RJ PLUS Series Q&A

Question 1

Asked 3 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 2

if set below 70% my generator stops generating. i shut off and turn on it starts generating then stops again View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 3

When you install the 2 jumpers to break the unit down to 120v, do the white wires stay on with jumpers? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 4

I have an RJ + 60 and the cell maint light is on. View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series

Question 5

The RJ45+ touch pad stopped working properly View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 6

CircuPool RJ-60+ keypad is unresponsive View answer

Asked 3 ´months ago

Question 7

My RJ45 temperature displays high at 168.9 degree but my water temperature is only 57 degrees View answer

Asked 3 ´months ago

Question 8

RJ45+ model, I get a "CELL NOT MATCH" View answer

Asked 3 ´months ago

Question 9

What is the return policy if the cell is not the fix and I need to buy another complete system? View answer

Asked 1 ´year ago

Question 10

How to determine the recommended size chorinator View answer

Asked 3 ´months ago

Question 11

No amps View answer

Asked 1 ´year ago

Question 12

Replace cell only? View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 13

How do you take the casing apart for the RJ 60 to replace the electrode? It looks glued but is it threaded? View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series

Question 14

Low salt light View answer

Asked 1 ´year ago

Question 15

Temperature readings over 110. Replaced flow switch. Temp readings still over 110. What should I do? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 16

My CircuPool RJ PLUS salt chlorinator lights up and then turns back off. View answer

Asked 1 ´year ago

Question 17

The salt level on my RJ 45+ reads correctly and 5 minutes later reads low salt. Cleaning does nothing. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series

Question 18

RJ PLUS Keypad View answer

Asked 2 ´months ago

Question 19

I have RJ60+ and have high temp reading which is incorrect. View answer

Asked 1 ´year ago

Question 20

Last year, on my 5 year old CircuPool RJ45, the buttons only half worked. But it made chlorine - now, no chlorine. View answer

Asked 2 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series

Question 21

I cleaned my r 40 cell and it still reads cell maintenance View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 22

My pool's pump is off with power to the RJ-30. is that OK? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 23

How to program the RJ-30 to turn on and off? Is there a way to program the system? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 24

noise View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 25

The power button does not respond. Can I fix it? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 26

My old Hayward Aquarite was vertical with no flow switch needed. Do I need one for the RJ45? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool® RJ-45 PLUS Salt Chlorine Generator

Question 27

I just installed an RJ60+ in place of my Aquapure 1400. I was just wondering- on the unit, there is a “remote” indicator. What is this for? Are there ways to adjust the unit remotely, perhaps interfacing it with the Jandy system? Thanks. View answer

Asked 4 ´years ago

Question 28

Will the system say when it’s time to change the cell? View answer

Asked 5 ´years ago

Question 29

I have an RJ-30 Plus system. What is the effect of Cell Version setting on the Menu? Each numerical value also has a '+' and '-'. What does this do to the operation of the system? This is not mentioned anywhere in the manual. View answer

Asked 3 ´years ago

Question 30

I'm interested in the bypass cell for the RJ45+, however I do not know whether my generator is "3rd generation". View answer

Asked 2 ´years ago

Question 31

Does it need to be connected to 120v or 240v? View answer

Asked 4 ´years ago

Question 32

1. On my screen it says power 50% it will not go higher. Is this because the water temp is less than 60 degrees. 2. Will it go higher when the water temp goes up View answer

Asked 4 ´years ago

Question 33

Do you make an extension cable for the rj 45 cell? View answer

Asked 2 ´years ago

Question 34

What is the minimum required flow (in GPM) for the RJ60+ Flow Switch to close and enable the Salt Cell to generate Chlorine? View answer

Asked 3 ´years ago

Question 35

Will this keypad fit my rj30 ? View answer

Asked 2 ´years ago

Question 36

What is the difference between the RJ vs the SJ series? View answer

Asked 6 ´years ago

Question 37

Our GRC/J1400-3 chlorine generator has failed. Looking for a direct replacement so the pipes don't need to be changed. Is this model applicable? Thanks View answer

Asked 5 ´years ago

Question 38

Do you offer extensions/adapters for the rj cell to connect to the power supply box? My power wall is about 6 feet farther than the provided cables length. Can I use a standard adapter to extend this? View answer

Asked 4 ´years ago

Question 39

What determins when your RJ+45 Series" goes into it's "REST Cycle"? View answer

Asked 5 ´years ago

Question 40

I have a RJ-45 Plus Salt Generator. I don't know what the winter mode button actually does and what it's usefulness is. The owners manual really doesn't describe it's function or why it should or should not be used. View answer

Asked 4 ´years ago

Question 41

I have the Circupool RJ 16. It says salt level is 2800 and really is 3600, How do you calibrate the unit? View answer

Asked 4 ´years ago

Question 42

Will the RJ45 plumbing interchange with my old circupool core View answer

Asked 1 ´year ago

Question 43

cell connection message and control panel will not power off with power button View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 44

I have purchased 2 of your RJ 30 units in the past for my pool. I really like the product and need a RJ 20 for my daughter . I have noticed the prices have increased substantially since my last purchase. There are many places that sell this product, which has the best price ? Also, what is the 120 v for $18.50 do. What is its purpose when the system runs on low voltage? Are there any discounts ? Military, senior anything at all . Thank you View answer

Asked 5 ´years ago

Question 45

No cell connection won’t turn off View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 46

RJ 30 Plus installed on 6/8/24 for a 10400 gal pool on startup with 0ppm salt. As of 6/10 salt reading is 4700ppm ? View answer

Asked 1 ´year ago

Question 47

Does the Cell maintenance light stay on when first installed and how long will it stay on?? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 48

flow switch View answer

Asked 1 ´year ago

Question 49

I am experiencing a lack of chlorine being generated but cell parameters seem correct. Solution? View answer

Asked 1 ´year ago

Question 50

Cell Connection Message View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

RJ PLUS Series Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools