Salt Chlorinators Q&A

Question 1

Hello, I'd like to connect a CORE35 onto 1.5 inch pvc pipe. Do I need the 1.5" reducer ? Just want to double check. Thanks, Dave View answer

Asked 2 ´years ago

Question 2

"Roughly" how long is the power wire? If it's short, is it easy to wire in a new one? "Roughly" how many amps would one think the 35k unit draws? I'm deciding on hardwiring it to my pump timer or a separate GFI outlet that runs off the timer. View answer

Asked 3 ´years ago

Question 3

Can Core35 be mounted horizontally instead of vertically? Do you have dimensions for the Core35? View answer

Asked 3 ´years ago

Question 4

The only power source available is 240 volt. Can the core 35 be rewired for a 240 volt connection? View answer

Asked 3 ´years ago

Question 5

Core35 warranty 8 year limited. What is covered? View answer

Asked 3 ´years ago

Question 6

what are the connection measurements, ie., length, dia. Where does the salt supply go and how long does it last. View answer

Asked 3 ´years ago

Question 7

What is the minimum GPM flow rate required for the Core series? View answer

Asked 3 ´years ago

Question 8

can this unit be powered up 24/7, or does it need a timer/clock? View answer

Asked 4 ´years ago

Question 9

How much space is required below 2" pipe to fit cell body. Can't find drawing with distances. View answer

Asked 4 ´years ago

Question 10

I currently have an si 30 does it have to be replaced with another 30 salt cell or can I up size to a 40. My pool size is approx 15000 gallons but I’ve always tested low for chlorine for as long as I’ve had the system. Thank you. Rp 818 512 2264. View answer

Asked 3 ´years ago

Question 11

Is the orientation of the unit important? The plumbing I want to install it into is roughly horizontal but I would prefer that the head of the control unit was 90% from vertical View answer

Asked 5 ´years ago

Question 12

I have an Si-45 unit. The cell needs replacing but I have reduced the size of the pool from 35,000 gals to 22,000 gals. Is it possible to replace the original cell with an Si-30 replacement ? View answer

Asked 3 ´years ago

Question 13

is there a way to calibrate the cell? salt level in the pool shows to be around 3900 and the display shows salt too low...any help greatly appreciated..thank you... it is a si30 system with a 15000 gallon pool View answer

Asked 2 ´years ago

Question 14

Are replacement cells readiiy available and how much $ If the flow valve breaks, can it be replaced or is a new cell required. View answer

Asked 2 ´years ago

Question 15

How does direct sunlight for most of the day affect the control unit? View answer

Asked 2 ´years ago

Question 16

Installed in fall of 2020. Tuned on in spring of 2021. How do I clean it and what is best to use. ??? View answer

Asked 2 ´years ago

Question 17

How often does the electrolytic cell need to be replaced? View answer

Asked 3 ´years ago

Question 18

Does the unit stop making chlorine when the water temperature drops? My cold water light is on and it doesn't seem to be making any chlorine. If it stop, what is the temperature range for it to work? View answer

Asked 3 ´years ago

Question 19

Is the CircuPool SJ salt system a complete kit? View answer

Asked 2 ´years ago | Sanitation > Salt Chlorinators > SJ Series

Question 20

I currently own a Circu-pool Si series chlorine generator,. The current cell is a Si30 that has a maximum output to sustain a 30,000 gal pool. I have a 28,000 gal pool. The cell is in need to be replaced. Can I replace the Si 30 cell with a Si 45 cell? View answer

Asked 5 ´years ago

Question 21

when cell is needing replace do you replace the entire unit View answer

Asked 4 ´years ago

Question 22

Need to get a manual. I own this device already View answer

Asked 4 ´years ago

Question 23

How can you predict the lifespan of the cell? View answer

Asked 3 ´years ago

Question 24

which system should I use for a 24,000 gal pool? View answer

Asked 3 ´years ago

Question 25

What is the face to face dimension for the water in-out ports. Looking to directly replace inline chlorinator if possible. View answer

Asked 3 ´years ago

Question 26

Our pool has 6500 gal. and I think the CORE15 model should have the right size. 1. When do I have to change the cell for the first time? and 2. what means 8 years "limited"? Thank you, Thomas View answer

Asked 3 ´years ago

Question 27

What setting should i use for my SI plus chlorinator? it is currently on F 15 View answer

Asked 2 ´years ago

Question 28

Are these in stock? My pool is only 8800 gallons. I don’t need the next size up. View answer

Asked 3 ´years ago

Question 29

Will this unit work for my 2200 gal pebble tec spa? Any special setting requirements since my spa much less than 15000 gal capacity of the CORE15? View answer

Asked 4 ´years ago

Question 30

Hi there, I got some questions. does this unit shows a water temp? also will this unit turn off when the pump goes off without being connected to the pump timer? in other words will it sense the water flow when the pump starts and come on? Thankyou for your help. View answer

Asked 4 ´years ago

Question 31

Will any sand filter work with this system or do i need a newer sand filter? Mine is almost 25 years old. View answer

Asked 4 ´years ago

Question 32

What Cell setting should I program my box too when using the Si40 UL40 cell? View answer

Asked 2 ´years ago

Question 33

I currently have the UL40 system and was wondering if I can upgrade the cell to the UL55 without changing the control box? View answer

Asked 2 ´years ago

Question 34

What does it indicate on a Circupool SJ40, If the cell seems to turn things in the housing an orange color? Is it a cell problem or a chemical problem? View answer

Asked 2 ´years ago

Question 35

How can you check if the cell is working. Thanks View answer

Asked 3 ´years ago

Question 36

How can I tell if my cell is not working? Normally it bubbles when in use. View answer

Asked 3 ´years ago

Question 37

What is the correct cell code for the SI-60 cell View answer

Asked 3 ´years ago

Question 38

can I buy a remote for the UL40? View answer

Asked 2 ´years ago

Question 39

Will the universal 40 cell fit the t-15 directly. View answer

Asked 2 ´years ago

Question 40

The Core-55 capacity is listed at 2.3 lbs/day. Is the "day" in this calculation 24 hours of runtime will produce 2.3 lbs or is the number of hours smaller? I realize the 2.3 lbs is an approximation...just curious about the required runtime to get the output. View answer

Asked 3 ´years ago

Question 41

Will the core55 fit right in the return line where the current Hayward CL200 3" tab chlorine is feeder is? Almost looks like it will. View answer

Asked 3 ´years ago

Question 42

My chlorinator is saying there is no water flow, but the water is flowing just fine with no obstructions. The flow indicator switch moves freely. What can I do?? View answer

Asked 2 ´years ago

Question 43

Can I easily replace my jandy 1400 aquapure system with this circupool 40k unit? View answer

Asked 2 ´years ago

Question 44

CircuPool product under serious consideration. Long time pool owner. 16x34 with diving end rectangular pool so I est. about 25,000 gals. DIY installation and controller can be in or out (exposed to all sun & elements). Can you suggest a good model for me? Thanks View answer

Asked 3 ´years ago

Question 45

Can this be installed at a diagonally? View answer

Asked 3 ´years ago

Question 46

Will this control panel work with a Hayward Salt Cell? View answer

Asked 3 ´years ago

Question 47

Other than warranty, what are the differences between the Universal Series and the RJ Series? View answer

Asked 3 ´years ago

Question 48

Can this replace my intellichlor ic60 or does it require replumbing? How soon can I get it? View answer

Asked 3 ´years ago

Question 49

is it plug and play 120 volt input hook-up. is it all in one inside program box is there a transformer inside the panel? or do I need extural View answer

Asked 2 ´years ago

Question 50

I have a 5 plus year old SI45 now. I have replaced the cell and now it is blowing the fuse on the main panel. I’m not sure what the cost is to replace the main board or if I should purchase this new unit. Thoughts? View answer

Asked 2 ´years ago

Salt Chlorinators Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools