CORE Series Q&A

Question 1

My cold water light stays on. The water temp is above 80 and has been for some time now. View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 2

What kind of acid to clean cell View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 3

This says it can produce up to 1.4 lbs of chlorine per day. Would this be assuming it is running at 100% output for 24 hours? Just trying to figure out my run time and output settings. Last year I was using about a 1/2 pound to 3/4 pound of chlorine per day before I installed this salt cell View answer

Asked 4 ´years ago

Question 4

When to use turbo? Is it necessary to use turbo for 24 hours every time it rains? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 5

my cell is 3 years old and the unit says cell life low View answer

Asked 2 ´years ago

Question 6

Is it ok for the chlorine generator to stay powered on 24 hours a day while the pool pump only runs about 10 hours? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 7

What is the return policy? View answers

Asked 1 ´year ago

Question 8

I love my salt chlorine generator but I use a lot of acid for the pH. Is this caused by it generating chlorine? View answer

Asked 2 ´years ago

Question 9

I have a variable speed pump. The question is, when I am at the low speed I suspect the flow will not be enough for the flow switch to read so it will not produce salt. Is this correct? Will this harm the system?If I purchase this my plan is to set the pump speeds to get the chlorine level I need. Pool is 15000 gallons View answer

Asked 3 ´years ago

Question 10

Unit will not power up….no lights at all View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 11

Can I run the system without a salt cell attached? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 12

when there is no electricity, will the device return to work after the power is restored? View answer

Asked 3 ´years ago

Question 13

How long does the circupool core35's cell last? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 14

Does the CircuPool CORE35 salt system need professional installation? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 15

Can I use a copper-based algaecide in my pool? View answer

Asked 8 ´months ago

Question 16

Does the CORE 35 have to be connected to a timer? View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 17

Salt level is normal but chlorine level is low. What can cause this? View answer

Asked 7 ´months ago

Question 18

I see the flow switch is integrated into the replaceable cell. Can it be repaired without replacing the entire cell? It seems flow switches are the weakest link with Pentair. While I like this system, I'm a little apprehensive. View answer

Asked 4 ´years ago

Question 19

No power View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 20

Cold water light on View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 21

How to handle warranty claims for a CircuPool CORE Salt Chlorinator? View answer

Asked 11 ´months ago

Question 22

What is the power of the CircuPool CORE35 salt system? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 23

CORE55 has 55000 hour lifespan and the RJ-60 is only 15000 are they rated the same? Will CORE55 last 3 times more? View answer

Asked 2 ´years ago

Question 24

Hello, What is the minimum flow rate (GPM) for operation for the CircuPool Core series? I currently have a Jandy VSP pump that I run at 1200 rpms that generates 22 gpm. Would the Chlorinator work at this low flow rate? Thanks in advance for your assistance. Have a GREAT Day. Regards, Eric Brown View answer

Asked 3 ´years ago

Question 25

How does direct sunlight for most of the day affect the control unit? View answer

Asked 3 ´years ago

Question 26

Where do I find the serial number for CORE55 View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 27

How often does the electrolytic cell need to be replaced? View answer

Asked 3 ´years ago

Question 28

Do you sell a “dummy cell” for CORE 35 View answer

Asked 6 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 29

Core35 warranty 8 year limited. What is covered? View answer

Asked 4 ´years ago

Question 30

Can I wire the Core35 to my pool pump wiring, so power is provided only when the pump is running? View answer

Asked 1 ´year ago

Question 31

How do you claim a warranty on my CircuPool equipment? View answer

Asked 3 ´years ago

Question 32

Why is my low salt light on when my salt content is 3600 ppm View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 33

Do I need to remove electrode and control unit when winterizing in the Northeast area? View answer

Asked 1 ´year ago

Question 34

What size PVC pipe does this fit? My plumbing is 1.5" View answer

Asked 4 ´years ago

Question 35

I have a Core 35 that was bought in April 2022, and the System Error light keeps blinking. View answer

Asked 1 ´year ago

Question 36

I have a variable speed pump and I'm curious, what is the minimum water flow in GPM for the CORE series? View answer

Asked 3 ´years ago

Question 37

Salt low sensor lit but salinity measures 3800. Cell has been cleaned but still get error code. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 38

I would like to confirm that the Core55 can be connected to an Pentair EasyTouch and IntelliTouch Pool and Spa System as I believe it can. Will the unit work? View answer

Asked 3 ´years ago

Question 39

Where can I find the CircuPool serial number on my equipment?? View answer

Asked 2 ´years ago

Question 40

DOES THE NO FLOW LIGHT STAY ON WHEN THE PUMP IS OFF? IF SO, HOW LONG? WILL I HAVE TO MANUALLY TURN IT OFF EVERY DAY? View answer

Asked 5 ´years ago

Question 41

Is the flow through the cell directional? Does it matter which way I install it? View answer

Asked 4 ´years ago

Question 42

I have a core35. Is it necessary to remove the head for winter? Will this cap fit? View answer

Asked 4 ´years ago

Question 43

What size salt system do I need for my pool? View answer

Asked 1 ´year ago

Question 44

How do you winterize the unit? View answer

Asked 4 ´years ago

Question 45

Hello, I'd like to connect a CORE35 onto 1.5 inch pvc pipe. Do I need the 1.5" reducer ? Just want to double check. Thanks, Dave View answer

Asked 3 ´years ago

Question 46

What are the controls on the CircuPool CORE35 salt system? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 47

What is the length of the power cord for the CircuPool CORE35 salt system? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 48

What is the manufacturer warranty for the CircuPool CORE35 salt system? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 49

What is the salinity range for the CircuPool CORE35 salt system? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 50

Is there a salinity test in the CircuPool CORE35 salt system? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

CORE Series Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools