years ago

Question 2

Is the SJ20 110 or 240 volt? View answer

Asked 4 ´years ago

Question 3

When will these be back in stock? View answer

Asked 4 ´years ago

Question 4

Does this work for above ground pool View answer

Asked 4 ´years ago

Question 5

Is it OK to install the salt generator cell (SJ-20) and flow sensor on the discharge piping of my pool cartridge cannister? View answer

Asked 4 ´years ago

Question 6

I am considering the purchase on your model RJ30. I am looking at the spects on Amazon, on the page for ordering it states 1.5 lb of salt made per day. but down on the compareable chart it states 3.1 lbs for the RJ30. which is it? View answer

Asked 4 ´years ago

Question 7

Will this handle a 72000 litre pool in a northern rn climate View answer

Asked 4 ´years ago

Question 8

When its generating how do you know its producing View answer

Asked 5 ´years ago

Question 9

How difficult is it to convert a chlorine tablet system to the Circupool SJ~20 system? Is the conversion similar to the one you use to convert from one salt system to the circupool product. Thanks View answer

Asked 5 ´years ago

Question 10

I just installed an RJ60+ in place of my Aquapure 1400. I was just wondering- on the unit, there is a “remote” indicator. What is this for? Are there ways to adjust the unit remotely, perhaps interfacing it with the Jandy system? Thanks. View answer

Asked 6 ´years ago

Question 11

I currenty have a aquapure 1400 that I am really dissatisfied with. I just changed the cell and it is still sporadic with error messages. I can’t believe I just bought a cell for $700.00 and nothing! Is this system a direct bolt on? I don’t want to continue throwing money at this problem. The pool size is 18,000 gallons and I live in Miami, Fl. Which is hot! View answer

Asked 6 ´years ago

Question 12

I have a SJ-series system 4 years ago. works great. I just had a variable speed pool pump installed. It goes threw its own internal timers. does the SJ- series have a built in flow switch sensor built in. Worried about the unit coming on via the old pool timer without the new pump running? View answer

Asked 6 ´years ago

Question 13

Does it only work when pump running and does it have a chlorine level reading View answer

Asked 5 ´years ago

Question 14

Will the universal 40 cell fit the t-15 directly. View answer

Asked 4 ´years ago

Question 15

I have a 15,000 gallon pool with a 3 year old waves/breeze unit that needs to be replaced. Just will not generate chlorine since install. Will this unit provide the correct chlorine and sanitizer needed for this size pool View answer

Asked 5 ´years ago

Question 16

I am replacing a Hayward system. I will eventually replace the control panel also but for now need ot know if I need to purchase anything else to connect to the existing control panel. it has a plug that connects to it now. Do I need to purchase a separate plug to connect to the control panel? View answer

Asked 6 ´years ago

Question 17

Where can I purchase the cell only for the 40 model ? View answer

Asked 4 ´years ago

Question 18

what should the salt level of the pool be? View answer

Asked 4 ´years ago

Question 19

How do I shock my salt water pool that has a RJ60+ system. View answer

Asked 4 ´years ago

Question 20

On the edge40 for do it yourselfer does this just plug into a gfci outlet. I cant find the installation instructions. I have a small pool maybe 10000-12000 gal. View answer

Asked 4 ´years ago

Question 21

HI..MY SALT LEVEL PPM IS 5000. WILL YUR SYTEM STILL GENERATE CLHORILE AT THIS LEVEL? View answer

Asked 6 ´years ago

Question 22

I have an inground pool 13,500 gallon in southwest Florida what size SJ unit will i need ? View answer

Asked 5 ´years ago

Question 23

What is the power draw on the Edge system? View answer

Asked 4 ´years ago

Question 24

I need to purchase a new system, is there anywhere I can look at how this is installed to see what I need to do if I replace by Frog system with this one. View answer

Asked 5 ´years ago

Question 25

I have a 10,000 gallon pool and want to convert to salt. So many questions. It's been 3 years since I drained and replaced 1/2 the water in the pool due to a repair. Should I consider a water replacement prior to conversion ? Under what circumstances should I consider water replacement? Money not an option...which model should I buy? What size? When does increase size not benefit performance for salt conversion power, cell cleaning cycle time, and cell life? Installation should not be a consideration as all would fit my system. Thank you, Bill View answer

