Question 1

Will I still need to add acid to lower alkalinity or will my alkalinity stabilize with this system? View answer

Answer comment posted 6 months ago

Question 2

Will this system operate efficiently in a hot summer 100 to 122 F. My concern is the ambient air around the tanks. View answer

Asked 6 ´months ago

Question 3

What is Circupool’s phone number? View answer

Asked 6 ´months ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 4

Do you offer the full cover (blue part)? Roofers damaged mine and would like to replace it. View answer

Asked 6 ´months ago

Question 5

When my CircuPool system turns on in the morning it is coming on noisier than usual. If it cycle power it is fine. View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 6

Cell connection View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 7

What is the minimum flow rate to produce chlorine, and maximum flow rate admited View answer

Asked 7 ´months ago

Question 8

If my pool is 15,000 gallons, give me the recommended size salt chlorinator View answer

Asked 8 ´months ago | Sanitation > Salt Chlorinators > CORE Series

Question 9

Hello, what is the best way to use the RJ60+ with a pump running 24/7 ? Full power a couple of hours, 50% longer View answer

Answer posted 8 months ago

Question 10

Can I get replacement control module? View answer

Asked 8 ´months ago | Replacement Parts > Parts & Accessories > EDGE Models

Question 11

Where can i get the black and red threaded adapters that attach to pool pump for pH control system? View answer

Asked 8 ´months ago

Question 12

My low salt light is flashing but I measure salt level in the pool at 4000ppm View answer

Asked 8 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 13

The ball within the "Flow Gauge" does not go up upon turning the xxxx even though gas is flowing in. View answer

Answer updated 8 months ago | Sanitation > pH Control > CircuPool TOTALBalance Series pH Control Systems - Owner Resources

Question 14

I live in phoenix Az should I remove salt cell for winter even though it doesn’t freeze here? View answer

Asked 8 ´months ago

Question 15

I have a UNIVERSAL25 SALT CHLORINE GENERATOR and I need to clean it. What end cap or stand works for this? View answer

Asked 8 ´months ago

Question 16

By adding the Balance Cntrol Upgrade Kit ($399.00), will this system then keep the titanium plates cleaner ? View answer

Asked 8 ´months ago | BALANCE CONTROL Upgrade Kit - Add ORP/pH Monitoring and Chemical Automation

Question 17

Display not working View answer

Asked 8 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 18

I have the RJ 45 the clear housing is fine but the clear some that covers the wired is cracked can I replace that p View answer

Asked 9 ´months ago | Replacement Parts > Parts & Accessories > RJ-Classic Models

Question 19

screen saying hot View answer

Asked 9 ´months ago | Replacement Parts > Parts & Accessories > Si / Universal Models

Question 20

Need o ring for strainer basket lid View answer

Asked 9 ´months ago | Replacement Parts > Pump / Filter Models > VJ-Series Pump Parts

Question 21

Does this have a lithium battery? View answer

Asked 9 ´months ago

Question 22

Hi salt/amps error View answer

Asked 9 ´months ago | Replacement Cells > Aftermarket Replacement Cells <span>fitting Hayward® / Goldline®</span> > CircuPool GEN-Series Aftermarket Replacement Cells - Owner Resources

Question 23

Which side is the inlet and outlet? View answer

Asked 9 ´months ago | Sanitation > Salt Chlorinators > CORE Series

Question 24

i have a VS pump/electronic control . can generator be connected directly to pump without separate controller View answer

Asked 10 ´months ago

Question 25

Sediment chamber replacement View answer

Asked 10 ´months ago | Replacement Parts > Pump / Filter Models

Question 26

Can the control module be rotated so it can be read from the wet end of the pump? View answer

Asked 10 ´months ago | Pumps > SmartFlo VS Pumps > CircuPool SmartFlo Series Variable Speed Pool Pumps - Owner Resources

Question 27

How much are the replacement probes and how do you order them? View answer

Asked 10 ´months ago | BALANCE CONTROL Upgrade Kit - Add ORP/pH Monitoring and Chemical Automation

Question 28

I would like to get a set of rubber pads for my swim drone, where can I get them or order them from View answer

Asked 10 ´months ago

Question 29

How do you calibrate the salt level on my customers UL25. Brand new syst.salt is at 3500 but is reading only 2800 View answer

Asked 10 ´months ago | Support

Question 30

Does this unit work with natural gas heater? View answer

Asked 10 ´months ago

Question 31

Can a SJ-20A salt cell work with the SJ-35 control module? View answer

Asked 10 ´months ago

Question 32

Optimal salt level in ppm for this device View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 33

I currently need to replace my Jandy Ei AquaPure Salt System. My pool is 19,000 gallons, will this system work? View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool® Universal25 Salt Chlorine Generator

Question 34

What is the width of the salt cell? View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > EDGE Series

Question 35

Can I replace an RJ45+ salt cell with an RJ60+ replacement salt cell? View answer

Asked 10 ´months ago

Question 36

Does the fan run even when flow is off? View answer

Asked 10 ´months ago

Question 37

Why is cell maintenance blinking View answer

Asked 10 ´months ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 38

I need to replace a housing that is currently a 1.5 inch pvc pipe. Is this compatible? I bought one and it’s 2 in View answer

Asked 10 ´months ago

Question 39

Setting up new pool, 15000 gal can you put together a package of equipment i need View answer

Asked 10 ´months ago | Packages

Question 40

I need a bulb ( OJ-30MR) for my Indigo Ozone generator I purchased from you? You have 3, I don' know which one? View answer

Asked 10 ´months ago | Replacement Lamps

Question 41

I have an Indigo3-M. Which replacement lamp do I order as the 3-M is not a listed option. View answer

Asked 10 ´months ago

Question 42

Can I use an extension cord if an outlet is too far away for core35 salt system? View answer

Asked 11 ´months ago | Sanitation > Salt Chlorinators > CORE Series

Question 43

Temp high View answer

Asked 11 ´months ago

Question 44

Will this work with iaqua3 controller View answer

Asked 11 ´months ago | Sanitation > Salt Chlorinators > SJ Series

Question 45

Will this work with iaqua 3? View answer

Asked 11 ´months ago

Question 46

Stablizer level View answer

Asked 11 ´months ago | Support

Question 47

Does this model work with 220V? View answer

Asked 11 ´months ago | Sanitation > Salt Chlorinators > EDGE Series > CircuPool EDGE Series Salt Chlorine Generators - Owner Resources

Question 48

clean cell View answer

Asked 11 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 49

My error light is blinking. I have cleaned the unit. View answer

Asked 11 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 50

Should the ozonator be plumbed before the heater or after the heater, or does it matter? View answer

Asked 11 ´months ago

Browse by Topic

Tools