RJ PLUS Series Q&A

Question 1

How often do you have to replace the salt cells? I see no mention of longevity View answer

Asked 4 ´years ago

Question 2

Do you offer extensions/adapters for the rj cell to connect to the power supply box? My power wall is about 6 feet farther than the provided cables length. Can I use a standard adapter to extend this? View answer

Asked 4 ´years ago

Question 3

What determins when your RJ+45 Series" goes into it's "REST Cycle"? View answer

Asked 5 ´years ago

Question 4

What is the max amp draw of this unit? I am trying to decide if I should add it to my pump circuit or add a new circuit and if the latter than size the circuit. View answer

Asked 3 ´years ago

Question 5

What are the dimensions of the RJ-45 cell and flow switch? I need to confirm if I have enough piping. Thank you View answer

Asked 3 ´years ago

Question 6

What size unit would I need for 18,000 pool 16 x 32 8 ft deep end 4 ft shallow View answer

Asked 3 ´years ago

Question 7

What size do I go with? My pool is 18 by 36 inground with a 4 foot shallow end and 9 feet in deep end which is gradual. Why would I choose one system over another?? What are your recommendations? I do not currently have a salt system View answer

Asked 3 ´years ago

Question 8

1. On my screen it says power 50% it will not go higher. Is this because the water temp is less than 60 degrees. 2. Will it go higher when the water temp goes up View answer

Asked 4 ´years ago

Question 9

I have a 25000 gal. Gunite pool and live in Maryland. Would you recommend the 40 or 65 model for maximum efficiency. Also can the control panel be mounted outside and is it waterproof View answer

Asked 3 ´years ago

Question 10

Can the RJ series be run on a above ground pool? If so can it be run vertically similar to the same way the Hayward Aqutrol RJ model which ties connected directly to the return jet? Thanks for any info View answer

Asked 6 ´years ago

Question 11

I have 1 -1/2" pipe 44gpm Hayward filter and Hayward pool heater. Will this work easily with these things?? View answer

Asked 3 ´years ago

Question 12

Universal 40 VS RJ45 Are they both titanium? I’m replacing a Hayward gold line controller and cell . Are the cell lengths the same on both Thanks View answer

Asked 4 ´years ago

Question 13

I am replacing a rj30. Is the control mounting bracket the same? View answer

Asked 4 ´years ago

Question 14

Is there a specific flow direction for the RJ-45 plus electric cell? View answer

Asked 4 ´years ago

Question 15

Does it need to be connected to 120v or 240v? View answer

Asked 4 ´years ago

Question 16

I am looking at ordering an Rj-30 plus does this run on 110 or 220 voltage or both? View answer

Asked 4 ´years ago

Question 17

I see the electronics are different, but is the cell physically the same length at the Hayward, making the plumbing upgrade a piece of cake? View answer

Asked 4 ´years ago

Question 18

What is the recommended GPM flow for the RJ45 system, Core35, and Core55 systems? View answer

Asked 4 ´years ago

Question 19

What is the grams per hour output of the RJ45? View answer

Asked 5 ´years ago

Question 20

Does the RJ45 refer to pool size (45,000 Ga's) or does the 45 represent the element output in grams per hour? View answer

Asked 5 ´years ago

Question 21

What are the dimensions of the electronics box? Does it have a door that has to be swung open? I am concerned about clearances. I now have a Hayward box. View answer

Asked 6 ´years ago

Question 22

I have an RJ-30 Plus system. What is the effect of Cell Version setting on the Menu? Each numerical value also has a '+' and '-'. What does this do to the operation of the system? This is not mentioned anywhere in the manual. View answer

Asked 3 ´years ago

Question 23

I am getting ready to install this unit but may have to install it vertically. What, if anything, do I need to do to insure the system works properly? Thanks, Marty View answer

Asked 4 ´years ago

Question 24

Just purchased RJ30. Was told it is a self cleaning unit utilizing revers polarity. How do I know when it is in cleaning mode? View answer

Asked 6 ´years ago

Question 25

I bough the RJ -30 system April 2016 and I would like to know if there is a way to tell if it is still putting out as much chlorine as it was designed to? View answer

Asked 6 ´years ago

Question 26

I currently have an RG 30 but it doesn’t seem to be reading the salinity levels correctly. I’m wondering if I need to purchase a separate new cell. If so how much would it be?Many thanks Jeff View answer

Asked 2 ´years ago

Question 27

Do you offer a military discount? View answer

Asked 3 ´years ago

Question 28

I have a 15 x 32 18200 gallon pool. I have small children and occasionally have pool partya with 20+ people in the pool. I also live near trees that constantly release leaves on to the pool. Thousands in a day. Would this system be able to handle these conditions? View answer

Asked 3 ´years ago

Question 29

Does this work for above ground pool View answer

Asked 3 ´years ago

Question 30

I am considering the purchase on your model RJ30. I am looking at the spects on Amazon, on the page for ordering it states 1.5 lb of salt made per day. but down on the compareable chart it states 3.1 lbs for the RJ30. which is it? View answer

Asked 3 ´years ago

Question 31

We will be replacing our old Zodiac LM23 chlorinator. We have a Hayward variable speed pump. I think the pool is a bit over 15000 gallons. Which system would be best for us? View answer

Asked 3 ´years ago

Question 32

What is the length of the RJ-30 cell? Trying to figure out if it will fit or if I need the vertical install kit. THanks. View answer

Asked 3 ´years ago

Question 33

what is the difference compared to the old RJ30 View answer

Asked 3 ´years ago

Question 34

Can you use a timer to turn the rj30 on and off? View answer

Asked 4 ´years ago

Question 35

Cell Connection message. I have done everything in the trouble shooting area in the manual. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 36

Can I replace the face on my RJ series? The digital screen no longer works. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 37

My RJ 45 unit the screen is showing me no amperage what could be the cause View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 38

What should my amps read View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 39

The “Cell Connection “ comes up on the display and nothing works View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 40

Display shows zero salinity and temp of 164 degrees. Cell was cleaned and no change. Appears to be generating cl View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 41

I have an RJ30 unit which I turn off at night. Start up in the morning results in a noticeable motor sound. I can View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series

Question 42

Is there a malfunction? View answer

Asked 2 ´years ago

Question 43

High salt light is flashing and showing 4500 what should I do it shows it’s still generating View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 44

i HAVE AN rj45+ AND MORE TIMES THEN NOT i CANT GET THE POWER TO TURN ON OR OFF. dO i NEED A NEW KEYPAD? View answer

Asked 1 ´year ago

Question 45

Why not sell the flow switch with the Tee? But you you show the sensor with the tee to sell the sensor. View answer

Asked 1 ´year ago

Question 46

I have an RJ-45 that has been working fine for about 2 years but now indicated "Cell Connect". View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 47

RJ60+ reading a voltage (around 28) but zero salinity and amps View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 48

Reading on unit says cell not match.. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 49

Readout says "cell not match" also the system will not power off...none of the buttons work ...help. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 50

control panel will not go higher than 50% View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

RJ PLUS Series Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools