Question 1

Where do you install the cartridge-looking device... On the intake line or the outflow (back to the pool) line? View answer

Asked 4 ´years ago

Question 2

I have a 5 plus year old SI45 now. I have replaced the cell and now it is blowing the fuse on the main panel. I’m not sure what the cost is to replace the main board or if I should purchase this new unit. Thoughts? View answer

Asked 4 ´years ago

Question 3

When do you know it's time to replace an old system? I have a CircuPool Si Series , 8 yrs old this past March, (salt). Can it be replaced with this one? View answer

Asked 4 ´years ago

Question 4

Can the RJ+ salt cell be installed vertically? View answer

Asked 2 ´years ago

Question 5

How long will the cell last before it needs to be replaced? View answer

Asked 3 ´years ago

Question 6

on the rj-45 does the 7 year warranty cover the cell? View answer

Asked 2 ´months ago

Question 7

Is the flow through the cell directional? Does it matter which way I install it? View answer

Asked 5 ´years ago

Question 8

Can I install my Edge40 in a vertical return line? View answer

Asked 2 ´months ago | Replacement Cells > EDGE-Series Replacement Cells

Question 9

unit says low salt but salt is high View answer

Asked 11 ´months ago

Question 10

how long does the edge 15 need to be run to meet the advertised chlorine rate per day? View answer

Asked 4 ´years ago

Question 11

Touch panel not working

Asked 7 ´days ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 12

I installed new Gen 15+ cell and my Hayward board fried. Set to 15, worked for a few mins, then blew the board.

Asked 2 ´months ago | Replacement Cells > Aftermarket Replacement Cells <span>fitting Hayward® / Goldline®</span> > CircuPool GEN-Series Aftermarket Replacement Cells - Owner Resources

Question 13

what type chlorinator with good warranty do you recommend for a freeform 10,000 gallon pool? You offer so many series. Thank you. View answer

Asked 4 ´years ago

Question 14

The valve on the bypass seems counterintuitive. When in bypass, a small amount of DE goes into the cyclone.

Asked 2 ´months ago

Question 15

When will your new pumps be available, and what are the differences? View answer

Asked 4 ´months ago

Question 16

I am looking to use the TJ16 cyclonic pool prefilter on my home due to sand/sediment. Will it work for that? View answer

Asked 4 ´months ago | Filters > CircuPool® TJ-16 Typhoon Pre-Filter

Question 17

I have a limited length of 2" pipe to install the generator. What is the length of pipe needed to be cut out for install? Does the unit come with a cut template? View answer

Asked 5 ´years ago

Question 18

Does this fit on the circupool universal25 salt chlorine generator? View answer

Asked 4 ´years ago

Question 19

Salt cell replacement View answer

Asked 2 ´months ago | Replacement Cells > Aftermarket Replacement Cells <span>fitting Hayward® / Goldline®</span>

Question 20

Is this the Part that the ORing fits into? View answer

Asked 4 ´years ago

Question 21

Why doesn’t generator work when water temp is 45 degrees View answer

Asked 4 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 22

Can this be used for an 8’x8’ below ground hot tub? View answer

Asked 4 ´years ago

Question 23

will this fit the sj-15 salt cell . The one that holds the cell .with the cord to the clear plastic housing. my blue collar has a crack in it View answer

Asked 5 ´years ago

Question 24

What is an Adaptive Flow Pump? View answer

Asked 3 ´months ago | CircuPool SmartFlo Adaptive Flow™ Pump | 1.3 THP | Variable-Speed Pool Pumps with Target Flow Control

Question 25

I have a 10,000 gallon pool and want to convert to salt. So many questions. It's been 3 years since I drained and replaced 1/2 the water in the pool due to a repair. Should I consider a water replacement prior to conversion ? Under what circumstances should I consider water replacement? Money not an option...which model should I buy? What size? When does increase size not benefit performance for salt conversion power, cell cleaning cycle time, and cell life? Installation should not be a consideration as all would fit my system. Thank you, Bill View answer

Asked 3 ´years ago

Question 26

My display is not accurately forming alphanumeric symbols and twitching, not generating either. What does it need? View answer

Asked 2 ´years ago

Question 27

RJ PLUS Keypad View answer

Asked 1 ´year ago

Question 28

Can the CORE 55 be plugged in constantly without problems? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 29

I have a variable speed pump with its own timer. Can I leave the salt generator on all the time? Will it run only when it senses water flow with the flow sensor? View answer

Asked 4 ´years ago

Question 30

My flow sensor has failed! Now can I replace just the flow sensor w/out cutting any PVC pipe? View answer

Asked 3 ´years ago | CircuPool® Flow Switch / Temperature Sensor (No PVC Tee Fitting)

Question 31

Can rj60 be powered from pentair intelliflo3 vsp built in 5 amp relay View answer

Asked 1 ´year ago | Support

Question 32

Can I install replacement cell from an SJ-35 into my SJ-20 so that I get more blades and more chlorine capacity? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series

Question 33

Is the replacement cell for the SJA 20 covered by the warranty? I purchased this in 2021 View answer

Asked 10 ´months ago

Question 34

No flow View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 35

Just started recently, when the unit first turns on, it hums and vibrates. View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 36

Why not sell the flow switch with the Tee? But you you show the sensor with the tee to sell the sensor. View answer

Asked 2 ´years ago

Question 37

I have an RJ-45 that has been working fine for about 2 years but now indicated "Cell Connect". View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 38

What the difference between the PVC Tee fitting and the flow switch housing? View answer

Asked 2 ´years ago | CircuPool EDGE Flow/Temperature Sensor PVC T-Fitting

Question 39

Will this replace an Astral E35 salt chlorine generator cell? View answer

Asked 1 ´year ago | Replacement Cells > RJ-Classic Replacement Cells

Question 40

How many hrs a day should it run for optimal chlorine generation? View answer

Asked 2 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 41

Do I need to register for the warranty? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 42

Where does the print go on the winter cap. It seems to be placed on the top and outside of cap but it leaks. So should it be on the inside when installing View answer

Asked 4 ´years ago

Question 43

Which terminal on the circuit board does the blue wire connect too ? Foolish me forgot to mark it when removing. View answer

Asked 5 ´years ago

Question 44

How should the SJ-A Control Module unit be wired? View answer

Asked 3 ´years ago

Question 45

Does the control box on CORE series salt systems separate from the chlorinator, for descaling View answer

Asked 3 ´years ago

Question 46

will this system do a 30,000 gallon pool? im trying to convert from fresh water to salt water with this system. View answer

Asked 3 ´years ago | Packages > CircuPool® Ultimate Combo (Salt Chlorinator + Pump + Filtration)

Question 47

Is this the ORing that goes in the Union Nut to seal against the Face of the Generator? View answer

Asked 4 ´years ago

Question 48

Can you tell me which replacement cell I ordered last? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 49

Please can you provide a technical drawing for this. Looking to replace a Surechlor 3000 SC210 and need to compare sizes/threads/fittings etc. thanks in advance, Gary View answer

Asked 3 ´years ago

Question 50

Is this female to female View answer

Asked 2 ´years ago | Replacement Parts > Parts & Accessories > CORE Models > CircuPool CORE 2-in Union Set (Unions plus Collars)

Browse by Topic

Tools