Question 1

Will this cap fit r j 45 View answer

Asked 3 ´years ago

Question 2

What is the correct cleaning cap to use for an RJ45 cell? View answer

Asked 3 ´years ago

Question 3

Will this fit the universal ul40? View answer

Asked 4 ´years ago

Question 4

Can you provide a picture of the CircuPool EDGE Cleaning Cap? View answer

Asked 5 ´years ago

Question 5

Is this the same union supplied with the core series? View answer

Asked 3 ´years ago

Question 6

Is this the Part that the ORing fits into? View answer

Asked 4 ´years ago

Question 7

Does this part have the rubber o-ring included? View answer

Asked 5 ´years ago

Question 8

will this fit the sj-15 salt cell . The one that holds the cell .with the cord to the clear plastic housing. my blue collar has a crack in it View answer

Asked 5 ´years ago

Question 9

I need a new flow switch for my RJ-30 Circupool salt system. Will this part fit? View answer

Asked 3 ´years ago

Question 10

Will this fit model S160? Serial no 05aa5da3f50037 View answer

Asked 4 ´years ago

Question 11

Would this flow meter work in a 305 px natural chlorine generator? It looks exactly the same as the one I'm replacing. View answer

Asked 4 ´years ago

Question 12

I just bought one of these to replace my origional SJ-55 Housing that does not have the xxxx on adapters to connect to the return line. Is there an O-Ring that goes between the adapter and the Clear Housing to insure a complete seal? View answer

Asked 4 ´years ago

Question 13

The Flow LED on the panel will turn green for aprox. 10 seconds and then go red for aprox. 2 min. When it will go green again for 10 seconds repeating. Could this be a faulty flow switch or something else? View answer

Asked 3 ´years ago

Question 14

How do you get the wire through the hole View answer

Asked 3 ´years ago

Question 15

My cap is cracked at the area that appears to be "fused" together...I purchased my SJ-30 in May of 2019. How can I get this part? I have looked all over the internet. View answer

Asked 3 ´years ago

Question 16

Cutting the cord is okay when replacing the collar cap. Or is there a way to disassemble the plug? View answer

Asked 4 ´years ago

Question 17

Any idea when this will be back in stock? View answer

Asked 3 ´years ago

Question 18

Is this the 3 wire plug that connects to the sj controller? View answer

Asked 4 ´years ago

Question 19

Does this 0-ring fit the electolytic cell for the CircuPool Core 35 unit? View answer

Asked 3 ´years ago

Question 20

Where does the print go on the winter cap. It seems to be placed on the top and outside of cap but it leaks. So should it be on the inside when installing View answer

Asked 4 ´years ago

Question 21

Is this the ORing that goes in the Union Nut to seal against the Face of the Generator? View answer

Asked 4 ´years ago

Question 22

does anyone know where this o ring should go ? View answer

Asked 6 ´years ago

Question 23

Please can you provide a technical drawing for this. Looking to replace a Surechlor 3000 SC210 and need to compare sizes/threads/fittings etc. thanks in advance, Gary View answer

Asked 3 ´years ago

Question 24

Does this fit all SJ series? If not, refundable? View answer

Asked 3 ´years ago

Question 25

does it fit for sj40 series? View answer

Asked 4 ´years ago

Question 26

How do you get wire through the cap View answer

Asked 3 ´years ago

Question 27

is this 2 pieces? View answer

Asked 3 ´years ago

Question 28

Does this item come with an o-ring? View answer

Asked 4 ´years ago

Question 29

do you make a similar cap for the RJ+ (RJ60N) ? View answer

Asked 6 ´years ago

Question 30

Standard overall needed space for installation? And can it be installed vertically? View answer

Asked 5 ´years ago

Question 31

What is the length of the power cord? View answer

Asked 5 ´years ago

Question 32

What are the overall dimensions of the unit? View answer

Asked 5 ´years ago

Question 33

Can we get an adapter kit for a pentair ic 40 View answer

Asked 3 ´years ago

Question 34

How important to place Core35 after the heater? The heater is about 8 feet from the filter but all the plumbing is underground and the wiring will be a longer distance than desired. This will cause me lots of work on new plumbing. I can easily place it between the filter (pool return) and the heater (which we rarely use in Florida). It this acceptable? View answer

Asked 4 ´years ago

Question 35

I see the flow switch is integrated into the replaceable cell. Can it be repaired without replacing the entire cell? It seems flow switches are the weakest link with Pentair. While I like this system, I'm a little apprehensive. View answer

Asked 4 ´years ago

Question 36

Do I need to install a check valve before the CORE35 to prevent superchlorinated water backflowing into my system when the pool pump is turned off? View answer

Asked 4 ´years ago

Question 37

How can I tell what my salinity level is on the Core35 unit? View answer

Asked 4 ´years ago

Question 38

How long is the power cord? View answer

Asked 4 ´years ago

Question 39

This says it can produce up to 1.4 lbs of chlorine per day. Would this be assuming it is running at 100% output for 24 hours? Just trying to figure out my run time and output settings. Last year I was using about a 1/2 pound to 3/4 pound of chlorine per day before I installed this salt cell View answer

Asked 4 ´years ago

Question 40

How can I get a pdf of the manual View answer

Asked 4 ´years ago

Question 41

I just got the Core35 model. Can you leave the unit on even if the pool pump is not running since I don't have a timer? View answer

Asked 4 ´years ago

Question 42

do you need to shock treat a pool with this Unit? Should non-chlorine shock be used? How often? View answer

Asked 4 ´years ago

Question 43

Can this chlorinator be added before the filter after the pump ?The existing pool system is very constrained where the water returns to the pool after the filter View answer

Asked 3 ´years ago

Question 44

Is there a replacement for the cell when it finally dies, or do you have to buy the entire system? I am not seeing one on the site. View answer

Asked 3 ´years ago

Question 45

when there is no electricity, will the device return to work after the power is restored? View answer

Asked 3 ´years ago

Question 46

We're thinking of replacing out Hayward with this system. Can we reply on the flow switch to turn the chlorinator on and off? The pump is always powered, but has an internal controller as well as variable speed. We can have reduced flow as well as no flow during parts of the day. Will this hurt your system? Thank you in advance. View answer

Asked 3 ´years ago

Question 47

Does the CircuPool Core 35 come with a sacrificial anode? View answer

Asked 3 ´years ago

Question 48

i HAVE A 25,000 GAL POOL WILL THE CORE35 BE SUFFICIENT? View answer

Asked 3 ´years ago

Question 49

What is the wording for the limited warranty * ? View answer

Asked 3 ´years ago

Question 50

Do you have a comparison chart for different models of salt chlorine generators? What is the difference between the RJ30 and Core35? View answer

Asked 3 ´years ago

Browse by Topic

Tools