Asked 4 ´years ago

Question 26

I have the Edge40. After a big rainstorm, the system told me that salt level was low. I added a few bags, and got it tested. Showings 4500 level. I had it running on high and boost for about 6 hours, yet my chlorine levels were still extremely low. I then cleaned the cell by the book and ran it again for a few hours with no change to chlorine levels. Still shows no chlorine when tested. I looked at the cell with a flashlight while it was running. I did see the electrolysis bubbles being formed. Yet after a few hours the chlorine levels did not rise. Please advise. View answer

Asked 5 ´years ago

Question 27

Can you use a timer to turn the rj30 on and off? View answer

Asked 5 ´years ago

Question 28

Looking for a system to replace my old system all my ports are 1.5” also looking to run a 48sq ft filter was looking at running DE again what’s the difference between cartrdige filter and DE? Customer of mine bought all new stuff from you guys so wanted to see what you had available thank you. View answer

Asked 5 ´years ago

Question 29

Why does the boost light flash on my edge pool generator? View answer

Asked 4 ´years ago

Question 30

why does the housing leak? I replaced gasket and it leaks around the threads View answer

Asked 4 ´years ago

Question 31

I have a below grade equipment room. I was going to install 2- SJ55 on a 50,000 gallon pool. I want the system to coast for longer cell life. What do I need to install the two units below ground? Would it be possible to get a drawing of what you would recommend? View answer

Asked 7 ´years ago

Question 32

1.Is there a video showing how to install? 2.Also, I have a 30,000 gallon pool, is it better to oversized the salt chlorinate? 3. I am replacing an existing chlorinator, I am very familiar with working with PVC pipe, is this a DIY project? 4. If I install myself are all warranties still in effect. Thank you View answer

Asked 6 ´years ago

Question 33

Do you have package pricing for just the pre filter, cartridge filter, and the 3hp pump? View answer

Asked 1 ´year ago

Question 34

what is the length of it? How long of a span of tubing is needed to be cut out for install? View answer

Asked 6 ´years ago

Question 35

When switching from chlorine to salt, do you have to start with fresh pool water or just add salt? View answer

Asked 1 ´year ago

Question 36

What is the difference between the RJ vs the SJ series? View answer

Asked 7 ´years ago

Question 37

is this unit 220V or 115V View answer

Asked 4 ´years ago

Question 38

What size set up for a 3000 gallon plunge pool? View answer

Asked 1 ´year ago

Question 39

What is the warranty, parts availability?Do you have a tech sheet or sales brochure you could email or mail to me? View answer

Asked 5 ´years ago

Question 40

Is it product partial to leave the unit powered 24-7 ? I recently purchased a variable speed pump which leaves the unit on displaying various lights…I realize the flow switch controls the Cell but I dont want to unnecessarily damage the unit by leaving it powered 24-7 View answer

Asked 4 ´years ago

Question 41

Concerning your RJ-20 System, I am close to the beach and a very corrosive environment, what is the rating on your control box and how does it stand up in salty conditions? View answer

Asked 4 ´years ago

Question 42

What is the max amp draw of this unit? I am trying to decide if I should add it to my pump circuit or add a new circuit and if the latter than size the circuit. View answer

Asked 4 ´years ago

Question 43

I have above ground pool 33 foot by 54 inch deep is this the best unit View answer

Asked 5 ´years ago

Question 44

Can this chlorinator be added before the filter after the pump ?The existing pool system is very constrained where the water returns to the pool after the filter View answer

Asked 4 ´years ago

Question 45

I have a RJ-45 Plus Salt Generator. I don't know what the winter mode button actually does and what it's usefulness is. The owners manual really doesn't describe it's function or why it should or should not be used. View answer

Asked 5 ´years ago

Question 46

If I currently have a Hayward Aquarite, do I need the adapter or will the Core35 fit where my cell is now? View answer

Asked 4 ´years ago

Question 47

Just received it, and so psyched to replace my 18 year old Aquarite, it looks great. Can I keep the old flow switch from that system that still works fine, or do I need to swap in the new one. Just looking for simplicity in the install. Thanks, View answer

Asked 5 ´years ago

Question 48

This says it can produce up to 1.4 lbs of chlorine per day. Would this be assuming it is running at 100% output for 24 hours? Just trying to figure out my run time and output settings. Last year I was using about a 1/2 pound to 3/4 pound of chlorine per day before I installed this salt cell View answer

Asked 5 ´years ago

Question 49

Is this system compatible to replace a compuclor? View answer

Asked 5 ´years ago

Question 50

How long is the power cord? View answer

Asked 5 ´years ago

CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration) Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools