CORE Series Q&A

Question 1

Is it ok for the chlorine generator to stay powered on 24 hours a day while the pool pump only runs about 10 hours? View answer

Asked 8 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 2

I have a variable speed pump. The question is, when I am at the low speed I suspect the flow will not be enough for the flow switch to read so it will not produce salt. Is this correct? Will this harm the system?If I purchase this my plan is to set the pump speeds to get the chlorine level I need. Pool is 15000 gallons View answer

Asked 2 ´years ago

Question 3

How to clean salt cell on CircuPool CORE? View answer

Asked 2 ´years ago

Question 4

Can I wire the Core35 to my pool pump wiring, so power is provided only when the pump is running? View answer

Asked 10 ´months ago

Question 5

How do you remove the cell from Control Module View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 6

Are you sure I can't put my swcg before the heater? View answer

Asked 2 ´years ago | Support

Question 7

Where can I find the CircuPool serial number on my equipment?? View answer

Asked 1 ´year ago

Question 8

Will this unit work better off of 120 or 240volts View answer

Asked 2 ´years ago

Question 9

Is the flow through the cell directional? Does it matter which way I install it? View answer

Asked 4 ´years ago

Question 10

My CircuPool CORE 35 that is about 3 years old, has a System Error light on. What do I do? View answer

Asked 8 ´months ago

Question 11

Unit will not power up….no lights at all View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 12

What's the minimum flow required for the Core55? I'm currently at 1700rpm and seeing the no flow light? Any ideas? View answer

Asked 3 ´years ago

Question 13

Salt low sensor lit but salinity measures 3800. Cell has been cleaned but still get error code. View answer

Asked 11 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 14

I love my salt chlorine generator but I use a lot of acid for the pH. Is this caused by it generating chlorine? View answer

Asked 1 ´year ago

Question 15

Cold water indicator is on when water is not cold View answer

Asked 9 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 16

CORE55 has 55000 hour lifespan and the RJ-60 is only 15000 are they rated the same? Will CORE55 last 3 times more? View answer

Asked 1 ´year ago

Question 17

I have a CORE55. I remove it when I close the pool for the winter. I live in New Hampshire. How do I store it. View answer

Asked 9 ´months ago

Question 18

Does this core35 fit an older version (2021) Core35 chlorine generator? View answer

Asked 1 ´year ago

Question 19

What kind of acid to clean cell View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 20

Is it possible to plug in the CORE to a timer which then regulates when the CORE turns on and off? View answer

Asked 11 ´months ago | Support

Question 21

CircuPool Core Salt Chlorinator doesnt turn on. View answer

Asked 11 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 22

The Core-55 capacity is listed at 2.3 lbs/day. Is the "day" in this calculation 24 hours of runtime will produce 2.3 lbs or is the number of hours smaller? I realize the 2.3 lbs is an approximation...just curious about the required runtime to get the output. View answer

Asked 3 ´years ago

Question 23

Hello, What is the minimum flow rate (GPM) for operation for the CircuPool Core series? I currently have a Jandy VSP pump that I run at 1200 rpms that generates 22 gpm. Would the Chlorinator work at this low flow rate? Thanks in advance for your assistance. Have a GREAT Day. Regards, Eric Brown View answer

Asked 2 ´years ago

Question 24

How long does the circupool core35's cell last? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 25

This says it can produce up to 1.4 lbs of chlorine per day. Would this be assuming it is running at 100% output for 24 hours? Just trying to figure out my run time and output settings. Last year I was using about a 1/2 pound to 3/4 pound of chlorine per day before I installed this salt cell View answer

Asked 3 ´years ago

Question 26

What is the power of the CircuPool CORE35 salt system? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE35 Salt Chlorine Generator

Question 27

What is the return policy? View answers

Asked 11 ´months ago

Question 28

Does the control box on CORE series salt systems separate from the chlorinator, for descaling View answer

Asked 2 ´years ago

Question 29

How do you claim a warranty on my CircuPool equipment? View answer

Asked 2 ´years ago

Question 30

What would be the preferred operating setup (to promote cell life): 12 hours at 25% output or 6 hours at 50%? View answer

Asked 11 ´months ago

Question 31

I meant to click the box for 1 1/2 in reducers when I purchased the Core 55 last week. I've looked on the site, but I don't see them separately. Is there a way I can get these now? thanks, Patrick Smith View answer

Asked 3 ´years ago

Question 32

DOES THE NO FLOW LIGHT STAY ON WHEN THE PUMP IS OFF? IF SO, HOW LONG? WILL I HAVE TO MANUALLY TURN IT OFF EVERY DAY? View answer

Asked 4 ´years ago

Question 33

Can this be left to plug-in? The outlet at my pump box is not on the timer but the pump is on a timer. Or do I need to add a timer to the outlet? View answer

Asked 3 ´years ago

Question 34

when cell is needing replace do you replace the entire unit View answer

Asked 4 ´years ago

Question 35

can i mount the core 35 vertical View answer

Asked 1 ´year ago

Question 36

Will I have to add salt to the pool at installation? If so how much salt do I add to a 20,000 gal pool at the beginning View answer

Asked 3 ´years ago

Question 37

Does the unit stop making chlorine when the water temperature drops? My cold water light is on and it doesn't seem to be making any chlorine. If it stop, what is the temperature range for it to work? View answer

Asked 3 ´years ago

Question 38

What is the return policy if the cell is not the fix and I need to buy another complete system? View answer

Asked 10 ´months ago

Question 39

I have a Hayward pump, will the CircuPool CORE 55 work with this pump? View answer

Asked 10 ´months ago

Question 40

can i use core55 with 25000 gal. pool? View answer

Asked 2 ´years ago | Sales

Question 41

What do I do when it says "salt cell low" View answer

Asked 2 ´years ago

Question 42

Do you need to connect to a timer or will it turn on automatically when the pool pump is running while connected to the 110v outlet? View answer

Asked 4 ´years ago

Question 43

Is your system all I need in addition to my pump and filter? View answer

Asked 9 ´months ago

Question 44

What is the minimum GPM flow rate required for the Core series? View answer

Asked 3 ´years ago

Question 45

I have a 21600 gallons inground pool , What would be the best suitable model salt chlorine generator? View answer

Asked 3 ´years ago

Question 46

If I currently have a Hayward Aquarite, do I need the adapter or will the Core35 fit where my cell is now? View answer

Asked 2 ´years ago

Question 47

can you ship to jamaica? View answer

Asked 1 ´year ago

Question 48

How long is the power cord? View answer

Asked 3 ´years ago

Question 49

Can I program the hours of operation? View answer

Asked 9 ´months ago

Question 50

I just got the Core35 model. Can you leave the unit on even if the pool pump is not running since I don't have a timer? View answer

Asked 3 ´years ago

CORE Series Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools