Sanitation Q&A

Question 1

I have a 11-12k gallon pool in DFW TX. Would the core 15 work for me? I only run my pump about 5 hours a day. Would this be long enough to create enough chlorine? What settings would I use? How often would I need to add salt to the pool? View answer

Asked 4 ´years ago

Question 2

Will this unit work for my 2200 gal pebble tec spa? Any special setting requirements since my spa much less than 15000 gal capacity of the CORE15? View answer

Asked 4 ´years ago

Question 3

Hi there, I got some questions. does this unit shows a water temp? also will this unit turn off when the pump goes off without being connected to the pump timer? in other words will it sense the water flow when the pump starts and come on? Thankyou for your help. View answer

Asked 4 ´years ago

Question 4

Will any sand filter work with this system or do i need a newer sand filter? Mine is almost 25 years old. View answer

Asked 5 ´years ago

Question 5

I currently have the UL40 system and was wondering if I can upgrade the cell to the UL55 without changing the control box? View answer

Asked 3 ´years ago

Question 6

I need the replacement electrodes for the sj40. Do you have an eta on the availability View answer

Asked 3 ´years ago

Question 7

What does it indicate on a Circupool SJ40, If the cell seems to turn things in the housing an orange color? Is it a cell problem or a chemical problem? View answer

Asked 3 ´years ago

Question 8

Hi there, I have a Circupool Si 45 salt cell that has gone bad. Can I replace it with a Si 60 cell instead? Is the size the same for both? I have a 36,000 gallon pool in the Dallas area. Thanks, Anton View answer

Asked 3 ´years ago

Question 9

What setting should i use for my SI plus chlorinator? it is currently on F 15 View answer

Asked 3 ´years ago

Question 10

is there a way to calibrate the cell? salt level in the pool shows to be around 3900 and the display shows salt too low...any help greatly appreciated..thank you... it is a si30 system with a 15000 gallon pool View answer

Asked 2 ´years ago

Question 11

I have an Si-45 unit. The cell needs replacing but I have reduced the size of the pool from 35,000 gals to 22,000 gals. Is it possible to replace the original cell with an Si-30 replacement ? View answer

Asked 3 ´years ago

Question 12

I currently have an si 30 does it have to be replaced with another 30 salt cell or can I up size to a 40. My pool size is approx 15000 gallons but I’ve always tested low for chlorine for as long as I’ve had the system. Thank you. Rp 818 512 2264. View answer

Asked 4 ´years ago

Question 13

What version should be on the Circupool Module for the SI 30. I believe mine is set on 9. View answer

Asked 4 ´years ago

Question 14

I have a SI series but don't know, manual doesn't say, if its a 30 or 45? I have a 18,000 gallon pool. is the -30 and -45 the same overall length? Connections to the controller the same? I don't want to replumb the system. Thanks. View answer

Asked 5 ´years ago

Question 15

I recently purchased this CO2 system including 2 tanks from you. Will the tanks that I purchased come with the regulator vales, or will I have to purchase them separately from somewhere else? View answer

Asked 3 ´years ago

Question 16

Can I use this system to lower my PH to 6.9 - 7.0? I have a staining problem and it is advised to lower the Ph to break uip the calcium covering the dirt so it can be vacuumed up View answer

Asked 2 ´years ago | Sanitation > pH Control

Question 17

What setup would I need for a 7,000g saltwater pool. View answer

Asked 3 ´years ago | Sanitation > pH Control

Question 18

What is the minimum flow rate for the TOTALBalance pH Control device? View answer

Asked 3 ´years ago | Sanitation > pH Control

Question 19

I own a CORE35 salt chlorinator system, I am interested in the TotalBalance PH CO2 system, website states there might be a coupon code for existing salt chlorinator users? View answer

Asked 3 ´years ago | Sanitation > pH Control

Question 20

3 questions, 1) is there any risk of CO2 added in the drain ports of the pump causing cavitation damage in the pump? 2) if installation complexity isn’t a problem, would you still recommend injecting at the drain ports? 3) I have 2 pumps, a “filter” pump that is the workhorse pushing water through filter, UV sanitizer, heater, wall returns, and when active floor cleaner jets. The other “water feature” pump runs at 1100 rpm 24/7 to overflow a zero edge spa. Which flow stream should I introduce CO2 to? View answer

Asked 3 ´years ago | Sanitation > pH Control

Question 21

I'm interested in the pH control system. Your website states that a discount may be available to me since I just installed a Core35 salt system. Please let me know what my price would be for the pH control. Thanks, Manny Roman View answer

Asked 3 ´years ago | Sanitation > pH Control

Question 22

I have approx 20,000 gallon pool running with with your salt system. You mentioned on a previous answer that I will still need to check for all chemicals on the pool. Do I still need to add salt and stabilizer with same frequency as before installing the CO2 system? View answer

Asked 4 ´years ago | Sanitation > pH Control

Question 23

I have a salt system and I run the pump year round but cover it in the winter months. Will this eliminate all the chemicals I have to add when I open the pool in the spring? With the exception of adding the salt of course. ai have a 20 X 30 pool so how many tanks would I need? View answer

Asked 4 ´years ago | Sanitation > pH Control

Question 24

Can the CO2 injector be placed anywhere on the pressure side of the system after the pump? What about the pressure sensor? Note: I would only have one port available on the pump for use with this system. View answer

Asked 4 ´years ago | Sanitation > pH Control

Question 25

What is the recommendation for operations of this system over the winter months in north Texas. Should the system be maintained and in operation or turned off? View answer

Asked 5 ´years ago | Sanitation > pH Control

Question 26

My pump has only 1 drain plug. Does that mean I can not use this system? Thanks, Jack E View answer

Asked 6 ´years ago | Sanitation > pH Control

Question 27

Can this system be wired into my 110V pump timer and can it come configured for that? View answer

Asked 6 ´years ago | Sanitation > pH Control

Question 28

Where do you get CO2? View answer

Asked 6 ´years ago | Sanitation > pH Control

Question 29

How does this get connected to my pool equipment? View answer

Asked 6 ´years ago

Question 30

Are ozone generators effective in a non-salt pool? My builder installed one, years ago (28 year-old pool) and it hasn’t worked for quite some time. Thinking about replacing it but not sure about how effective it is (was). View answer

Asked 3 ´years ago | Sanitation > Ozone Generators

Question 31

Does rj20 plus have a timer? View answer

Asked 4 ´years ago

Question 32

I have purchased 2 of your RJ 30 units in the past for my pool. I really like the product and need a RJ 20 for my daughter . I have noticed the prices have increased substantially since my last purchase. There are many places that sell this product, which has the best price ? Also, what is the 120 v for $18.50 do. What is its purpose when the system runs on low voltage? Are there any discounts ? Military, senior anything at all . Thank you View answer

Asked 5 ´years ago

Question 33

Did this take the place of the SGS salt system? View answer

Asked 4 ´years ago

Question 34

what is the length of it? How long of a span of tubing is needed to be cut out for install? View answer

Asked 5 ´years ago

Question 35

is there a verical hook-up kit available? View answer

Asked 6 ´years ago

Question 36

What would you recomand using your products in place of a Pentair #520555 IntelliChlor IC40 Salt Chlorine Generator Cell. View answer

Asked 2 ´years ago

Question 37

1.Is there a video showing how to install? 2.Also, I have a 30,000 gallon pool, is it better to oversized the salt chlorinate? 3. I am replacing an existing chlorinator, I am very familiar with working with PVC pipe, is this a DIY project? 4. If I install myself are all warranties still in effect. Thank you View answer

Asked 5 ´years ago

Question 38

I have a below grade equipment room. I was going to install 2- SJ55 on a 50,000 gallon pool. I want the system to coast for longer cell life. What do I need to install the two units below ground? Would it be possible to get a drawing of what you would recommend? View answer

Asked 6 ´years ago

Question 39

why does the housing leak? I replaced gasket and it leaks around the threads View answer

Asked 2 ´years ago

Question 40

How many amps does my CircuPool SJ pull? View answer

Asked 4 ´years ago

Question 41

Can the unit be mounted on its side rather than upright (the intake and output openings upward)? View answer

Asked 4 ´years ago

Question 42

The Digital Control Panel of the SJ-40 has stopped working how can I fix it? View answer

Asked 5 ´years ago

Question 43

On our second SJ40 and have never used Super CL Mode and would like to know should the light be red.?? We just had the pool redone and need to get the chlorine and salinity back up to where they need to be.......... View answer

Asked 5 ´years ago

Question 44

I have an older RJ 45 model, S/N 30477. Will the SJ 45 fit on my existing plumbing? IE, are the inlet and outlet openings the same distance apart as the RJ? Can you send dimensional specs to me? View answer

Asked 3 ´years ago

Question 45

I need to purchase a new system, is there anywhere I can look at how this is installed to see what I need to do if I replace by Frog system with this one. View answer

Asked 3 ´years ago

Question 46

Is there an adapter kit for a Compupool CPSC36 system? View answer

Asked 4 ´years ago

Question 47

I have an inground pool 13,500 gallon in southwest Florida what size SJ unit will i need ? View answer

Asked 4 ´years ago

Question 48

HI..MY SALT LEVEL PPM IS 5000. WILL YUR SYTEM STILL GENERATE CLHORILE AT THIS LEVEL? View answer

Asked 4 ´years ago

Question 49

How do I buy a replacement for the SJ 3500 Generator buy it's self?? View answer

Asked 3 ´years ago

Question 50

Just bought the sj35 and don’t see anywhere in the instructions how long the two risers have to be. How long should they be? View answer

Asked 4 ´years ago

Sanitation Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools