Asked 5 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources
What is the width of the salt cell? View answer
Asked 2 ´months ago
What are the CircuPool EDGE control module dimensions? View answer
Asked 3 ´years ago
How many titanium plates does this EDGE-40 cell have? View answer
Asked 3 ´years ago
sacrificial anode / cyanuric acid stabilizer level in pool? View answer
Asked 2 ´years ago
What's the ideal system setting for EDGE Series Salt System? View answer
Asked 2 ´years ago | Support
Why does the boost light flash on my edge pool generator? View answer
Asked 3 ´years ago
I have the Edge40. After a big rainstorm, the system told me that salt level was low. I added a few bags, and got it tested. Showings 4500 level. I had it running on high and boost for about 6 hours, yet my chlorine levels were still extremely low. I then cleaned the cell by the book and ran it again for a few hours with no change to chlorine levels. Still shows no chlorine when tested. I looked at the cell with a flashlight while it was running. I did see the electrolysis bubbles being formed. Yet after a few hours the chlorine levels did not rise. Please advise. View answer
Asked 4 ´years ago
How do I winterize with this system. View answer
Asked 4 ´years ago
I have a 10,000 gallon pool and want to convert to salt. So many questions. It's been 3 years since I drained and replaced 1/2 the water in the pool due to a repair. Should I consider a water replacement prior to conversion ? Under what circumstances should I consider water replacement? Money not an option...which model should I buy? What size? When does increase size not benefit performance for salt conversion power, cell cleaning cycle time, and cell life? Installation should not be a consideration as all would fit my system. Thank you, Bill View answer
Asked 3 ´years ago
What is the power draw on the Edge system? View answer
Asked 3 ´years ago
Who sells and installs the EDGE 25/40 in Orlando Florida Area? View answer
Asked 5 ´years ago
I am replacing a Hayward system. I will eventually replace the control panel also but for now need ot know if I need to purchase anything else to connect to the existing control panel. it has a plug that connects to it now. Do I need to purchase a separate plug to connect to the control panel? View answer
Asked 5 ´years ago
Can this be used for an 8’x8’ below ground hot tub? View answer
Asked 4 ´years ago
