Question 1

What do I do when it says "salt cell low" View answer

Answer posted 2 years ago

Question 2

Does this O ring fit 2" bushing converting to 1 1/2 " fitted to cell. Is $9.00 for 2 o rings? View answer

Answer posted 2 years ago | CircuPool® O-Ring Set for RJN/UL/Si

Question 3

It is Titanium Cell ? View answer

Answer posted 2 years ago | Replacement Parts > Replacement Cells > Si-Series Replacement Cells

Question 4

I have a 10,000 gallon pool and want to convert to salt. So many questions. It's been 3 years since I drained and replaced 1/2 the water in the pool due to a repair. Should I consider a water replacement prior to conversion ? Under what circumstances should I consider water replacement? Money not an option...which model should I buy? What size? When does increase size not benefit performance for salt conversion power, cell cleaning cycle time, and cell life? Installation should not be a consideration as all would fit my system. Thank you, Bill View answer

Answer posted 2 years ago

Question 5

Just submitted a question regarding swg and just ran across your Ozone units. Again, 10,000 gallon pool. Light use except for 2-3 weeks when grandkids visit. Which unit would you recommend? I have a Pentair VSP that I run 4-6 hours a day. How long/volume does the 03 unit require? View answer

Answer posted 2 years ago | Sanitation > Ozone Generators

Question 6

Little add on to previous two questions that I submitted. Pool is located in south Florida (Port Charlotte, FL). Equipment is all outside. Lots of sun, rain and humidity. What would be best configuration for installing swg and O3 units together? Thanks again, Bill View answer

Answer posted 2 years ago | Sanitation > Ozone Generators

Question 7

Is this item, the vertical installation kit, returnable if I wind up not needing it for my install? If so are there restock fees or return shipping to consider? View answer

Answer posted 2 years ago

Question 8

I have to remove my core 35. Can I install these with a piece of PVC pipe until the Core 35 is checked out? View answer

Answer posted 2 years ago

Question 9

What size unit would I need for 18,000 pool 16 x 32 8 ft deep end 4 ft shallow View answer

Answer posted 2 years ago

Question 10

Why does the boost light flash on my edge pool generator? View answer

Answer posted 2 years ago

Question 11

Will this inter change with old 23470 element and wire up to my old system, View answer

Answer posted 2 years ago

Question 12

what size pipe is used for the inlet and outlet and is it PVC? View answer

Answer posted 2 years ago

Question 13

Hello, can I purchase a UL55 replacement cell for our UL25 system? Thank you, Jamie View answer

Answer posted 2 years ago

Question 14

What does it indicate on a Circupool SJ40, If the cell seems to turn things in the housing an orange color? Is it a cell problem or a chemical problem? View answer

Answer posted 2 years ago

Question 15

My sand filter does not trap the very fine dust. Will this capture the fine particals? View answer

Answer posted 2 years ago

Question 16

How do you get wire through the cap View answer

Answer posted 2 years ago

Question 17

How do you get the wire through the hole View answer

Answer posted 2 years ago

Question 18

Does this work for CORE models? View answer

Answer posted 2 years ago | CircuPool® Bypass Cell for RJ-PLUS and UL-Series Salt Systems

Question 19

I have an inground 11,500gal (estimate) pool. I have a 100 sq ft cartridge filter. All visible plumbing is 1-1/2" PVC. The current pump motor is 1 HP single speed. I would like to upgrade to a VS pump to run 8 hrs per day and turn the pool over 2x/day. I'm also considering the RJ-20PLUS SWCG. What size motor should I use - the 1.5, 2.0 or the 3.0HP??? Also, do you agree with the RJ-20 or should I go with the RJ-30? View answer

Answer posted 2 years ago

Question 20

I purchased a Universal 55 to replace a Pentair Salt System and I was wondering if there is an adapter kit or if I will just have to modify the plumbing myself. Thank you for your time and I can't wait to see the new system in action! View answer

Answer posted 2 years ago

Question 21

How many pounds it has? View answer

Answer posted 2 years ago

Question 22

How can I tell if my cell needs replacement? My cell does not bring the chlorine levels up. I have cleaned the unit twice this year per directions. The only lights lit up on the control panel is generate and power. No problem with flow speed, salt level is about 3700. Any suggestions? Unit is about 4 years old. How can you tell if it's a classic RJ45 or newer?? View answer

Answer posted 2 years ago | Replacement Parts > Replacement Cells > RJ-Classic Replacement Cells

Question 23

Curious if the items are in stock or on back order please. Looking for the J60 model... And even my pool guy is having a hard time getting it, thank you View answer

Answer posted 2 years ago

Question 24

what should the salt level of the pool be? View answer

Answer posted 2 years ago

Question 25

Hello, I have a 6,000 gal in-ground pool in the Florida Keys. What is the best system and size for my pool. thank you. Jose View answer

Answer posted 2 years ago

Question 26

Can this SJ55 cell fit and be used on a system that previously had an SJ-40 cell installed on it? Once I get confirmation I will purchase the equipment if it works View answer

Answer posted 2 years ago | Replacement Parts > Replacement Cells > SJ-Classic Replacement Cells

Question 27

My Hayward Aqua Rite system is not generating and says low salt check cell. I checked salt and salt is good. Cleaned cell ,reset system and still shows check cell. Low salt. I’m trying to decide if I should replace cell or complete system. Is this typical when cell is bad or is panel also bad . Is there a way to check.? View answer

Answer posted 2 years ago | Replacement Parts > Replacement Cells > Aftermarket Replacement Cells <span>fitting Hayward® / Goldline®</span>

Question 28

Does the power turn off to the plates when pump is off and it says no flow View answer

Answer posted 2 years ago

Question 29

How many amps does the circupool universal 25 draw? Running power out to pool and making sure that I run the correct amount. View answer

Answer posted 2 years ago

Question 30

I am trying to decide between this rj30 and your core 35 could you give me some help I have 15000gl pool changing from tables to salt View answer

Answer posted 2 years ago

Question 31

I have a Circupool Model Si30. I have the cell with the female part of the union the replacement did not come with the inside part that glues to the pipe. I need the adapters at 1-1/2". What item # would I need? View answer

Answer posted 2 years ago

Question 32

I have a 20x40 pool and there is currently a cable cord that goes from the cell to the electric chlorinated generator but I don’t see this in the pick. Will this work? View answer

Answer posted 2 years ago | Replacement Parts > Replacement Cells > Universal-Series Replacement Cells

Question 33

Will this filter work in a Hayward Filter cannister with 150 sq ft cartridge? Thanks. View answer

Answer posted 2 years ago

Question 34

Installed the RJ-30 just before summer hit here in the Houston area on a ~15K gallon pool. Just want to know if having to run it at around 85-90% power is normal for the hot summer days on this size of pool. View answer

Answer posted 2 years ago

Question 35

Is this what I need to connect an SI30 cell to 1 1/2" pvc plumbing? View answer

Answer posted 2 years ago

Question 36

How many amps will this pump pull? View answer

Answer posted 2 years ago

Question 37

Does this fit all SJ series? If not, refundable? View answer

Answer posted 2 years ago

Question 38

Does this work for above ground pool View answer

Answer posted 2 years ago

Question 39

can the SJ-55 classic work in the SJ-40 housing? View answer

Answer posted 2 years ago | Replacement Parts > Replacement Cells > SJ-Classic Replacement Cells

Question 40

what does the 3 year warantee cover. ? will it last as long as the haywood cell View answer

Answer posted 2 years ago | Replacement Parts > Replacement Cells > Aftermarket Replacement Cells <span>fitting Hayward® / Goldline®</span>

Question 41

I am considering the purchase on your model RJ30. I am looking at the spects on Amazon, on the page for ordering it states 1.5 lb of salt made per day. but down on the compareable chart it states 3.1 lbs for the RJ30. which is it? View answer

Answer posted 2 years ago

Question 42

What’s the average lifespan of the cell in the RJ30? View answer

Answer posted 2 years ago

Question 43

The lifespan is referring to the cell, correct? How much is the replacement cell for this system? Why is the lifespan range so wide- I am hearing 3 to 7 years- what effects the life span? Thank you. View answer

Answer posted 2 years ago

Question 44

My chlorinator is saying there is no water flow, but the water is flowing just fine with no obstructions. The flow indicator switch moves freely. What can I do?? View answer

Answer posted 2 years ago

Question 45

I recently purchased this CO2 system including 2 tanks from you. Will the tanks that I purchased come with the regulator vales, or will I have to purchase them separately from somewhere else? View answer

Answer posted 2 years ago

Question 46

what type chlorinator with good warranty do you recommend for a freeform 10,000 gallon pool? You offer so many series. Thank you. View answer

Answer posted 2 years ago

Question 47

The dual filter combos - do the cartridge filters come with a cartridge filter? Or do you have to also buy the cartridge in addition to the combo cost? For example - thinking about the dual filter combo with the CJ 2750 . Will the dual combo purchase include the cartridge or will the combo arrive without a cartridge? View answer

Answer posted 2 years ago

Question 48

What is the RJ+ cell unit's maximum pressure (PSI) rating? View answer

Answer posted 2 years ago

Question 49

Do I need a flow sensor with the SJ system? How do you know the differences between SJ-20 and others? Is it size of pool? Location? View answer

Answer posted 2 years ago

Question 50

Are ozone generators effective in a non-salt pool? My builder installed one, years ago (28 year-old pool) and it hasn’t worked for quite some time. Thinking about replacing it but not sure about how effective it is (was). View answer

Answer posted 2 years ago | Sanitation > Ozone Generators

Browse by Topic

Tools