CircuPool CORE Series Salt Chlorine GeneratorsOwner Resources Questions & Answers

On CORE salt chlorinators, why is the third light not on and the fourth light is flashing for the chlorine output lights on the controller View answer

Asked 2 ´months ago

How to clean salt cell on CircuPool CORE? View answer

Asked 3 ´years ago

How do I clean the CircuPool CORE salt cell? View answer

Asked 19 ´days ago

Can I replace a CircuPool core 55 cell with a core 35 replacement cell? View answer

Asked 1 ´month ago

does the direction of flow matter when installing my Circupool core55 View answer

Asked 2 ´months ago

What is the expected lifespan of the CORE55 Replacement Cell. How does the eight year warranty impact the cost of replacing the cell if it applies at all? View answer

Asked 4 ´years ago

I have a core 55 salt cell and the plastic housing has cracked and I wanted a replacement plastic housing that h View answer

Asked 7 ´days ago

can you use the core 55 with 1.5 inch pvc plumbing that exists? thanks View answer

Asked 3 ´years ago

How long is the power cord? View answer

Asked 5 ´years ago

where does the large O-ring go on the Core55 Salt chlorinator? Is there an illustration? View answer

Asked 1 ´year ago

Does the power turn off to the plates when pump is off and it says no flow View answer

Asked 4 ´years ago

When I winterize the pool, do I need to do anything different now that I have a CircuPool CORE salt chlorine generator on my pool?? View answer

Asked 3 ´years ago

WiFi issues

Asked 3 ´months ago

Chlorine output led blinking constantly and cannot change settings View answer

Asked 1 ´year ago

I have a Solaxx Purechlor CLG140A-010 salt cell. Do I need a plumbing adapter like for the Hayward? View answer

Asked 3 ´years ago

How do I change power setting? View answer

Asked 1 ´year ago

Is there a warranty on the CircuPool CORE salt system? View answer

Asked 1 ´year ago

How do you configure your CircuPool CORE Series Salt Chlorinator to accept a particular voltage? View answer

Asked 2 ´years ago

Are the pipe fittings the same with the new Core as prior generation Core? View answer

Asked 2 ´years ago

Unit will not power up….no lights at all View answer

Asked 3 ´years ago

What steps to replace the temperature sensor on CircuPool CORE Series, or should I contact circupool customer service? View answer

Asked 2 ´months ago

do you need to shock treat a pool with this Unit? Should non-chlorine shock be used? How often? View answer

Asked 5 ´years ago

I have your older model CircuPool core system 60 (core55) i need a cell for it View answer

Asked 1 ´month ago

CircuPool Core Salt Chlorinator doesnt turn on. View answer

Asked 2 ´years ago

sacrificial anode / cyanuric acid stabilizer level in pool? View answer

Asked 3 ´years ago

I cleaned the cell but the clean cell light is still on View answer

Asked 2 ´years ago

Can the core 35 be rewired for a 240 volt connection View answer

Asked 1 ´year ago

install View answer

Asked 5 ´months ago

How does direct sunlight for most of the day affect the control unit? View answer

Asked 4 ´years ago

I just bought a core 35 and will turn it on tomorrow. View answer

Asked 1 ´year ago

Is the flow switch in the CircuPool CORE Series usable as an on/off switch? View answer

Asked 2 ´months ago

Young device, low output View answer

Asked 1 ´year ago

I have to remove my core 35. Can I install these with a piece of PVC pipe until the Core 35 is checked out? View answer

Asked 4 ´years ago

No Flow View answer

Asked 1 ´month ago

the manual says to not put chemicals directly into the skimmers View answer

Asked 3 ´years ago

When to use turbo? Is it necessary to use turbo for 24 hours every time it rains? View answer

Asked 2 ´years ago

Controller orientation View answer

Asked 3 ´years ago

Hi, our CORE unit shows 'low temp' at 86°F. Please advise. View answer

Asked 2 ´years ago

I meant to click the box for 1 1/2 in reducers when I purchased the Core 55 last week. I've looked on the site, but I don't see them separately. Is there a way I can get these now? thanks, Patrick Smith View answer

Asked 5 ´years ago

Does the CORE55 control need to be protected from sunlight? View answer

Asked 5 ´years ago

DOES THE NO FLOW LIGHT STAY ON WHEN THE PUMP IS OFF? IF SO, HOW LONG? WILL I HAVE TO MANUALLY TURN IT OFF EVERY DAY? View answer

Asked 6 ´years ago

Is it ok for the chlorine generator to stay powered on 24 hours a day while the pool pump only runs about 10 hours? View answer

Asked 2 ´years ago

My cold water light stays on. The water temp is above 80 and has been for some time now. View answer

Asked 1 ´year ago

Can I run the system without a salt cell attached? View answer

Asked 2 ´years ago

Low water sensor fault?

Asked 3 ´months ago

Fault light on but no code View answer

Asked 10 ´days ago

CYA level ??? View answer

Asked 1 ´year ago

I have a standard salt cell system, will the Core salt system fit in the same pool line cut out? View answer

Asked 1 ´year ago

Should I clean the electrolytic before the clean cell light is illuminated. View answer

Asked 1 ´year ago

What's the ideal system setting for CORE Series Salt System? View answer

Asked 3 ´years ago | Support

CircuPool CORE Series Salt Chlorine Generators - Owner Resources Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools