EDGE Series Q&A

Question 1

Is the flow switch required on a salt chlorinator system? View answer

Asked 4 ´years ago

Question 2

sacrificial anode / cyanuric acid stabilizer level in pool? View answer

Asked 3 ´years ago

Question 3

How often will I need to replace the salt cell View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series

Question 4

system error 5 & 6

Asked 3 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 5

Why hasTemp sensor malfunction after 22hrs running from new install? View answer

Asked 6 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 6

To prolong the life of a salt water chlorine generator's cell, would it be better to run the pool system at 25% for 24 hrs., 50% for 12 hrs. or 100% 6 hrs View answer

Asked 2 ´months ago

Question 7

Check cell light is on View answer

Asked 3 ´years ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 8

Installed last weekend edge new units system error light tested 3 lights temp sensor reset back after 22 hrs. View answer

Asked 6 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 9

Where can I find the CircuPool serial number on my equipment?? View answer

Asked 2 ´years ago

Question 10

What is the power draw on the Edge system? View answer

Asked 4 ´years ago

Question 11

How many titanium plates does this EDGE-40 cell have? View answer

Asked 3 ´years ago

Question 12

To send a CircuPool Edge salt cell in for inspection, do you send the entire cell including housing or can the blades be removed and sent? View answer

Asked 2 ´years ago

Question 13

On the Edge 40 how long is the cable from controller to cell View answer

Asked 2 ´years ago

Question 14

Where is the serial number located? View answer

Asked 2 ´years ago

Question 15

I bought an Edge 25 from Discount Salt Pool, is that product covered under warranty or do I have to order from you to receive a full warranty? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 16

Can Magnesium chloride be used with this? View answer

Asked 1 ´year ago

Question 17

Backup power for Edge 25 View answer

Asked 2 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 18

How often is my salt cell supposed to be cleaned? View answer

Asked 2 ´months ago

Question 19

Edge series blank for winter use

Asked 4 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 20

I got a salt cell in February. I am adding salt twice a week and after about three days I start to see loose alg View answer

Asked 3 ´years ago

Question 21

Do I need to register my new system and if so, where do I register it at? View answer

Asked 2 ´years ago

Question 22

50 and 60 hz or only 60hz?

Asked 1 ´year ago

Question 23

Does this model work with 220V? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 24

register my device

Asked 2 ´years ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 25

Can the flow switch be installed vertically with a variable speed pump?

Asked 6 ´months ago | Sanitation > Salt Chlorinators > EDGE Series

Question 26

My CircuPool Edge unit is producing too much Chlorine at the lowest setting, and will sometimes introduce bubbles? View answer

Asked 2 ´years ago

Question 27

panel dose not turn when i start time

Asked 4 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 28

All the LEDs went out on my edge25. Do I need a new unit? View answer

Asked 3 ´years ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 29

All seems normal, but no chlorine is registering on test. What could be issue?

Asked 4 ´months ago

Question 30

I have a variable speed pump with its own timer. Can I leave the salt generator on all the time? Will it run only when it senses water flow with the flow sensor? View answer

Asked 4 ´years ago

Question 31

I have the Edge40. After a big rainstorm, the system told me that salt level was low. I added a few bags, and got it tested. Showings 4500 level. I had it running on high and boost for about 6 hours, yet my chlorine levels were still extremely low. I then cleaned the cell by the book and ran it again for a few hours with no change to chlorine levels. Still shows no chlorine when tested. I looked at the cell with a flashlight while it was running. I did see the electrolysis bubbles being formed. Yet after a few hours the chlorine levels did not rise. Please advise. View answer

Asked 5 ´years ago

Question 32

What is the width of the salt cell? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series

Question 33

On the edge40 for do it yourselfer does this just plug into a gfci outlet. I cant find the installation instructions. I have a small pool maybe 10000-12000 gal. View answer

Asked 5 ´years ago

Question 34

I have a limited length of 2" pipe to install the generator. What is the length of pipe needed to be cut out for install? Does the unit come with a cut template? View answer

Asked 5 ´years ago

Question 35

what type chlorinator with good warranty do you recommend for a freeform 10,000 gallon pool? You offer so many series. Thank you. View answer

Asked 4 ´years ago

Question 36

I set everything up and I cannot get any lights to come on

Asked 4 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 37

system error 5 & 6

Asked 3 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 38

CYA level ??? View answer

Asked 1 ´year ago

Question 39

Is there a reset button on the Edge unit? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 40

I see no wiring diagram in the instructions for a plug onto the edge control box View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > EDGE Series

Question 41

how to determine if edge 40 cell needs replacement View answer

Asked 2 ´years ago

Question 42

I have a 16,000 gallon above ground pool, will the Edge Series work? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > EDGE Series

Question 43

My pool holds 44,000 gal water. Which one do you recommend

Asked 4 ´months ago

Question 44

I want to replace my PureChlor generator with a CircuPool Edge 25. I would like to know the length of the cell, View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 45

CircuPool EDGE Series: No power, no lights coming on on panel, I have 115.3 VAC at power cord View answer

Asked 1 ´month ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 46

My edge 40 has stopped working after only 3 summers. Looks fine what's wrong View answer

Asked 1 ´month ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 47

What is the warranty on the chlorine generator View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 48

How long is the salt generator supposed to last? I just recently cleaned mine as instructed reinstalled and it stop View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 49

Edge controller not set to cell size View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > EDGE Series

Question 50

salt light flashing View answer

Asked 1 ´month ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

EDGE Series Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools