Salt Chlorinators Q&A

Question 1

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 2

I am considering the purchase on your model RJ30. I am looking at the spects on Amazon, on the page for ordering it states 1.5 lb of salt made per day. but down on the compareable chart it states 3.1 lbs for the RJ30. which is it? View answer

Asked 3 ´years ago

Question 3

We will be replacing our old Zodiac LM23 chlorinator. We have a Hayward variable speed pump. I think the pool is a bit over 15000 gallons. Which system would be best for us? View answer

Asked 4 ´years ago

Question 4

rj-30 generates 1.5 lbs / day... Question: What do you mean by "day"? How many hours in "day"? View answer

Asked 4 ´years ago

Question 5

What is the length of the RJ-30 cell? Trying to figure out if it will fit or if I need the vertical install kit. THanks. View answer

Asked 4 ´years ago

Question 6

Concerning your RJ-20 System, I am close to the beach and a very corrosive environment, what is the rating on your control box and how does it stand up in salty conditions? View answer

Asked 4 ´years ago

Question 7

Installed in fall of 2020. Tuned on in spring of 2021. How do I clean it and what is best to use. ??? View answer

Asked 4 ´years ago

Question 8

Is it product partial to leave the unit powered 24-7 ? I recently purchased a variable speed pump which leaves the unit on displaying various lights…I realize the flow switch controls the Cell but I dont want to unnecessarily damage the unit by leaving it powered 24-7 View answer

Asked 4 ´years ago

Question 9

can this unit be powered up 24/7, or does it need a timer/clock? View answer

Asked 5 ´years ago

Question 10

Did this take the place of the SGS salt system? View answer

Asked 5 ´years ago

Question 11

Core55 output View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > CORE Series

Question 12

Our GRC/J1400-3 chlorine generator has failed. Looking for a direct replacement so the pipes don't need to be changed. Is this model applicable? Thanks View answer

Asked 5 ´years ago

Question 13

is there a verical hook-up kit available? View answer

Asked 7 ´years ago

Question 14

I have a below grade equipment room. I was going to install 2- SJ55 on a 50,000 gallon pool. I want the system to coast for longer cell life. What do I need to install the two units below ground? Would it be possible to get a drawing of what you would recommend? View answer

Asked 7 ´years ago

Question 15

I bought a house with a 26qft pool. I'm trying to learn to control the salt chlorinator (SJ series) for my pool. The water is murky now, with algae. All parameters are ok (I check regularly), except chlorine and free chlorine levels, which are at 0. How do I know that the cell actually works? Is there a documentation regarding the controller? the left bottom green light has been blinking. Also, how is this controller related to the pump? I have Hayward controller for the pump, and I'm clueless here too. Please help. View answer

Asked 4 ´years ago

Question 16

On our second SJ40 and have never used Super CL Mode and would like to know should the light be red.?? We just had the pool redone and need to get the chlorine and salinity back up to where they need to be.......... View answer

Asked 6 ´years ago

Question 17

Will the plumbing for the SJ20 classic fit with the new SJ series? View answer

Asked 4 ´years ago

Question 18

How long is the cord that connects the cell housing to the control module? View answer

Asked 4 ´years ago

Question 19

I have a 15,000 gallon pool with a 3 year old waves/breeze unit that needs to be replaced. Just will not generate chlorine since install. Will this unit provide the correct chlorine and sanitizer needed for this size pool View answer

Asked 4 ´years ago

Question 20

The only power source available is 240 volt. Can the core 35 be rewired for a 240 volt connection? View answer

Asked 4 ´years ago

Question 21

When its generating how do you know its producing View answer

Asked 5 ´years ago

Question 22

Is it OK to install the salt generator cell (SJ-20) and flow sensor on the discharge piping of my pool cartridge cannister? View answer

Asked 4 ´years ago

Question 23

I have a 21600 gallons inground pool , What would be the best suitable model salt chlorine generator? View answer

Asked 4 ´years ago

Question 24

why do I have letters on my screen View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 25

When will these be back in stock? View answer

Asked 4 ´years ago

Question 26

When will SJ-20 system be available? View answer

Asked 4 ´years ago

Question 27

Will this work on 24 round above ground pool that is 5 ft deep ? View answer

Asked 5 ´years ago

Question 28

With a variable speed pump is it ok to leave the generator powered all the time even when the pump shuts off View answer

Asked 3 ´years ago

Question 29

Can Core35 be mounted horizontally instead of vertically? Do you have dimensions for the Core35? View answer

Asked 4 ´years ago

Question 30

Are there any specific instructions for storing in the winter months? Covering? (for CircuPool Universal Series salt chlorinator) View answer

Asked 3 ´years ago

Question 31

"Roughly" how long is the power wire? If it's short, is it easy to wire in a new one? "Roughly" how many amps would one think the 35k unit draws? I'm deciding on hardwiring it to my pump timer or a separate GFI outlet that runs off the timer. View answer

Asked 4 ´years ago

Question 32

Is the warranty for 8 years even if I install it the owner and it’s large enough for 80 thousand litres pooland brand new unit and will I receive it and is in Canadian money this numbe thanks View answer

Asked 4 ´years ago

Question 33

Do you have a comparison chart for different models of salt chlorine generators? What is the difference between the RJ30 and Core35? View answer

Asked 3 ´years ago

Question 34

i HAVE A 25,000 GAL POOL WILL THE CORE35 BE SUFFICIENT? View answer

Asked 3 ´years ago

Question 35

Why is polarity 2 yellow and no output and polarity 1 green and working great. Replaced cell and same issue View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-Classic Series Salt Chlorine Generators - Owner Resources

Question 36

Will the generator be compatible with my infinity i40 salt cell View answer

Asked 3 ´years ago

Question 37

Does the CircuPool Core 35 come with a sacrificial anode? View answer

Asked 3 ´years ago

Question 38

Do you make an extension cable for the rj 45 cell? View answer

Asked 3 ´years ago

Question 39

We're thinking of replacing out Hayward with this system. Can we reply on the flow switch to turn the chlorinator on and off? The pump is always powered, but has an internal controller as well as variable speed. We can have reduced flow as well as no flow during parts of the day. Will this hurt your system? Thank you in advance. View answer

Asked 3 ´years ago

Question 40

when there is no electricity, will the device return to work after the power is restored? View answer

Asked 3 ´years ago

Question 41

Is there a replacement for the cell when it finally dies, or do you have to buy the entire system? I am not seeing one on the site. View answer

Asked 3 ´years ago

Question 42

hot on led View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 43

How can I get a pdf of the manual View answer

Asked 5 ´years ago

Question 44

How can I tell what my salinity level is on the Core35 unit? View answer

Asked 5 ´years ago

Question 45

The display screen is not working properly View answer

Asked 3 ´years ago

Question 46

Which side of the cell is the input? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 47

Do I need to install a check valve before the CORE35 to prevent superchlorinated water backflowing into my system when the pool pump is turned off? View answer

Asked 4 ´years ago

Question 48

How important to place Core35 after the heater? The heater is about 8 feet from the filter but all the plumbing is underground and the wiring will be a longer distance than desired. This will cause me lots of work on new plumbing. I can easily place it between the filter (pool return) and the heater (which we rarely use in Florida). It this acceptable? View answer

Asked 4 ´years ago

Question 49

What are my issues using a reducer for 1 1/2 to 2 in . Suggestions View answer

Asked 5 ´years ago

Question 50

My pool Is 27,000 gals ... is it best to purchase core 55 salt chlorinator or would that be to big ..also will the metal components on the pool equipment suffer from the salt View answer

Asked 5 ´years ago

Salt Chlorinators Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools