Question 1

We're thinking of replacing out Hayward with this system. Can we reply on the flow switch to turn the chlorinator on and off? The pump is always powered, but has an internal controller as well as variable speed. We can have reduced flow as well as no flow during parts of the day. Will this hurt your system? Thank you in advance. View answer

Asked 2 ´years ago

Question 2

Can I use this system to lower my PH to 6.9 - 7.0? I have a staining problem and it is advised to lower the Ph to break uip the calcium covering the dirt so it can be vacuumed up View answer

Asked 2 ´years ago | Sanitation > pH Control

Question 3

What is the max amp draw of this unit? I am trying to decide if I should add it to my pump circuit or add a new circuit and if the latter than size the circuit. View answer

Asked 2 ´years ago

Question 4

Will this replace the rj45 View answer

Asked 2 ´years ago

Question 5

Will this cap fit r j 45 View answer

Asked 2 ´years ago

Question 6

Can this replace a T17 cell View answer

Asked 2 ´years ago

Question 7

The Flow LED on the panel will turn green for aprox. 10 seconds and then go red for aprox. 2 min. When it will go green again for 10 seconds repeating. Could this be a faulty flow switch or something else? View answer

Asked 2 ´years ago

Question 8

Does the CircuPool Core 35 come with a sacrificial anode? View answer

Asked 2 ´years ago

Question 9

I have a timer on my pump. Does the generator need to be on a timer also or is it ok to just let the flow switch shut down the unit when the pump is off? View answer

Asked 2 ´years ago

Question 10

How long do these RJ 30 cells last? View answer

Asked 2 ´years ago

Question 11

Will the universal 40 cell fit the t-15 directly. View answer

Asked 2 ´years ago

Question 12

Can we get an adapter kit for a pentair ic 40 View answer

Asked 2 ´years ago

Question 13

i HAVE A 25,000 GAL POOL WILL THE CORE35 BE SUFFICIENT? View answer

Asked 2 ´years ago

Question 14

Will this handle a 72000 litre pool in a northern rn climate View answer

Asked 2 ´years ago

Question 15

Bought until 5 months ago and not generating. Power doesn’t seem to be getting to cell but control box lights working and has power. Any ideas? View answer

Asked 2 ´years ago

Question 16

I have a 15 x 32 18200 gallon pool. I have small children and occasionally have pool partya with 20+ people in the pool. I also live near trees that constantly release leaves on to the pool. Thousands in a day. Would this system be able to handle these conditions? View answer

Asked 2 ´years ago

Question 17

I am re-plumbing My RJ60+ because of leaks. I purchased the Vertical installation kit but it does not include a flow switch housing. Is this the one I need? View answer

Asked 2 ´years ago

Question 18

I am reinstalling my RJ60+ because of leaks. Is this union the same as the one that came with my RJ60+. Does it a a groove cut in it for the o-ring? View answer

Asked 2 ´years ago

Question 19

Does the flow switch install into the existing PVC tee fitting? View answer

Asked 2 ´years ago | CircuPool® Flow Switch / Temperature Sensor (No PVC Tee Fitting)

Question 20

Can you have too big of a chlorinator? View answer

Asked 2 ´years ago

Question 21

I have an SI-40 will the SI-45 replacement cell work with it. View answer

Asked 2 ´years ago

Question 22

Just received my order from you and it was a housing O-ring, Mechanical Seal, and impeller, not quite sure of the sequence and I want to be sure I put everything back the way it suppose to be. Would you have a better picture you could e-mail me that is a little better than the manual shows. When I unscrewed the impeller some of the parts on mechanical seal came apart and I would like to make sure I do this right. Thanks for any help you could give me. View answer

Asked 2 ´years ago

Question 23

I have a Circupool Core. Needs an element. How to tell which one? thank you View answer

Asked 2 ´years ago | Replacement Cells > CORE-Series Replacement Cells

Question 24

Will this work with a 25000 gallon above ground pool? View answer

Asked 2 ´years ago

Question 25

Where can I purchase the cell only for the 40 model ? View answer

Asked 2 ´years ago

Question 26

Do you know when this product is expected to be back in stock (CircuPool CIR-GEN15 salt cell)? View answer

