CircuPool CORE Series Salt Chlorine GeneratorsOwner Resources Questions & Answers

When I winterize the pool, do I need to do anything different now that I have a CircuPool CORE salt chlorine generator on my pool?? View answer

Asked 3 ´years ago

sacrificial anode / cyanuric acid stabilizer level in pool? View answer

Asked 3 ´years ago

How to clean salt cell on CircuPool CORE? View answer

Asked 3 ´years ago

Is there a warranty on the CircuPool CORE salt system? View answer

Asked 1 ´year ago

Is the flow through the cell directional? Does it matter which way I install it? View answer

Asked 5 ´years ago

Why is my low salt light on when my salt content is 3600 ppm View answer

Asked 1 ´year ago

the salt cell will not come out of the housing circupool core 35 View answer

Asked 19 ´days ago | Support

My cold water light stays on. The water temp is above 80 and has been for some time now. View answer

Asked 1 ´year ago

Is it ok for the chlorine generator to stay powered on 24 hours a day while the pool pump only runs about 10 hours? View answer

Asked 2 ´years ago

What steps to replace the temperature sensor on CircuPool CORE Series, or should I contact circupool customer service? View answer

Asked 23 ´days ago

no power how to replace fuse

Asked 1 ´month ago

Where can I find the CircuPool serial number on my equipment?? View answer

Asked 2 ´years ago

Do I need to register my new system and if so, where do I register it at? View answer

Asked 2 ´years ago

my cell is 3 years old and the unit says cell life low View answer

Asked 3 ´years ago

How do you remove the cell from Control Module View answer

Asked 2 ´years ago

On CORE salt chlorinators, why is the third light not on and the fourth light is flashing for the chlorine output lights on the controller View answer

Asked 23 ´days ago

I have a Solaxx Purechlor CLG140A-010 salt cell. Do I need a plumbing adapter like for the Hayward? View answer

Asked 3 ´years ago

CircuPool Core Salt Chlorinator doesnt turn on. View answer

Asked 2 ´years ago

Can the flow switch be installed vertically while the CORE will be horizontal? View answer

Asked 2 ´years ago | Support

Do I need to install a check valve before the CORE35 to prevent superchlorinated water backflowing into my system when the pool pump is turned off? View answer

Asked 5 ´years ago

do you need to shock treat a pool with this Unit? Should non-chlorine shock be used? How often? View answer

Asked 5 ´years ago

Can I run the system without a salt cell attached? View answer

Asked 2 ´years ago

I have a Core 35 that was bought in April 2022, and the System Error light keeps blinking. View answer

Asked 1 ´year ago

I have flow on my core 55 but the unit is indicating no flow. Checked by hand but still has an error. View answer

Asked 4 ´months ago

To prolong the life of a salt water chlorine generator's cell, would it be better to run the pool system at 25% for 24 hrs., 50% for 12 hrs. or 100% 6 hrs View answer

Asked 14 ´days ago

How do you claim a warranty on my CircuPool equipment? View answer

Asked 3 ´years ago

Reset Button View answer

Asked 1 ´year ago

Can I use a Core35 or an Edge 25 on a 5000 gallon pool? View answer

Asked 2 ´years ago

I have a 40 and need a new core but do not see a 40 just above and below that. What do you replace it with? View answer

Asked 2 ´months ago

Cold water indicator is on when water is not cold View answer

Asked 2 ´years ago

How do I get in contact with customer service. The number posted says "operations were down call back in a little.

Asked 2 ´months ago

Keep getting a System fault error View answer

Asked 1 ´year ago

What kind of acid to clean cell View answer

Asked 2 ´years ago

When to use turbo? Is it necessary to use turbo for 24 hours every time it rains? View answer

Asked 2 ´years ago

What size salt system do I need for my pool? View answer

Asked 2 ´years ago

My new replacement cell for CORE55 arrived with grease covering the connector pins View answers

Asked 3 ´months ago

How much straight pipe distance is needed between the chlorinator and the filter head to get even water flow? View answer

Asked 4 ´months ago

Will the Core35 fit in the space left by my Hayward T15 cell? View answer

Asked 2 ´years ago

I have no power at the unit, no lights on will not power on, outlet is functioning

Asked 1 ´month ago

Got power, but generator won't come on. Is there a fuse that can be replaced. Only 2 years old.

Asked 1 ´month ago

Does the CORE 35 have to be connected to a timer? View answer

Asked 1 ´year ago

Can I use a copper-based algaecide in my pool? View answer

Asked 1 ´year ago

I cleaned the cell but the clean cell light is still on View answer

Asked 2 ´years ago

Low water sensor fault?

Asked 29 ´days ago

No power View answer

Asked 1 ´year ago

CYA level ??? View answer

Asked 1 ´year ago

can you use the core 55 with 1.5 inch pvc plumbing that exists? thanks View answer

Asked 3 ´years ago

I installed my system last march, just over a year ago, and my system is already saying cell life low. View answer

Asked 1 ´year ago

How long does it take for the salty water taste to go away ? View answer

Asked 1 ´year ago

How often is my salt cell supposed to be cleaned? View answer

Asked 23 ´days ago

CircuPool CORE Series Salt Chlorine Generators - Owner Resources Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools