Sanitation Q&A

Question 1

How to turn off a solid green cell maintenance light

Asked 3 ´months ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 2

Output levels not adjusting View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 3

wiring variable speed pump View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 4

Display fails. Can I replace the display board? View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > Universal Series

Question 5

How often does the electrolytic cell need to be replaced? View answer

Asked 4 ´years ago

Question 6

3 questions, 1) is there any risk of CO2 added in the drain ports of the pump causing cavitation damage in the pump? 2) if installation complexity isn’t a problem, would you still recommend injecting at the drain ports? 3) I have 2 pumps, a “filter” pump that is the workhorse pushing water through filter, UV sanitizer, heater, wall returns, and when active floor cleaner jets. The other “water feature” pump runs at 1100 rpm 24/7 to overflow a zero edge spa. Which flow stream should I introduce CO2 to? View answer

Asked 4 ´years ago | Sanitation > pH Control

Question 7

I need 2 of theplastic blue divider spacers for the electrolytic cell View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > SJ Series > CircuPool SJ-A Series Salt Chlorine Generators - Owner Resources

Question 8

What is the minimum flow rate for the TOTALBalance pH Control device? View answer

Asked 4 ´years ago | Sanitation > pH Control

Question 9

Can this device be connected to wifi View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 10

I currently have a permasalt system. Can I just swap this out or will I need to cut any houses? View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > SJ Series

Question 11

Do you sell cell only

Asked 2 ´months ago | Sanitation > Salt Chlorinators > CORE Series

Question 12

Are ozone generators effective in a non-salt pool? My builder installed one, years ago (28 year-old pool) and it hasn’t worked for quite some time. Thinking about replacing it but not sure about how effective it is (was). View answer

Asked 4 ´years ago

Question 13

How do I actually use an ozone system on my pool? View answer

Asked 7 ´years ago

Question 14

I have a 11-12k gallon pool in DFW TX. Would the core 15 work for me? I only run my pump about 5 hours a day. Would this be long enough to create enough chlorine? What settings would I use? How often would I need to add salt to the pool? View answer

Asked 5 ´years ago

Question 15

Will this unit work for my 2200 gal pebble tec spa? Any special setting requirements since my spa much less than 15000 gal capacity of the CORE15? View answer

Asked 5 ´years ago

Question 16

I currently have the Pentair ICHLOR 30.

Asked 3 ´months ago | Sanitation > Salt Chlorinators > EDGE Series

Question 17

HI SALT and CELL MAINT lights on View answer

Asked 2 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 18

What setup would I need for a 7,000g saltwater pool. View answer

Asked 4 ´years ago | Sanitation > pH Control

Question 19

Interested in purchasing this with a variable speed pump and saltwater generator. I understand the saltwater generator can be wired to constant power and will be activated by the flow switch. How do I control the Ozone Generator operation in this setup? View answer

Asked 6 ´years ago

Question 20

Adjust model number

Asked 2 ´months ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 21

What size are the o rings for CircuPool® O-Ring Set for RJN/UL/Si View answer

Asked 4 ´months ago

Question 22

How often do you have to refill the CO2 tank? View answer

Asked 7 ´years ago

Question 23

Salt cell is reading 0 amps

Asked 2 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 24

Little add on to previous two questions that I submitted. Pool is located in south Florida (Port Charlotte, FL). Equipment is all outside. Lots of sun, rain and humidity. What would be best configuration for installing swg and O3 units together? Thanks again, Bill View answer

Asked 4 ´years ago

Question 25

My salt level reading on the RJ 45 is always higher than manually testing. Is there a way to calibrate? View answer

Asked 2 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 26

1. Is there a particular grade of CO2 that is recommended for use in this system? I have identified a couple potential suppliers and they have medical, food and industrial grades of CO2 available. 2. Are the tank connections standardized so that if I obtain the CO2 locally it will work with the supplied regulator(s)? View answer

Asked 7 ´years ago

Question 27

does Circupool recommend a specific brand of salt View answer

Asked 3 ´months ago

Question 28

Our rj 30 was purchased in 2012. It’s showing water fault and low salt but salt is ok

Asked 2 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 29

Just submitted a question regarding swg and just ran across your Ozone units. Again, 10,000 gallon pool. Light use except for 2-3 weeks when grandkids visit. Which unit would you recommend? I have a Pentair VSP that I run 4-6 hours a day. How long/volume does the 03 unit require? View answer

Asked 4 ´years ago

Question 30

I recently purchased this CO2 system including 2 tanks from you. Will the tanks that I purchased come with the regulator vales, or will I have to purchase them separately from somewhere else? View answer

Asked 4 ´years ago

Question 31

Does the Universal55 have the same threads as Hayward Goldline Aqua Rite? I.e., can I unscrew the Hayward and xxxx in the Universal? Or is it the length that is what makes them 'compatible' per the webpage description? Thanks much. View answer

Asked 4 ´years ago

Question 32

My Core chlorinating unit will not turn on. View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 33

How many hours a day will the pump need to run for the C02 injector to keep a 15,000 gallon salt pool W salt chlorinator at a PH of 7.4? View answer

Asked 4 ´years ago

Question 34

SJ series View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series

Question 35

Upgrading from 25 to 55? View answer

Asked 2 ´months ago

Question 36

Is there a regular interval at which polarity is reversed? I run my pump 4 hours per day. When not running there will be no power to the control unit. I'm worried based on my past experience with Zodiac LM that with power being cut, the polarity will be reversed every 4 hours after power up which would be a problem (of course I can run it longer if needed). View answer

Asked 4 ´years ago

Question 37

RJ PLUS Warranty Proration View answer

Asked 2 ´months ago

Question 38

Is there any reason I cannot use a Universal55 in a 35K gallon pool? Thx View answer

Asked 4 ´years ago

Question 39

Can this be integrated into the control panel on a pentair intelliflo 3 variable speed pump? View answer

Asked 4 ´months ago

Question 40

Universal55 Salt Chlorine Generator. What salt cell do I need to restore chlorine View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool® Universal55 Salt Chlorine Generator

Question 41

What version should be on the Circupool Module for the SI 30. I believe mine is set on 9. View answer

Asked 5 ´years ago

Question 42

Can the electrical cord be wired to a 3 prong male plug to use an outlet instead of hard wiring to electrical box? View answer

Asked 2 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 43

Why is my cell amperage -4.99 View answer

Asked 3 ´months ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 44

The unit is on and it says says cell connection and none of the buttons are responding and I have powered it off an View answer

Asked 2 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 45

I am looking at ordering an Rj-30 plus does this run on 110 or 220 voltage or both? View answer

Asked 5 ´years ago

Question 46

what is the difference compared to the old RJ30 View answer

Asked 4 ´years ago

Question 47

How to change the Salt cell version on the control panel? View answer

Asked 26 ´days ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 48

We will be replacing our old Zodiac LM23 chlorinator. We have a Hayward variable speed pump. I think the pool is a bit over 15000 gallons. Which system would be best for us? View answer

Asked 4 ´years ago

Question 49

Does this work for above ground pool View answer

Asked 4 ´years ago

Question 50

I have a 15 x 32 18200 gallon pool. I have small children and occasionally have pool partya with 20+ people in the pool. I also live near trees that constantly release leaves on to the pool. Thousands in a day. Would this system be able to handle these conditions? View answer

Asked 4 ´years ago

Sanitation Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools