Salt Chlorinators Q&A

Question 1

What is the total dimension for the flow switch and cell for the Edge 40? 11 3/4 inches View answer

Asked 6 ´years ago

Question 2

I am looking for a unit to convert my pool to a saltwater pool. I noticed this system says that it is a "replacement" for current systems. What would I need to do to install this as a new system? View answer

Asked 3 ´years ago

Question 3

When do you think this product will be available again? I am converting a 9 person hot tub to saltwater. Would the edge25 be too large for hot tub? View answer

Asked 3 ´years ago

Question 4

how long does the edge 15 need to be run to meet the advertised chlorine rate per day? View answer

Asked 4 ´years ago

Question 5

When converting from a chlorine pool to this system, do I run the already chlorinated water through the system and add additional salt as needed? Thanks a lot for the assistance. View answer

Asked 3 ´years ago

Question 6

I meant to click the box for 1 1/2 in reducers when I purchased the Core 55 last week. I've looked on the site, but I don't see them separately. Is there a way I can get these now? thanks, Patrick Smith View answer

Asked 4 ´years ago

Question 7

I have an Si-45 unit. The cell needs replacing but I have reduced the size of the pool from 35,000 gals to 22,000 gals. Is it possible to replace the original cell with an Si-30 replacement ? View answer

Asked 4 ´years ago

Question 8

is there a way to calibrate the cell? salt level in the pool shows to be around 3900 and the display shows salt too low...any help greatly appreciated..thank you... it is a si30 system with a 15000 gallon pool View answer

Asked 3 ´years ago

Question 9

DOES THE NO FLOW LIGHT STAY ON WHEN THE PUMP IS OFF? IF SO, HOW LONG? WILL I HAVE TO MANUALLY TURN IT OFF EVERY DAY? View answer

Asked 5 ´years ago

Question 10

I currently own a Circu-pool Si series chlorine generator,. The current cell is a Si30 that has a maximum output to sustain a 30,000 gal pool. I have a 28,000 gal pool. The cell is in need to be replaced. Can I replace the Si 30 cell with a Si 45 cell? View answer

Asked 6 ´years ago

Question 11

If hardwired to the pump, will the percentage of output stay the same when powered off and back on again? View answer

Asked 6 ´years ago

Question 12

What is the correct cell code for the SI-60 cell View answer

Asked 4 ´years ago

Question 13

Can the core 55 be mounted in the vertical position? View answer

Asked 3 ´years ago

Question 14

What is the width of the salt cell? View answer

Asked 6 ´months ago

Question 15

Which side of the cell is the input? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 16

We just cleaned our cell and now we are having issues with it communicating to the system. There is a code saying Cell Connection. We have inspected the all of the cables and everything look to be in good shape. We have powered it down several times and disconnected it several times as well yet we can not get the cell to communicate with the system, W”hat could be the cause of this code? View answer

Asked 4 ´years ago

Question 17

I need replacement unions for Core-55 View answer

Asked 1 ´year ago

Question 18

Do I need to register for the warranty? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 19

low salt View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 20

Can I add a flow switch to my SJ-45 classic? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-Classic Series Salt Chlorine Generators - Owner Resources

Question 21

When my CircuPool system turns on in the morning it is coming on noisier than usual. If it cycle power it is fine. View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 22

I currently have a Jandy AquaPure PLC1400 that went bad. Can this replace that without professional? Thanks much. Duane View answer

Asked 4 ´years ago

Question 23

flow led changing red to green; 6 seconds green - 8 seconds red - then green again View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 24

The readout says HOT and the cell has been cleaned. It reads 190. It seems the thermistor is bad. How do I solve View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > Universal Series

Question 25

Why does my rj30+ read "Temp peNo" and the green power light flashes? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 26

Do you offer extensions/adapters for the rj cell to connect to the power supply box? My power wall is about 6 feet farther than the provided cables length. Can I use a standard adapter to extend this? View answer

Asked 4 ´years ago

Question 27

Cell connection View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 28

What is the warranty? I don’t see any info here. View answer

Asked 4 ´years ago

Question 29

Cell connection View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 30

how to replace a rj-60 keypad? View answer

Asked 1 ´year ago

Question 31

Is the Salt Cell covered under the same warranty as the control unit? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 32

We have a RJ 45 and a pool with just under 14,000 gal. Once Chem levels are achieved how much salt should need to be added to maintain them. It is an indoor pool. View answer

Asked 4 ´years ago

Question 33

Can this replace a Jandy Aquapure 1400 with automation (Jandy AquaLink)? View answer

Asked 6 ´years ago

Question 34

Which side is the inlet and outlet? View answer

Asked 5 ´months ago

Question 35

Will a salt level of 4700 shut down the cell? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 36

Do you have service personnel in my area 34987 View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 37

Cell not match View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > RJ PLUS Series

Question 38

Is large O ring for electrolytic cell necessary? SJ 35A arrived without it. View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-Classic Series Salt Chlorine Generators - Owner Resources

Question 39

Does this product eliminate the need for chlorine By generating it’s own salt ? View answer

Asked 4 ´years ago

Question 40

Remote View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series

Question 41

No lights View answer

Asked 1 ´year ago

Question 42

How do you convert a CircuPool RJ PLUS from 220 to 110? View answer

Asked 1 ´year ago

Question 43

can you use the core 55 with 1.5 inch pvc plumbing that exists? thanks View answer

Asked 2 ´years ago

Question 44

I need a cleaning stand. Where can I buy one? View answer

Asked 1 ´year ago

Question 45

do you have a wifi capable addapter to monitor the salt system on my mobile device? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators

Question 46

Loud noise - transformer(?) View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 47

can flow switch be after the cell in a vertical installation? View answer

Asked 1 ´year ago

Question 48

Does this generator cell plug up with calcite quicker/more readily than the CORE? We have very hard water and very high temperatures, View answer

Asked 5 ´years ago

Question 49

Why does my CircuPool SJ-20 Salt Chlorine Generator show low water temp and flow red lights even after replacing the flow sensor? View answer

Asked 1 ´year ago

Question 50

Have a RJ30+ Looking for the cap and stand as described on pg.12. What is a bypass cell? Where's the cap? View answer

Asked 1 ´year ago

Salt Chlorinators Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools