EDGE Series Q&A

Question 1

Is the flow switch required on a salt chlorinator system? View answer

Asked 2 ´years ago

Question 2

Can you use a pool ionizer in conjunction with a salt generator?

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 3

How long is the salt generator supposed to last? I just recently cleaned mine as instructed reinstalled and it stop View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 4

Check cell light is on View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 5

How often will I need to replace the salt cell View answer

Asked 3 ´months ago

Question 6

Where can I get my CircuPool salt cell tested? View answer

Asked 1 ´month ago

Question 7

sacrificial anode / cyanuric acid stabilizer level in pool? View answer

Asked 2 ´years ago

Question 8

Where is the serial number located? View answer

Asked 11 ´months ago

Question 9

Do I need to register my new system and if so, where do I register it at? View answer

Asked 1 ´year ago

Question 10

Is the 6"-12" of straight pipe absolutely necessary before entering the flow sensor? View answer

Asked 1 ´month ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 11

I got a salt cell in February. I am adding salt twice a week and after about three days I start to see loose alg View answer

Asked 2 ´years ago

Question 12

Is this system for inground pool? View answer

Asked 2 ´months ago

Question 13

How do you claim a warranty on my CircuPool equipment? View answer

Asked 2 ´years ago

Question 14

My system error light is on. What should I do? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 15

Salt level is normal but chlorine level is low. What can cause this? View answer

Asked 3 ´months ago

Question 16

My troubleshooting process ended with 7 blue LEDs showing which says that control module replacement is needed View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 17

Am I able to bond the Edge system with my pool? I don’t see anywhere to connect the bonding wire? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 18

Maximum input voltage View answer

Asked 1 ´month ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 19

I have a 10,000 gallon pool and want to convert to salt. So many questions. It's been 3 years since I drained and replaced 1/2 the water in the pool due to a repair. Should I consider a water replacement prior to conversion ? Under what circumstances should I consider water replacement? Money not an option...which model should I buy? What size? When does increase size not benefit performance for salt conversion power, cell cleaning cycle time, and cell life? Installation should not be a consideration as all would fit my system. Thank you, Bill View answer

Asked 3 ´years ago

Question 20

I soaked the cell in the muratic acid solution for 10’ but there are still mineral deposits visible on both ends View answer

Asked 1 ´year ago

Question 21

Can the flow switch be installed upstream of the heater? View answer

Asked 6 ´months ago

Question 22

What is the return policy if the cell is not the fix and I need to buy another complete system? View answer

Asked 1 ´year ago

Question 23

What does System Error 3 mean? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 24

Where can I find the CircuPool serial number on my equipment?? View answer

Asked 1 ´year ago

Question 25

I love my salt chlorine generator but I use a lot of acid for the pH. Is this caused by it generating chlorine? View answer

Asked 1 ´year ago

Question 26

If I buy a new system on eBay from a vendor that is not a Circupool dealer, will that affect the warranty? View answer

Asked 1 ´year ago

Question 27

I have a variable speed pump with its own timer. Can I leave the salt generator on all the time? Will it run only when it senses water flow with the flow sensor? View answer

Asked 3 ´years ago

Question 28

I have the Edge40. After a big rainstorm, the system told me that salt level was low. I added a few bags, and got it tested. Showings 4500 level. I had it running on high and boost for about 6 hours, yet my chlorine levels were still extremely low. I then cleaned the cell by the book and ran it again for a few hours with no change to chlorine levels. Still shows no chlorine when tested. I looked at the cell with a flashlight while it was running. I did see the electrolysis bubbles being formed. Yet after a few hours the chlorine levels did not rise. Please advise. View answer

Asked 3 ´years ago

Question 29

I have a 16,000 gallon above ground pool, will the Edge Series work? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series

Question 30

Low Salt light blinking on my CircuPool Edge 25. It was installed 1 month ago, test strips and tester read 3900, and the pool temp is 82. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 31

I have a limited length of 2" pipe to install the generator. What is the length of pipe needed to be cut out for install? Does the unit come with a cut template? View answer

Asked 4 ´years ago

Question 32

how to determine if edge 40 cell needs replacement View answer

Asked 1 ´year ago

Question 33

I see no wiring diagram in the instructions for a plug onto the edge control box View answer

Asked 1 ´year ago

Question 34

My pool is 56k gallons. What do you recommend? If two, run inline or parallel? View answer

Asked 2 ´years ago | Sales

Question 35

Circupool edge on for four days all the lights come on but chlorine still low have it on boost 24/7 View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 36

Can the flow switch be installed vertical position? View answer

Asked 2 ´months ago

Question 37

My CircuPool Edge unit is producing too much Chlorine at the lowest setting, and will sometimes introduce bubbles? View answer

Asked 10 ´months ago

Question 38

Water flow light is on, not producing chlorine View answer

Asked 1 ´month ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 39

Why must the flow switch have the wires pointing up when installed horizontally? View answer

Asked 12 ´days ago

Question 40

My control panel got moisture in it due to high humidity and condensation. Is that covered under the warrantee? View answer

Asked 11 ´days ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 41

register my device

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 42

I bought an Edge 25 from Discount Salt Pool, is that product covered under warranty or do I have to order from you to receive a full warranty? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 43

To send a CircuPool Edge salt cell in for inspection, do you send the entire cell including housing or can the blades be removed and sent? View answer

Asked 1 ´year ago

Question 44

Display View answer

Asked 1 ´year ago

Question 45

Circuit Breaker? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 46

Is there a reset button on the Edge unit? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 47

50 and 60 hz or only 60hz?

Asked 6 ´months ago

Question 48

Can Magnesium chloride be used with this? View answer

Asked 7 ´months ago

Question 49

Should I clean the salt cell before I put it away for the winter? View answer

Asked 10 ´months ago

Question 50

Edge controller not set to cell size View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series

EDGE Series Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools