Question 1

I have an auto clear system will this this work to replace that system. Thanks Scott View answer

Asked 4 ´years ago

Question 2

Does this product eliminate the need for chlorine By generating it’s own salt ? View answer

Asked 4 ´years ago

Question 3

I just got the Core35 model. Can you leave the unit on even if the pool pump is not running since I don't have a timer? View answer

Asked 4 ´years ago

Question 4

do you need to shock treat a pool with this Unit? Should non-chlorine shock be used? How often? View answer

Asked 4 ´years ago

Question 5

Can this chlorinator be added before the filter after the pump ?The existing pool system is very constrained where the water returns to the pool after the filter View answer

Asked 2 ´years ago

Question 6

Is the cell a direct replacement for the Pentair IC20? And, is the flowmeter integral it the cell? View answer

Asked 4 ´years ago

Question 7

I just want to ask two questions before buying this unit... I have a Hayward Aqualogic unit running a Hayward T-Cell-15. Is this unit compatible no matter what the firmware is? Is this unit in stock ready to ship immediately? View answer

Asked 3 ´years ago

Question 8

I currently have a Jandy AquaPure PLC1400 that went bad. Can this replace that without professional? Thanks much. Duane View answer

Asked 4 ´years ago

Question 9

hi I like to know if this Circupool CIR-GEN15 is comparable with aqua rite firmware r1.40 View answer

Asked 2 ´years ago

Question 10

When do you expect this item to be back in stock? View answer

Asked 3 ´years ago

Question 11

Is there a replacement for the cell when it finally dies, or do you have to buy the entire system? I am not seeing one on the site. View answer

Asked 2 ´years ago

Question 12

I have the Edge40. After a big rainstorm, the system told me that salt level was low. I added a few bags, and got it tested. Showings 4500 level. I had it running on high and boost for about 6 hours, yet my chlorine levels were still extremely low. I then cleaned the cell by the book and ran it again for a few hours with no change to chlorine levels. Still shows no chlorine when tested. I looked at the cell with a flashlight while it was running. I did see the electrolysis bubbles being formed. Yet after a few hours the chlorine levels did not rise. Please advise. View answer

Asked 3 ´years ago

Question 13

Is this item in stock and ready for immediate shipment? Thanks View answer

Asked 3 ´years ago

Question 14

Have an old RJ60. Does this replacement include both plastic housing and electrode? My plastic housing does not appear to be able to open to insert a new electrode View answer

Asked 4 ´years ago | Replacement Cells > RJ-Classic Replacement Cells

Question 15

How effective is this systm View answer

Asked 4 ´years ago

Question 16

when there is no electricity, will the device return to work after the power is restored? View answer

Asked 2 ´years ago

Question 17

We're thinking of replacing out Hayward with this system. Can we reply on the flow switch to turn the chlorinator on and off? The pump is always powered, but has an internal controller as well as variable speed. We can have reduced flow as well as no flow during parts of the day. Will this hurt your system? Thank you in advance. View answer

Asked 2 ´years ago

Question 18

Does the CircuPool Core 35 come with a sacrificial anode? View answer

Asked 2 ´years ago

Question 19

What is the difference in this product and the actual Hayward Aqua-rite Turbo T-Cell-9 (T-9)? View answer

Asked 5 ´years ago

Question 20

I have above ground pool 33 foot by 54 inch deep is this the best unit View answer

Asked 4 ´years ago

Question 21

i HAVE A 25,000 GAL POOL WILL THE CORE35 BE SUFFICIENT? View answer

Asked 2 ´years ago

Question 22

What is the wording for the limited warranty * ? View answer

Asked 2 ´years ago

Question 23

Does this system have a remote start View answer

Asked 4 ´years ago

Question 24

My old salt system lasted 19 years with the original cell, the system periodically reverse its polarity to self clean the cell. Does the CORE 35 do this? And if it doesn't why not? View answer

Asked 2 ´years ago

Question 25

what size pipe is used for the inlet and outlet and is it PVC? View answer

Asked 2 ´years ago

Question 26

Hello, I have a 6,000 gal in-ground pool in the Florida Keys. What is the best system and size for my pool. thank you. Jose View answer

Asked 2 ´years ago

Question 27

If I currently have a Hayward Aquarite, do I need the adapter or will the Core35 fit where my cell is now? View answer

Asked 2 ´years ago

Question 28

Does this work with the hayward omnilogic controller? View answer

Asked 3 ´years ago

Question 29

Is this system compatible to replace a compuclor? View answer

Asked 3 ´years ago

Question 30

How doe's the cord attach. Have SJ45A SN 05BAFAB875GE0016 View answer

Asked 2 ´years ago

Question 31

Is there a place where i can get actual dimensions? Like a shop drawing. Ive already managed to rule out the CORE55 from rough dimensions given to another. I suspect this model will be a much more close call on fitting. View answer

Asked 4 ´years ago

Question 32

The description says this can be installed horizontally or vertically but then the website shows a ventricle installation kit. Does this mean the unit as purchased cannot be installed vertically out of the box? View answer

Asked 3 ´years ago

Question 33

Is the warranty for 8 years even if I install it the owner and it’s large enough for 80 thousand litres pooland brand new unit and will I receive it and is in Canadian money this numbe thanks View answer

Asked 3 ´years ago

Question 34

I reversed the cleaning amounts using more acid than water. Did i destroy the unit ? View answer

Asked 3 ´years ago

Question 35

I just installed an RJ60+ in place of my Aquapure 1400. I was just wondering- on the unit, there is a “remote” indicator. What is this for? Are there ways to adjust the unit remotely, perhaps interfacing it with the Jandy system? Thanks. View answer

Asked 4 ´years ago

Question 36

"Roughly" how long is the power wire? If it's short, is it easy to wire in a new one? "Roughly" how many amps would one think the 35k unit draws? I'm deciding on hardwiring it to my pump timer or a separate GFI outlet that runs off the timer. View answer

Asked 3 ´years ago

Question 37

Can Core35 be mounted horizontally instead of vertically? Do you have dimensions for the Core35? View answer

Asked 3 ´years ago

Question 38

I have a 21600 gallons inground pool , What would be the best suitable model salt chlorine generator? View answer

Asked 3 ´years ago

Question 39

The only power source available is 240 volt. Can the core 35 be rewired for a 240 volt connection? View answer

Asked 3 ´years ago

Question 40

I’m thinking about changing over to a SWJ system, mainly due to issues with chlorine this year. Looking at a UL40.. 1) at 120v, how many amps does it pull? 2) does the plug in model need to be on a timer with the pump? Or is it smart enough to not work when there is no flow? 3) what are dimensions of the control box? View answer

Asked 3 ´years ago

Question 41

Can you use the flow switch from my Hayward system or do I have to change it? Also what would be the shipping time after I order? Universal 40 View answer

Asked 3 ´years ago

Question 42

I currently have a Jandy saltwater system and I am looking to replace it with something that actually works. Can you tell me what product would make sense to work with my Jandy system and work for my pool size (about 35,000 gallons) Thanks View answer

Asked 3 ´years ago

Question 43

How can I tell if my cell needs replacement? My cell does not bring the chlorine levels up. I have cleaned the unit twice this year per directions. The only lights lit up on the control panel is generate and power. No problem with flow speed, salt level is about 3700. Any suggestions? Unit is about 4 years old. How can you tell if it's a classic RJ45 or newer?? View answer

Asked 2 ´years ago | Replacement Cells > RJ-Classic Replacement Cells

Question 44

Hi, I have a pool of 22.000 gallons with a pump pentair of 2 HP SF-N1-2A (85 GPM Aprox). If I Installed a Universal 40 how many hours a day I must turn on the system ?. I live in Colombia and the temperature of the water is about 84 F. When you talk about 2.0 lb, how many working hours it means ? Regards, Diego. View answer

Asked 3 ´years ago

Question 45

What are the dimensions of the steel cabinet? View answer

Asked 3 ´years ago

Question 46

Will the system say when it’s time to change the cell? View answer

Asked 5 ´years ago

Question 47

what are the connection measurements, ie., length, dia. Where does the salt supply go and how long does it last. View answer

Asked 3 ´years ago

Question 48

What are the dimensions of the UL 40 and it's flow control unit. (LxW). I'm investigating an acceptable place to install in my existing cholorine system piping. I cannot find this info anywhere on your site. View answer

Asked 3 ´years ago

Question 49

My core 55 is only showing one bar and if I increase the bars, it one flashes on another bar. It also says to clean the unit which I have done several times. What can I do to fix the problem. At first, it was working great. View answer

Asked 2 ´years ago

Question 50

1)Hi, are your generators universal voltage? Are there for 220 Volts? 2) How many years can work for a pool of 80,000 liters(21,000 gallons), Thanks View answer

Asked 3 ´years ago

Browse by Topic

Tools