Asked 2 ´years ago

Question 27

can i replace a rj45 with a rj60 View answer

Asked 2 ´years ago | Replacement Cells > RJ PLUS-Series Replacement Cells

Question 28

If you have the SJ20 and upgrade to the RJ30 plus, do all the replacement parts fit where the SJ20 parts were? For example the cell fittings? View answer

Asked 2 ´years ago

Question 29

does the cell come with the cable attached ? View answer

Asked 2 ´years ago | Replacement Cells > Universal-Series Replacement Cells

Question 30

I am looking for a unit to convert my pool to a saltwater pool. I noticed this system says that it is a "replacement" for current systems. What would I need to do to install this as a new system? View answer

Asked 2 ´years ago

Question 31

Tired of the sand. Looking to replace my sand filter with a two-stage process like this. I get the TJ-16 but not sure what the proper filter would be? CJ180? What is the replacement cost of the filter cartridge? View answer

Asked 2 ´years ago

Question 32

What are the dimensions of the RJ-45 cell and flow switch? I need to confirm if I have enough piping. Thank you View answer

Asked 2 ´years ago

Question 33

I tripped on my wire of the flow connector. The wire pulled out of the phone cord like clip. Can I reconnect it? or do I really have to buy a new one? My unit is a si series plis unit from over 10 years ago. On the panel ........r502 f15 if that helps. View answer

Asked 2 ´years ago | CircuPool® Flow Switch / Temperature Sensor (No PVC Tee Fitting)

Question 34

water pump qualifies for energy star tax credit View answer

Asked 2 ´years ago

Question 35

Hello, What is the minimum flow rate (GPM) for operation for the CircuPool Core series? I currently have a Jandy VSP pump that I run at 1200 rpms that generates 22 gpm. Would the Chlorinator work at this low flow rate? Thanks in advance for your assistance. Have a GREAT Day. Regards, Eric Brown View answer

Asked 2 ´years ago

Question 36

What setup would I need for a 7,000g saltwater pool. View answer

Asked 2 ´years ago | Sanitation > pH Control

Question 37

Is there a regular interval at which polarity is reversed? I run my pump 4 hours per day. When not running there will be no power to the control unit. I'm worried based on my past experience with Zodiac LM that with power being cut, the polarity will be reversed every 4 hours after power up which would be a problem (of course I can run it longer if needed). View answer

Asked 2 ´years ago

Question 38

I need the replacement electrodes for the sj40. Do you have an eta on the availability View answer

Asked 2 ´years ago

Question 39

How do I buy a replacement for the SJ 3500 Generator buy it's self?? View answer

Asked 2 ´years ago

Question 40

I noticed in reading about my RJ+ 60 that you recommend a Cleaning Cap or Cleaning Stand to clean the cell of mineral build up. I went on line to look for these items, but only found the cleaning stand. Where can I find the cleaning cap? View answer

Asked 2 ´years ago | CircuPool® Cleaning Stand for CircuPool RJ Plus, Universal, and Si Systems

Question 41

I currently have the UL40 system and was wondering if I can upgrade the cell to the UL55 without changing the control box? View answer

Asked 2 ´years ago

Question 42

I have an AquaRite Model: AQ-RITE-X295; SN 5A0710-1047242, rev 1.4. Can I replace the blown circuit board with your CircuPool Si PCB? View answer

Asked 2 ´years ago

Question 43

Do you have a handle on the estimated arrival for shipment of this item? View answer

Asked 2 ´years ago

Question 44

What size pic pipe does the kit fit as shown? My current plumbing is 2", and is the original Hayward, which has fit the RJ45 View answer

Asked 2 ´years ago

Question 45

What setting should i use for my SI plus chlorinator? it is currently on F 15 View answer

Asked 2 ´years ago

Question 46

How doe's the cord attach. Have SJ45A SN 05BAFAB875GE0016 View answer

Asked 2 ´years ago

Question 47

Do you have a comparison chart for different models of salt chlorine generators? What is the difference between the RJ30 and Core35? View answer

Asked 2 ´years ago

Question 48

What is the wording for the limited warranty * ? View answer

Asked 2 ´years ago

Question 49

can I buy a remote for the UL40? View answer

Asked 2 ´years ago

Question 50

Does this O ring fit 2" bushing converting to 1 1/2 " fitted to cell. Is $9.00 for 2 o rings? View answer

Asked 2 ´years ago | CircuPool® O-Ring Set for RJN/UL/Si

Browse by Topic

Tools