Salt Chlorinators Q&A

Question 1

If hardwired to the pump, will the percentage of output stay the same when powered off and back on again? View answer

Asked 6 ´years ago

Question 2

Asked 9 ´months ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 3

Can I use the RJ30 on a 6000 gallon pool? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 4

How often do I need to replace the salt cell and how much does it cost? View answer

Asked 9 ´months ago

Question 5

I have a variable speed pump and I'm curious, what is the minimum water flow in GPM for the CORE series? View answer

Asked 3 ´years ago

Question 6

At what salinity levels does the RJ-60+ stop powering the salt cell? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series

Question 7

High Salt Light Blinking View answer

Asked 9 ´months ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 8

How should I store my salt chlorinator in the winter months? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 9

My CircuPool RJ-PLUS control box is noisy. How can I fix it? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 10

I have a below grade equipment room. I was going to install 2- SJ55 on a 50,000 gallon pool. I want the system to coast for longer cell life. What do I need to install the two units below ground? Would it be possible to get a drawing of what you would recommend? View answer

Asked 6 ´years ago

Question 11

The Universal UL40 unit sent from factory set to accept 220/240v. Do I need two lugs to accept 110/120V ? View answer

Asked 1 ´year ago

Question 12

Does the salt go directly into the pool on a new pool start up View answer

Asked 1 ´year ago

Question 13

The RJ45+ touch pad stopped working properly View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 14

What is the difference between the RJ vs the SJ series? View answer

Asked 6 ´years ago

Question 15

Does rj20 plus have a timer? View answer

Asked 4 ´years ago

Question 16

After installation this reads 4400 this is not right according to every other test . I View answer

Asked 1 ´year ago

Question 17

CircuPool Universal Series Salt Chlorinator O-rings View answer

Asked 1 ´year ago

Question 18

how long is the warranty View answer

Asked 1 ´year ago

Question 19

NO SALINITY READING WHEN BUTTON PUSHED ON RJ30 PLUS View answer

Asked 1 ´year ago

Question 20

What would be the preferred operating setup (to promote cell life): 12 hours at 25% output or 6 hours at 50%? View answer

Asked 1 ´year ago

Question 21

What’s the average lifespan of the cell in the RJ30? View answer

Asked 3 ´years ago

Question 22

I am trying to decide between this rj30 and your core 35 could you give me some help I have 15000gl pool changing from tables to salt View answer

Asked 3 ´years ago

Question 23

Just installed a new Circupool RJ60 no flow light is on View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 24

My plumbing uses 1 1/2-inch PVC. If I use 1 1/2 to 2-inch PVC adaptors, are there any known problems I may face? View answer

Asked 1 ´year ago

Question 25

CircuPool® SJ-40 Classic Replacement Cell Product ID: SJ40NR-RC still available? View answer

Asked 1 ´year ago

Question 26

can salt generator be installed vertical View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 27

Does the RJ30+ need to be recalibrated..if so how? View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 28

What is the recommended GPM flow for the RJ45 system, Core35, and Core55 systems? View answer

Asked 5 ´years ago

Question 29

Does it need to be connected to 120v or 240v? View answer

Asked 4 ´years ago

Question 30

To send a CircuPool Edge salt cell in for inspection, do you send the entire cell including housing or can the blades be removed and sent? View answer

Asked 1 ´year ago

Question 31

My cleaning light continues to flash it will not stop when I hold the reset button in for 10 seconds. I have cleane View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 32

How far does this need to be from the heater? View answer

Asked 1 ´year ago

Question 33

My UL40 states the actual salt level and generating output is higher than what it is when tested at a pool store. View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > Universal Series

Question 34

I HAVE AN RJ60 UNIT , 2 YRS OLD , WHEN I PRESS THE SALINITY BUTTON = NO RESPONSE , ONLY WITH MENU View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 35

How often do you have to replace the salt cells? I see no mention of longevity View answer

Asked 4 ´years ago

Question 36

the salinity indicator on my circupool universal 40 reads Hot , what does that indicate? View answer

Asked 1 ´year ago

Question 37

How much space do you need for a vertical install in length View answer

Asked 7 ´months ago

Question 38

"Cell Connection" frozen on the screen. What can I do? View answer

Asked 1 ´year ago

Question 39

My Control Module displays jumbled numbers in System Status menu. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 40

How to do cell maintenance? View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 41

Does this generator cell plug up with calcite quicker/more readily than the CORE? We have very hard water and very high temperatures, View answer

Asked 4 ´years ago

Question 42

When ever I check my settings I always get a resting mode reading. View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 43

Extremely high salt reading View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > Universal Series > CircuPool Universal Series Salt Chlorine Generators - Owner Resources

Question 44

Hello. I have an RJ-60+ which is rated at 300W, so presumably it only draws 1.36A at 220V. However, the manual also mentions the cell current ranging between 2.5 and 7.8 amps. I can also see the cell current displayed when I cycle through the menu options. For example, at 50%, it shows 5.7 amps. I'm assuming this cell current is different from the load on the circuit breaker. Can you confirm please? View answer

Asked 4 ´years ago

Question 45

No keys on controller respond and display reads "cell connection." View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 46

CircuPool Core Salt Chlorinator doesnt turn on. View answer

Asked 1 ´year ago | Sanitation > Salt Chlorinators > CORE Series > CircuPool CORE Series Salt Chlorine Generators - Owner Resources

Question 47

What is the life of this generator? View answer

Asked 5 ´years ago

Question 48

Salt level ok, generator cleaned, but chlorine levels remain extremely low View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > RJ PLUS Series > CircuPool RJ-PLUS Series Salt Chlorine Generators - Owner Resources

Question 49

I have RJ60+ and have high temp reading which is incorrect. View answer

Asked 1 ´year ago

Question 50

How can I tell if I have a core 15, 35, or 55? View answer

Asked 7 ´months ago | Sanitation > Salt Chlorinators > CORE Series

Salt Chlorinators Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools