Sanitation Q&A

Question 1

Are replacement cells readiiy available and how much $ If the flow valve breaks, can it be replaced or is a new cell required. View answer

Asked 3 ´years ago

Question 2

What do I do when it says "salt cell low" View answer

Asked 4 ´years ago

Question 3

i HAVE A 25,000 GAL POOL WILL THE CORE35 BE SUFFICIENT? View answer

Asked 3 ´years ago

Question 4

How does direct sunlight for most of the day affect the control unit? View answer

Asked 4 ´years ago

Question 5

Does the unit stop making chlorine when the water temperature drops? My cold water light is on and it doesn't seem to be making any chlorine. If it stop, what is the temperature range for it to work? View answer

Asked 4 ´years ago

Question 6

Will I have to add salt to the pool at installation? If so how much salt do I add to a 20,000 gal pool at the beginning View answer

Asked 5 ´years ago

Question 7

do you need to shock treat a pool with this Unit? Should non-chlorine shock be used? How often? View answer

Asked 5 ´years ago

Question 8

which system should I use for a 24,000 gal pool? View answer

Asked 4 ´years ago

Question 9

This says it can produce up to 1.4 lbs of chlorine per day. Would this be assuming it is running at 100% output for 24 hours? Just trying to figure out my run time and output settings. Last year I was using about a 1/2 pound to 3/4 pound of chlorine per day before I installed this salt cell View answer

Asked 5 ´years ago

Question 10

Are these in stock? My pool is only 8800 gallons. I don’t need the next size up. View answer

Asked 5 ´years ago

Question 11

What Cell setting should I program my box too when using the Si40 UL40 cell? View answer

Asked 4 ´years ago

Question 12

I currently have the UL40 system and was wondering if I can upgrade the cell to the UL55 without changing the control box? View answer

Asked 4 ´years ago

Question 13

How important to place Core35 after the heater? The heater is about 8 feet from the filter but all the plumbing is underground and the wiring will be a longer distance than desired. This will cause me lots of work on new plumbing. I can easily place it between the filter (pool return) and the heater (which we rarely use in Florida). It this acceptable? View answer

Asked 4 ´years ago

Question 14

Standard overall needed space for installation? And can it be installed vertically? View answer

Asked 6 ´years ago

Question 15

I like the core55. I am currently a no salt pool and would like to switch with this system. However, my pool is 54,000 gallons. Can I install the core55 with any the core35 and meet my needs? View answer

Asked 6 ´years ago

Question 16

I need the replacement electrodes for the sj40. Do you have an eta on the availability View answer

Asked 4 ´years ago

Question 17

My pool Is 27,000 gals ... is it best to purchase core 55 salt chlorinator or would that be to big ..also will the metal components on the pool equipment suffer from the salt View answer

Asked 5 ´years ago

Question 18

How can you check if the cell is working. Thanks View answer

Asked 5 ´years ago

Question 19

What are the dimensions of the Core55 unit? I need to make sure I have enough room to install with existing setup. View answer

Asked 5 ´years ago

Question 20

Do the CORE series of salt chlorinators have a max flow rate? My current Chlorinator requires a bypass loop if the flow rate exceeds 80 gpm. View answer

Asked 5 ´years ago

Question 21

What setting should i use for my SI plus chlorinator? it is currently on F 15 View answer

Asked 4 ´years ago

Question 22

My pool is 40,000 gallons. Will this work properly? How much salt will need to be added? View answers

Asked 5 ´years ago

Question 23

Can this be installed at a diagonally? View answer

Asked 5 ´years ago

Question 24

I currently own a Circu-pool Si series chlorine generator,. The current cell is a Si30 that has a maximum output to sustain a 30,000 gal pool. I have a 28,000 gal pool. The cell is in need to be replaced. Can I replace the Si 30 cell with a Si 45 cell? View answer

Asked 7 ´years ago

Question 25

I currently have an si 30 does it have to be replaced with another 30 salt cell or can I up size to a 40. My pool size is approx 15000 gallons but I’ve always tested low for chlorine for as long as I’ve had the system. Thank you. Rp 818 512 2264. View answer

Asked 5 ´years ago

Question 26

we just recently bought this product and have questions. Is there a customer service department we can speak to? View answer

Asked 6 ´years ago

Question 27

DOES THE NO FLOW LIGHT STAY ON WHEN THE PUMP IS OFF? IF SO, HOW LONG? WILL I HAVE TO MANUALLY TURN IT OFF EVERY DAY? View answer

Asked 5 ´years ago

Question 28

Does the CORE55 control need to be protected from sunlight? View answer

Asked 5 ´years ago

Question 29

How do you winterize the unit? View answer

Asked 4 ´years ago

Question 30

When converting from a chlorine pool to this system, do I run the already chlorinated water through the system and add additional salt as needed? Thanks a lot for the assistance. View answer

Asked 4 ´years ago

Question 31

Does the power turn off to the plates when pump is off and it says no flow View answer

Asked 4 ´years ago

Question 32

how long does the edge 15 need to be run to meet the advertised chlorine rate per day? View answer

Asked 5 ´years ago

Question 33

When do you think this product will be available again? I am converting a 9 person hot tub to saltwater. Would the edge25 be too large for hot tub? View answer

Asked 3 ´years ago

Question 34

what type chlorinator with good warranty do you recommend for a freeform 10,000 gallon pool? You offer so many series. Thank you. View answer

Asked 4 ´years ago

Question 35

What is the total dimension for the flow switch and cell for the Edge 40? 11 3/4 inches View answer

Asked 6 ´years ago

Question 36

Who sells and installs the EDGE 25/40 in Orlando Florida Area? View answer

Asked 6 ´years ago

Question 37

I have a limited length of 2" pipe to install the generator. What is the length of pipe needed to be cut out for install? Does the unit come with a cut template? View answer

Asked 5 ´years ago

Question 38

What is the length of the EDG40 chlorine generator cell, please? Just end-of-threads-to-end-of-threads... View answer

Asked 4 ´years ago

Question 39

Can this system be wired into my 110V pump timer and can it come configured for that? View answer

Asked 7 ´years ago | Sanitation > pH Control

Question 40

Where do you get CO2? View answer

Asked 7 ´years ago | Sanitation > pH Control

Question 41

How does this get connected to my pool equipment? View answer

Asked 7 ´years ago

Question 42

I reversed the cleaning amounts using more acid than water. Did i destroy the unit ? View answer

Asked 5 ´years ago

Question 43

Chlorine is not being generated. New cell with about 6 months service. Will a problem with the small board not indexing causing this problem? View answer

Asked 4 ´years ago

Question 44

How do you get the wire through the hole View answer

Asked 4 ´years ago

Question 45

The Flow LED on the panel will turn green for aprox. 10 seconds and then go red for aprox. 2 min. When it will go green again for 10 seconds repeating. Could this be a faulty flow switch or something else? View answer

Asked 3 ´years ago

Question 46

I just bought one of these to replace my origional SJ-55 Housing that does not have the xxxx on adapters to connect to the return line. Is there an O-Ring that goes between the adapter and the Clear Housing to insure a complete seal? View answer

Asked 4 ´years ago

Question 47

All, I received my RJ-30 generator in the winter of 2019, installed for last season, this season I have been fighting with algae growth, and I think it is due to a defective flow sensor, is there some way I can clean it, or otherwise troubleshoot it before I have to replace the whole thing? I touched the wire on it today, and it stopped flickering with no-flow, and started generating again, so I am sure this is the issue. Please let me know, Louise View answer

Asked 5 ´years ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 48

I am looking for a unit to convert my pool to a saltwater pool. I noticed this system says that it is a "replacement" for current systems. What would I need to do to install this as a new system? View answer

Asked 4 ´years ago

Question 49

My pool is 35k gals does it hurt anything if I go with the bigger 55k unit? Thanks View answer

Asked 4 ´years ago

Question 50

is it plug and play 120 volt input hook-up. is it all in one inside program box is there a transformer inside the panel? or do I need extural View answer

Asked 4 ´years ago

Sanitation Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools