Question 1

where is reset button located on rj 45? My serial number is 030255 View answer

Asked 3 ´years ago

Question 2

Does it need to be connected to 120v or 240v? View answer

Asked 3 ´years ago

Question 3

Can you use the flow switch from my Hayward system or do I have to change it? Also what would be the shipping time after I order? Universal 40 View answer

Asked 3 ´years ago

Question 4

Which replacement cartridge will this need? View answer

Asked 3 ´years ago

Question 5

How easy are is the SJ 35 to clean and how often does it need clening. View answer

Asked 3 ´years ago

Question 6

I have a rj 45 classic the it had on panel.power off and will not turn on will the key pad help this or do u need a whole new control panel View answer

Asked 3 ´years ago

Question 7

Do I need to install a check valve before the CORE35 to prevent superchlorinated water backflowing into my system when the pool pump is turned off? View answer

Asked 3 ´years ago

Question 8

I need two o rings for my salt cell connection RJ 45 View answer

Asked 3 ´years ago

Question 9

I reversed the cleaning amounts using more acid than water. Did i destroy the unit ? View answer

Asked 3 ´years ago

Question 10

Which direction does the flow switch face. With water flow holding the leg open that already stays open or against the water flow causing the leg to stay down. View answer

Asked 3 ´years ago

Question 11

Will the core55 fit right in the return line where the current Hayward CL200 3" tab chlorine is feeder is? Almost looks like it will. View answer

Asked 3 ´years ago

Question 12

The Core-55 capacity is listed at 2.3 lbs/day. Is the "day" in this calculation 24 hours of runtime will produce 2.3 lbs or is the number of hours smaller? I realize the 2.3 lbs is an approximation...just curious about the required runtime to get the output. View answer

Asked 3 ´years ago

Question 13

Can this replace my intellichlor ic60 or does it require replumbing? How soon can I get it? View answer

Asked 3 ´years ago

Question 14

I need replacement o- rings for this chlorinator. Do you sell then. and if so, how much are they? View answer

Asked 3 ´years ago

Question 15

I have a RJ60 since 2013, can I replace with a RJ45, my pool is 30,000 gallons. does not seem to be producing enough chlorine, but water is still cold 65 degrees. thanks View answer

Asked 3 ´years ago | Replacement Parts > Replacement Cells > RJ-Classic Replacement Cells

Question 16

We bought a T-9 chlorinator from you, and we need the o-rings for it. Do you have them, and how much are they? Thank you. View answer

Asked 3 ´years ago

Question 17

Is this the right flow switch for an RJ 60 ? View answer

Asked 3 ´years ago

Question 18

Can this be installed at a diagonally? View answer

Asked 3 ´years ago

Question 19

I’m thinking about changing over to a SWJ system, mainly due to issues with chlorine this year. Looking at a UL40.. 1) at 120v, how many amps does it pull? 2) does the plug in model need to be on a timer with the pump? Or is it smart enough to not work when there is no flow? 3) what are dimensions of the control box? View answer

Asked 3 ´years ago

Question 20

whats the difference between the core 35 and rj series? View answer

Asked 3 ´years ago

Question 21

What is the warranty? I don’t see any info here. View answer

Asked 3 ´years ago

Question 22

CircuPool product under serious consideration. Long time pool owner. 16x34 with diving end rectangular pool so I est. about 25,000 gals. DIY installation and controller can be in or out (exposed to all sun & elements). Can you suggest a good model for me? Thanks View answer

Asked 3 ´years ago

Question 23

Will this kit work OK when connected to 1 1/2 inc h PVC? View answer

Asked 3 ´years ago

Question 24

Can this be used as an initial conversion kit? Meaning I don't have a salt system can I install this product? Thanks View answer

Asked 3 ´years ago

Question 25

What is the optimum Salt content for this unit. I think its referred to as Parts per million (PPM) Thank You View answer

Asked 3 ´years ago

Question 26

When will SJ-20 system be available? View answer

Asked 3 ´years ago

Question 27

The description says this can be installed horizontally or vertically but then the website shows a ventricle installation kit. Does this mean the unit as purchased cannot be installed vertically out of the box? View answer

Asked 3 ´years ago

Question 28

What's the minimum flow required for the Core55? I'm currently at 1700rpm and seeing the no flow light? Any ideas? View answer

Asked 3 ´years ago

Question 29

Are these in stock? My pool is only 8800 gallons. I don’t need the next size up. View answer

Asked 3 ´years ago

Question 30

Hi, Can I use this with my existing pool pump? Do you have it in stock? View answer

Asked 3 ´years ago

Question 31

Is the Si-45 the proper replacement for my Si+ cell? View answer

Asked 3 ´years ago

Question 32

Is this compatible with a Hayward T-cell 5? View answer

Asked 3 ´years ago

Question 33

what are the connection measurements, ie., length, dia. Where does the salt supply go and how long does it last. View answer

Asked 3 ´years ago

Question 34

When its generating how do you know its producing View answer

Asked 3 ´years ago

Question 35

Is this system compatible to replace a compuclor? View answer

Asked 3 ´years ago

Question 36

I purchased a SJ-20 (from Amazon, hasn't arrived yet) it was a panic buy, only nine left yada yada, no chlorine available locally. but I realize now that the unit will likely be undersized as my pool is 30000 gallons. they didn't indicate volume or capacity and I did not find you website until after i made the purchase. So am i wasting my time with this unit or do I have any recourse ( upgrade path? bigger cell etc.) any input would be appreciated. View answer

Asked 3 ´years ago

Question 37

What is the minimum GPM flow rate required for the Core series? View answer

Asked 3 ´years ago

Question 38

Does this item come with an o-ring? View answer

Asked 3 ´years ago

Question 39

Does the control module have to be covered or is it waterproof? View answer

Asked 3 ´years ago

Question 40

I have an RJ with 5 plates can you tell me what size that is View answer

Asked 3 ´years ago

Question 41

What is the correct cell code for the SI-60 cell View answer

Asked 3 ´years ago

Question 42

How can I tell what my salinity level is on the Core35 unit? View answer

Asked 3 ´years ago

Question 43

I'm installing a 16x32 inground pool, approx 30,000 gallons. Instead of a chlorine pool, I'd like to make it salt water and looking at this unit. Will this suffice my pool size. No pump, filter are installed yet so now is the time for me to make this decision. View answer

Asked 3 ´years ago

Question 44

How often do you have to replace the salt cells? I see no mention of longevity View answer

Asked 3 ´years ago

Question 45

What’s are the measurements of this filter? View answer

Asked 3 ´years ago

Question 46

Do you have this in stock....it says call for availability.....if you don't have it will a SJ-40 work with my system? View answer

Asked 3 ´years ago

Question 47

I am looking at ordering an Rj-30 plus does this run on 110 or 220 voltage or both? View answer

Asked 3 ´years ago

Question 48

How long is the power cord? View answer

Asked 3 ´years ago

Question 49

I replaced my cell a few years ago, now it reads either low salt or no water. I took a sample to my local pools supply store to have the water tested as I have been adding salt. Their testing showed I have around 10000 ppm. Is my cell bad? View answer

Asked 3 ´years ago | Replacement Parts > Replacement Cells > RJ-Classic Replacement Cells

Question 50

I have a Hayward turbo cell tcell925. Extended life. (I'm reading right off of the Tcell). Is this the correct replacement for mine? View answer

Asked 3 ´years ago

Browse by Topic

Tools