Question 1

I see the flow switch is integrated into the replaceable cell. Can it be repaired without replacing the entire cell? It seems flow switches are the weakest link with Pentair. While I like this system, I'm a little apprehensive. View answer

Asked 5 ´years ago

Question 2

How often the salt cell has to be replaced? How much is a replacement salt cell for the Core 35

Asked 17 ´days ago

Question 3

Our GRC/J1400-3 chlorine generator has failed. Looking for a direct replacement so the pipes don't need to be changed. Is this model applicable? Thanks View answer

Asked 6 ´years ago

Question 4

This says it can produce up to 1.4 lbs of chlorine per day. Would this be assuming it is running at 100% output for 24 hours? Just trying to figure out my run time and output settings. Last year I was using about a 1/2 pound to 3/4 pound of chlorine per day before I installed this salt cell View answer

Asked 5 ´years ago

Question 5

Noticed lots of calcium all over my pool what can I do to eliminate this View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 6

Power button stays on

Asked 17 ´days ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 7

I just got the Core35 model. Can you leave the unit on even if the pool pump is not running since I don't have a timer? View answer

Asked 5 ´years ago

Question 8

How do I connect the CircuPool RJ-PLUS salt chlorinator to a timer? View answer

Asked 1 ´year ago

Question 9

can I buy a remote for the UL40? View answer

Asked 3 ´years ago

Question 10

for the CJ-2750 Cartridge Filter, how many filter cartridges are there? Looks like two stacked. What are the part numbers for the filter cartridges? View answer

Asked 4 ´years ago

Question 11

Does the CircuPool Core 35 come with a sacrificial anode? View answer

Asked 3 ´years ago

Question 12

I just purchased the circupool sj-45 and when I installed the Flow Switch it's leaking out of the top.

Asked 16 ´days ago

Question 13

When would this ship? Thank you View answer

Asked 4 ´years ago

Question 14

how long is it typically before you have to change the filter. I have a DE filter and usually backwash every 2-3 months. View answer

Asked 5 ´years ago

Question 15

Do you have a comparison chart for different models of salt chlorine generators? What is the difference between the RJ30 and Core35? View answer

Asked 3 ´years ago

Question 16

How many amps does the circupool universal 25 draw? Running power out to pool and making sure that I run the correct amount. View answer

Asked 4 ´years ago

Question 17

what size pipe is used for the inlet and outlet and is it PVC? View answer

Asked 4 ´years ago

Question 18

If I currently have a Hayward Aquarite, do I need the adapter or will the Core35 fit where my cell is now? View answer

Asked 4 ´years ago

Question 19

How long does it take for the salty water taste to go away ? View answer

Asked 11 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 20

Does the chlorinator need to have water circulating through it continuously? My pool has a timer to run about 8 hours a day. Does the unit need to be oversized for this? View answer

Asked 4 ´years ago

Question 21

what if the polarity light is blinking back and forth

Asked 16 ´days ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-Classic Series Salt Chlorine Generators - Owner Resources

Question 22

Can I install the unit on the discharge of the filter housing? View answer

Asked 4 ´years ago

Question 23

My pool is 35k gals does it hurt anything if I go with the bigger 55k unit? Thanks View answer

Asked 4 ´years ago

Question 24

The no flow light is on I’ve cleaned cell removed head and checked for debris and sand level what do I need to chec

Asked 16 ´days ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 25

Can Core35 be mounted horizontally instead of vertically? Do you have dimensions for the Core35? View answer

Asked 4 ´years ago

Question 26

The salt level on my RJ 45+ reads correctly and 5 minutes later reads low salt. Cleaning does nothing. View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > RJ PLUS Series

Question 27

Pentair ic40 View answer

Asked 1 ´year ago

Question 28

Is a Zinc Anode required? View answer

Asked 2 ´years ago

Question 29

The generate LED is blinking and we are getting a Hot message however the water temperature is actually 68 degrees. View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 30

How do I determine if my CircuPool Universal Series Salt Chlorinator is working properly. I have no chlorine, and I am running the generator 8 hours. View answer

Asked 1 ´year ago

Question 31

Is there a good way to clean the core 35 cell. View answer

Asked 1 ´year ago

Question 32

Does this come with the measuring template? View answer

Asked 1 ´year ago

Question 33

My CircuPool RJ PLUS salt chlorinator lights up and then turns back off. View answer

Asked 2 ´years ago

Question 34

Can this device be connected to wifi View answer

Asked 2 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 35

Part Number: RJ20N-3300-7A I am not able to order this product. Is it out of stock? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 36

Does the SJ-40 classic cell come with a replacement O-ring or do I need to buy it separately? View answer

Asked 2 ´years ago | Replacement Cells > SJ-Classic Replacement Cells

Question 37

Can get my system past “Cell Connection” View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 38

My pH is usually on the high side will this control this situation? Do you need to have salt generator? View answer

Asked 2 ´years ago

Question 39

I need to order 3-4 of the blue union arms that space the cell chlorinator plates. View answer

Asked 4 ´months ago

Question 40

Does it have a built in flow sensor or is that an extra expense? View answer

Asked 4 ´months ago

Question 41

Does the Si30 have the self-clean feature? View answer

Asked 1 ´year ago

Question 42

My generator panel is making a loud grinding sound like the power supply fan is dying. View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 43

My new replacement cell for CORE55 arrived with grease covering the connector pins View answers

Asked 2 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 44

i HAVE AN rj45+ AND MORE TIMES THEN NOT i CANT GET THE POWER TO TURN ON OR OFF. dO i NEED A NEW KEYPAD? View answer

Asked 2 ´years ago

Question 45

I currently have a permasalt system. Can I just swap this out or will I need to cut any houses? View answer

Asked 1 ´month ago | Sanitation > Salt Chlorinators > SJ Series

Question 46

Will this system operate efficiently in a hot summer 100 to 122 F. My concern is the ambient air around the tanks. View answer

Asked 5 ´months ago

Question 47

can salt generator be installed vertical View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 48

Can I order the flow sensor for CircuPool- SJ55A? View answer

Asked 1 ´year ago

Question 49

What is the minimum GPM through 2" pipe to activate the flow switch on 25 model? View answer

Asked 2 ´years ago

Question 50

Can the salt cell be installed vertically? View answer

Asked 2 ´years ago

Browse by Topic

Tools