Salt Chlorinators Q&A

Question 1

Is this compatible with iAquaLink 3.0 so I can view my readings remotely? View answer

Asked 3 ´years ago

Question 2

Bought until 5 months ago and not generating. Power doesn’t seem to be getting to cell but control box lights working and has power. Any ideas? View answer

Asked 2 ´years ago

Question 3

Can this chlorinator be added before the filter after the pump ?The existing pool system is very constrained where the water returns to the pool after the filter View answer

Asked 2 ´years ago

Question 4

what are the connection measurements, ie., length, dia. Where does the salt supply go and how long does it last. View answer

Asked 3 ´years ago

Question 5

can I buy a remote for the UL40? View answer

Asked 2 ´years ago

Question 6

Where do you install the cartridge-looking device... On the intake line or the outflow (back to the pool) line? View answer

Asked 2 ´years ago

Question 7

I have a 5 plus year old SI45 now. I have replaced the cell and now it is blowing the fuse on the main panel. I’m not sure what the cost is to replace the main board or if I should purchase this new unit. Thoughts? View answer

Asked 2 ´years ago

Question 8

whats the difference between the core 35 and rj series? View answer

Asked 3 ´years ago

Question 9

Is this system Hayward compatible? View answer

Asked 2 ´years ago

Question 10

I need replacement o- rings for this chlorinator. Do you sell then. and if so, how much are they? View answer

Asked 3 ´years ago

Question 11

Does this kit come with a flow switch and is this flow switch from the Hayward compatible with this one View answer

Asked 2 ´years ago

Question 12

Core35 warranty 8 year limited. What is covered? View answer

Asked 3 ´years ago

Question 13

The only power source available is 240 volt. Can the core 35 be rewired for a 240 volt connection? View answer

Asked 3 ´years ago

Question 14

Is it really better to oversize? Looking at the Universal40 for a 20K size pool. Will the 25K be just as efficient? Does the electronic box have a timer or do I need to tie it into my pool timer? Runs 12 hours per day. Using 220v pump. Thank you. View answer

Asked 2 ´years ago

Question 15

Can Core35 be mounted horizontally instead of vertically? Do you have dimensions for the Core35? View answer

Asked 3 ´years ago

Question 16

Is there a replacement for the cell when it finally dies, or do you have to buy the entire system? I am not seeing one on the site. View answer

Asked 2 ´years ago

Question 17

when there is no electricity, will the device return to work after the power is restored? View answer

Asked 2 ´years ago

Question 18

How soon can we get this product? View answer

Asked 2 ´years ago

Question 19

We're thinking of replacing out Hayward with this system. Can we reply on the flow switch to turn the chlorinator on and off? The pump is always powered, but has an internal controller as well as variable speed. We can have reduced flow as well as no flow during parts of the day. Will this hurt your system? Thank you in advance. View answer

Asked 2 ´years ago

Question 20

Does the CircuPool Core 35 come with a sacrificial anode? View answer

Asked 2 ´years ago

Question 21

How many pounds it has? View answer

Asked 2 ´years ago

Question 22

i HAVE A 25,000 GAL POOL WILL THE CORE35 BE SUFFICIENT? View answer

Asked 2 ´years ago

Question 23

What is the wording for the limited warranty * ? View answer

Asked 2 ´years ago

Question 24

Do you have a comparison chart for different models of salt chlorine generators? What is the difference between the RJ30 and Core35? View answer

Asked 2 ´years ago

Question 25

Will this work with a 25000 gallon above ground pool? View answer

Asked 2 ´years ago

Question 26

My old salt system lasted 19 years with the original cell, the system periodically reverse its polarity to self clean the cell. Does the CORE 35 do this? And if it doesn't why not? View answer

Asked 2 ´years ago

Question 27

Will the universal 40 cell fit the t-15 directly. View answer

Asked 2 ´years ago

Question 28

what size pipe is used for the inlet and outlet and is it PVC? View answer

Asked 2 ´years ago

Question 29

Hello, I have a 6,000 gal in-ground pool in the Florida Keys. What is the best system and size for my pool. thank you. Jose View answer

Asked 2 ´years ago

Question 30

Is the warranty for 8 years even if I install it the owner and it’s large enough for 80 thousand litres pooland brand new unit and will I receive it and is in Canadian money this numbe thanks View answer

Asked 2 ´years ago

Question 31

Hello, I'd like to connect a CORE35 onto 1.5 inch pvc pipe. Do I need the 1.5" reducer ? Just want to double check. Thanks, Dave View answer

Asked 2 ´years ago

Question 32

Can I easily replace my jandy 1400 aquapure system with this circupool 40k unit? View answer

Asked 2 ´years ago

Question 33

"Roughly" how long is the power wire? If it's short, is it easy to wire in a new one? "Roughly" how many amps would one think the 35k unit draws? I'm deciding on hardwiring it to my pump timer or a separate GFI outlet that runs off the timer. View answer

Asked 3 ´years ago

Question 34

What is the current draw of the entire system if running on 110VAC? View answer

Asked 4 ´years ago

Question 35

Panel is blank View answer

Asked 3 ´years ago

Question 36

I have above ground pool 33 foot by 54 inch deep is this the best unit View answer

Asked 3 ´years ago

Question 37

Is this system compatible to replace a compuclor? View answer

Asked 3 ´years ago

Question 38

What is the correct cell code for the SI-60 cell View answer

Asked 3 ´years ago

Question 39

Can this be used as an initial conversion kit? Meaning I don't have a salt system can I install this product? Thanks View answer

Asked 3 ´years ago

Question 40

I’m thinking about changing over to a SWJ system, mainly due to issues with chlorine this year. Looking at a UL40.. 1) at 120v, how many amps does it pull? 2) does the plug in model need to be on a timer with the pump? Or is it smart enough to not work when there is no flow? 3) what are dimensions of the control box? View answer

Asked 3 ´years ago

Question 41

How can I tell if my cell is not working? Normally it bubbles when in use. View answer

Asked 3 ´years ago

Question 42

I currently own a Circu-pool Si series chlorine generator,. The current cell is a Si30 that has a maximum output to sustain a 30,000 gal pool. I have a 28,000 gal pool. The cell is in need to be replaced. Can I replace the Si 30 cell with a Si 45 cell? View answer

Asked 5 ´years ago

Question 43

Can you use the flow switch from my Hayward system or do I have to change it? Also what would be the shipping time after I order? Universal 40 View answer

Asked 3 ´years ago

Question 44

I see the flow switch is integrated into the replaceable cell. Can it be repaired without replacing the entire cell? It seems flow switches are the weakest link with Pentair. While I like this system, I'm a little apprehensive. View answer

Asked 3 ´years ago

Question 45

How can you check if the cell is working. Thanks View answer

Asked 3 ´years ago

Question 46

I currently have a Jandy saltwater system and I am looking to replace it with something that actually works. Can you tell me what product would make sense to work with my Jandy system and work for my pool size (about 35,000 gallons) Thanks View answer

Asked 3 ´years ago

Question 47

is there a way to calibrate the cell? salt level in the pool shows to be around 3900 and the display shows salt too low...any help greatly appreciated..thank you... it is a si30 system with a 15000 gallon pool View answer

Asked 2 ´years ago

Question 48

I have an Si-45 unit. The cell needs replacing but I have reduced the size of the pool from 35,000 gals to 22,000 gals. Is it possible to replace the original cell with an Si-30 replacement ? View answer

Asked 3 ´years ago

Question 49

I currently have an si 30 does it have to be replaced with another 30 salt cell or can I up size to a 40. My pool size is approx 15000 gallons but I’ve always tested low for chlorine for as long as I’ve had the system. Thank you. Rp 818 512 2264. View answer

Asked 3 ´years ago

Question 50

Do I need to install a check valve before the CORE35 to prevent superchlorinated water backflowing into my system when the pool pump is turned off? View answer

Asked 3 ´years ago

Salt Chlorinators Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools