SJ Series Q&A

Question 1

Is the flow switch required on a salt chlorinator system? View answer

Asked 2 ´years ago

Question 2

What else can I use to clean the salt cell? View answer

Asked 12 ´months ago

Question 3

I have an SJ45A System that won't generate chlorine. View answer

Asked 11 ´months ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 4

Is it possible to bypass the flow switch because the system turns on when the pump starts? View answer

Asked 11 ´months ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 5

Do I need to register my new system and if so, where do I register it at? View answer

Asked 1 ´year ago

Question 6

Salt level is normal but chlorine level is low. What can cause this? View answer

Asked 5 ´months ago

Question 7

What does a blinking red salt light mean on my SJ-45A unit? Cell light is green. Salinity levels are correct. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 8

Only number two polarity comes on View answer

Asked 5 ´years ago

Question 9

What does the circupool sj-20 salt chlorine generator's Control Module do? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool® SJ-20 Salt Chlorine Generator

Question 10

Where can I get a replacement LCD display board for my SJ-20 Circupool Chlorine generator system? View answer

Asked 1 ´year ago

Question 11

How to install sj45a to variable speed pump View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 12

Flow switch led red when water is flowing? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 13

Why does my CircuPool SJ-20 Salt Chlorine Generator show low water temp and flow red lights even after replacing the flow sensor? View answer

Asked 1 ´year ago

Question 14

Can an SJ-45A cell be used with an SJ-35A control module? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool® SJ-35 Salt Chlorine Generator

Question 15

No lights on the panel View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 16

Why is it showing red lights and not producing chlorine? View answer

Asked 9 ´months ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 17

Is the flow switch necessary? My chlorinator already switches on and off automatically with my pump. View answer

Asked 2 ´years ago

Question 18

How do you claim a warranty on my CircuPool equipment? View answer

Asked 2 ´years ago

Question 19

flow led changing red to green; 6 seconds green - 8 seconds red - then green again View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 20

what should the salt level of the pool be? View answer

Asked 3 ´years ago

Question 21

I have an 80000 gallon pool which is heated in winter. Can I use two sj55's, on e on each heater? View answer

Asked 1 ´year ago

Question 22

Where can I find the CircuPool serial number on my equipment?? View answer

Asked 1 ´year ago

Question 23

Just started recently, when the unit first turns on, it hums and vibrates. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 24

What is the voltage for the chlorinator View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 25

What is the duration of the manufacturer warranty for the CircuPool SJ-20 salt chlorine generator? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool® SJ-20 Salt Chlorine Generator

Question 26

Will an SJ-35 cell work in an SJ-30 system? View answer

Asked 3 ´months ago

Question 27

I got a salt cell in February. I am adding salt twice a week and after about three days I start to see loose alg View answer

Asked 2 ´years ago

Question 28

Is the SJ20 110 or 240 volt? View answer

Asked 3 ´years ago

Question 29

How can you tell if your salt cell is, View answer

Asked 2 ´months ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 30

I have 8,000 gal. Do they make a smaller unit? Thank you View answer

Asked 4 ´years ago

Question 31

sacrificial anode / cyanuric acid stabilizer level in pool? View answer

Asked 2 ´years ago

Question 32

What controls are included in the CircuPool SJ-20 Salt Chlorine Generator? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool® SJ-20 Salt Chlorine Generator

Question 33

Will the Sj-20 work with an above ground round 20’ x 48” Intex pool? If it does, do you have an adapter kit? The fittings are 1.5 in. View answer

Asked 3 ´years ago

Question 34

I purchased a SJ-20 (from Amazon, hasn't arrived yet) it was a panic buy, only nine left yada yada, no chlorine available locally. but I realize now that the unit will likely be undersized as my pool is 30000 gallons. they didn't indicate volume or capacity and I did not find you website until after i made the purchase. So am i wasting my time with this unit or do I have any recourse ( upgrade path? bigger cell etc.) any input would be appreciated. View answer

Asked 4 ´years ago

Question 35

My SJ20 is turning itself off and both the cell light and the sale light are showing red. The salt level is good. View answer

Asked 2 ´months ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 36

Are you sure I can't put my swcg before the heater? View answer

Asked 3 ´years ago | Support

Question 37

Why won't my SJ20 cycle the reverse polarity. It's causing the plates to get covered very quickly. View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 38

What is the return policy if the cell is not the fix and I need to buy another complete system? View answer

Asked 1 ´year ago

Question 39

My pool pump runs all the time how do I wire in my SJA series View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 40

When will these be back in stock? View answer

Asked 3 ´years ago

Question 41

SJ series chlorinator is not producing chlorine View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 42

I have an inground pool 13,500 gallon in southwest Florida what size SJ unit will i need ? View answer

Asked 4 ´years ago

Question 43

Will this model work with above ground pools? View answer

Asked 1 ´year ago

Question 44

Is there an adapter kit for a Compupool CPSC36 system? View answer

Asked 4 ´years ago

Question 45

I need to purchase a new system, is there anywhere I can look at how this is installed to see what I need to do if I replace by Frog system with this one. View answer

Asked 4 ´years ago

Question 46

I have an older RJ 45 model, S/N 30477. Will the SJ 45 fit on my existing plumbing? IE, are the inlet and outlet openings the same distance apart as the RJ? Can you send dimensional specs to me? View answer

Asked 4 ´years ago

Question 47

On our second SJ40 and have never used Super CL Mode and would like to know should the light be red.?? We just had the pool redone and need to get the chlorine and salinity back up to where they need to be.......... View answer

Asked 6 ´years ago

Question 48

Is it OK to install the salt generator cell (SJ-20) and flow sensor on the discharge piping of my pool cartridge cannister? View answer

Asked 3 ´years ago

Question 49

The Digital Control Panel of the SJ-40 has stopped working how can I fix it? View answer

Asked 5 ´years ago

Question 50

Can the unit be mounted on its side rather than upright (the intake and output openings upward)? View answer

Asked 4 ´years ago

SJ Series Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools